Title: Elements of Airplane Performance
1Chapter 6
- Elements of Airplane Performance
2- Simple Mission Profile for an Airplane
- 1 Switch on Worming Taxi
Un-accelerated level flight
4
(Cruising flight)
3
Descent
Altitude
Climb
Landing
Takeoff
5
6
1
2
Simple mission profile
3Airplane Performance
Equations of Motions
Static Performance (Zero acceleration
Dynamic Performance (Finite acceleration)
Thrust required Thrust available
Maximum velocity
Takeoff
Power required Power available
Landing
Maximum velocity
Rate of climb
Gliding flight
4Time to climb
Maximum altitude
Service ceiling
Absolute ceiling
Range and endurance
Road map for Chapter 6
5- Study the airplane performance requires the
derivation of the airplane equations of motion - As we know the airplane is a rigid body has six
degrees of freedom - But in case of airplane performance we are deal
with the calculation of velocities (
e.g.Vmax,Vmin..etc),distances (e.g. range,
takeoff distance, landing distance, ceilings
etc), times (e.g. endurance, time to
climb,etc), angles (e.g.climb angleetc)
6- So, the rotation of the airplane about its axes
during flight in case of performance study is not
necessary. - Therefore, we can assume that the airplane is a
point mass concentrated at its c.g. - Also, the derivation of the airplanes equations
of motion requires the knowledge of the forces
acting on the airplane - The forces acting on an airplane are
7- 1- Lift force L
- 2- Drag force D
- 3- Thrust force T Propulsive force
- 4- Weight W Gravity force
- Thrust T and weight W will be given
- But what about L and D?
- We are in the position that we cant calculate L
and D with our limited knowledge of the airplane
aerodynamics
Components of the resultant aerodynamic force R
8- So, the relation between L and D will be given in
the form of the so called drag polar - But before write down the equation of the
airplane drag polar it is necessary to know the
airplane drag types
9Total Drag
Skin Friction Drag
Pressure Drag
Form Drag (Drag Due to Flow separation)
Induced Drag
Wave Drag
Note Profile Drag Skin Friction Drag Form
Drag
10- ?Skin friction drag
- This is the drag due to shear stress at the
surface. - ?Pressure drag
- This is the drag that is generated by the
resolved components of the forces due to pressure
acting normal to the surface at all points and
consists of form drag induced drag wave
drag . - ?Form drag
- This can be defined as the difference between
profile drag and the skin-friction drag or the
drag due to flow separation.
11- ?Profile Drag
- ? Profile drag is the sum of skin-friction
and form drags. -
- ? It is called profile drag because both
skin-friction and - form drag or drag due to flow separation
are - ramifications of the shape and size of the
body, the - profile of the body.
-
- ? It is the total drag on an aerodynamic
shape due to - viscous effects
12Skin-friction
Form drag
13- ?Induced drag ( or vortex drag )
- This is the drag generated due to the wing
tip vortices , depends on lift, does not depend
on viscous effects , and can be estimated by
assuming inviscid flow.
Finite wing flow tendencies
14Formation of wing tip vortices
15Complete wing-vortex system
16(No Transcript)
17The origin of downwash
The origin of induced drag
18- ?Wave Drag
- This is the drag associated with the formation
of shock waves in high-speed flight .
19- Total Drag of Airplane
- ? An airplane is composed of many components and
each will contribute to the total drag of its
own. - ? Possible airplane components drag include
- 1. Drag of wing, wing flaps Dw
- 2. Drag of fuselage Df
- 3. Drag of tail surfaces Dt
- 4. Drag of nacelles Dn
- 5. Drag of engines De
- 6. Drag of landing gear Dlg
- 7. Drag of wing fuel tanks and external
stores Dwt - 8. Drag of miscellaneous parts Dms
20- ? Total drag of an airplane is not simply the sum
of the drag of the components. - ? This is because when the components are
combined into a complete airplane, one component
can affect the flow field, and hence, the drag of
another. - ? these effects are called interference effects,
and the change in the sum of the component drags
is called interference drag. - ? Thus,
- (Drag)12 (Drag)1 (Drag)2
(Drag)interference -
21- Buid-up Technique of Airplae Drag D
- ? Using the build-up technique, the airplane
total drag D is expressed as - D Dw Df Dt Dn De Dlg Dwt
Dms Dinterference - ? Interference Drag
- ? An additional pressure drag caused by the
mutual interaction of the flow fields around each
component of the airplane. - ? Interference drag can be minimized by proper
fairing and filleting which induces smooth mixing
of air past the components. - ? The Figure shows an airplane with large degree
of wing filleting.
