Mobile Radio Propagation - Large Scale Path Loss - PowerPoint PPT Presentation

1 / 44
About This Presentation
Title:

Mobile Radio Propagation - Large Scale Path Loss

Description:

Mobile Radio Propagation - Large Scale Path Loss Asad Ali Introduction .. Question: What are reasons why wireless signals are hard to send and receive? – PowerPoint PPT presentation

Number of Views:283
Avg rating:3.0/5.0
Slides: 45
Provided by: Asad156
Category:

less

Transcript and Presenter's Notes

Title: Mobile Radio Propagation - Large Scale Path Loss


1
Mobile Radio Propagation - Large Scale Path Loss
  • Asad Ali

2
Introduction ..
  • Question
  • What are reasons why wireless signals are hard to
    send and receive?

3
Introduction to Radio Wave Propagation
  • The mobile radio channel places fundamental
    limitations on the performance of wireless
    communication systems
  • Paths can vary from simple line-of-sight to ones
    that are severely obstructed by buildings,
    mountains, and foliage
  • Radio channels are extremely random and difficult
    to analyze
  • The speed of motion also impacts how rapidly the
    signal level fades as a mobile terminals moves
    about.

4
Problems Unique to Wireless systems
  • Interference from other service providers
  • Interference from other users (same network)
  • CCI due to frequency reuse
  • ACI due to Tx/Rx design limitations large
    users sharing finite BW
  • Shadowing
  • Obstructions to line-of-sight paths cause areas
    of weak received signal strength

5
Problems Unique to Wireless systems
  • Fading
  • When no clear line-of-sight path exists, signals
    are received that are reflections off
    obstructions and diffractions around obstructions
  • Multipath signals can be received that interfere
    with each other
  • Fixed Wireless Channel ? random unpredictable
  • must be characterized in a statistical fashion
  • field measurements often needed to characterize
    radio channel performance

6
Mechanisms that affect the radio propagation ..
  • Reflection
  • Diffraction
  • Scattering
  • In urban areas, there is no direct line-of-sight
    path between
  • the transmitter and the receiver, and where the
    presence of high- rise buildings causes severe
    diffraction loss.
  • Multiple reflections cause multi-path fading

7
Reflection, Diffraction, Scattering
  • Reflections arise when the plane waves are
    incident upon a surface with dimensions that are
    very large compared to the wavelength
  • Diffraction occurs according to Huygens's
    principle when there is an obstruction between
    the transmitter and receiver antennas, and
    secondary waves are generated behind the
    obstructing body
  • Scattering occurs when the plane waves are
    incident upon an object whose dimensions are on
    the order of a wavelength or less, and causes the
    energy to be redirected in many directions.

8
Mobile Radio Propagation Environment
  • The relative importance of these three
    propagation mechanisms depends on the particular
    propagation scenario.
  • As a result of the above three mechanisms, macro
    cellular radio propagation can be roughly
    characterized by three