22Wing fillets
23- ? No theoretical method can predict interference
drag, thus, it is obtained from wind-tunnel or
flight-test measurements. - ? For rough drag calculations a figure of 5 to
10 can be attributed to interference drag on a
total drag, i.e, - Dinterference 5 10 of
components total drag - The Airplane Drag Polar
- ? For every airplane, there is a relation
between CD and CL that can be expressed as an
equation or plotted on a graph. - ? The equation and the graph are called the drag
polar. -
24For the complete airplane, the drag coefficient
is written as CD CDo
K CL2 This equation is the drag polar
for an airplane. Where CDo drag coefficient at
zero lift ( or parasite
drag coefficient ) K CL2 drag
coefficient due to lift ( or
induced drag coefficient CDi )
K 1/p e AR
25 e Oswald efficiency factor 0.75 0.9
(sometimes known as the airplane efficiency
factor) AR wing aspect ratio b2/S ,
b wing span and S wing
planform area
Schematic of the drag polar
26- Airplane Equations of Motion
27(No Transcript)
28(No Transcript)
29- Apply Newtons 2nd low of motion
- In the direction of the flight path
- Perpendicular to the flight path
30- Un-accelerated Level Flight Performance
- (Cruising Flight)
31- Thrust Required for Level Un-accelerated Flight
- (Drag)
- Thrust required TR for a given airplane to
fly at V8 is given as TR D
32? TR as a function of V8 can be obtained by tow
methods or approaches graphical/analytical
Graphical Approach
33- 1- Choose a value of V8
- 2 - For the chosen V8 calculate CL
- L W ½?8 V28S CL
- CL 2W/ ?8 V28S
- 3- Calculate CD from the drag polar
- CD CDo K CL2
- 4- Calculate drag, hence TR, from
- TR D ½?8 V28S CD
- 5- Repeat for different values of V8
346- Tabulate the results
V8 CL CD CL/CD W/CL/CD
35(TR)min occurs at (CL/CD)max
36- Analytical Approach
- It is required to obtain an equation for TR as a
function of V8 - TR D
Required equation
37- Parasite and induced drag
-
TR/D
CDoCDi
V8
38- Note that TR is minimum at the point of
intersection of the parasite drag Do and induced
drag Di - Thus Do Di at TRmin
- or CDo CDi
- KCL2
- Then CL(TR)min vCDo/K
- And CDo(TR)min 2CDo
39- Finally, (L/D)max (CL/CD)max
- vCDo/K /2CDo
-
- (CL/CD)max 1/v4KCDo
- Also,V8(TR)min V8 (CL/CD)max is obtained
from W L - ½?8V2(TR)minS CL(TR)min
- Thus
- V (TR)min 2(W/S)(vK/CDo)/?8½
40L/D as function of angle of attack a
L/D as function of velocity V8
41- L/D as function of V8
- Since,
- But LW
- Then
- or
42- Flight Velocity for a Given TR
- TR D
- In terms of q8 ½?8V28 we obtain
- Multiplying by q8 and rearranging, we have
- This is quadratic equation in q8
43- Solving for q8
- By replacing q8 ½?8V28 we get
-
44- Let
- Where (TR/W) is the thrust-to-weight-ratio
- (W/S) is the wing loading
- The final expression for velocity is
- This equation has two roots as shown in figure
corresponding to point 1 an 2
45?When the discriminant equals zero ,then only
one solution for V8 is obtained ?This
corresponds to point 3 in the figure, namely
at (TR)min
46- Or, (TR/W)min v4CDoK
- Then the velocity V3 V(TR)min is
- Substituting for (TR/W)min v4CDoK we have
47- Effect of Altitude on (TR)min
- We know that
- (TR/W)min v4CDoK
- This means that (TR)min is independent of
altitude as show in Figure
48Thrust Available TA
49Sonic speed
50Thrust Available TA and Maximum Velocity Vmax
51 52 53PR
54(No Transcript)
55(No Transcript)
56 57(No Transcript)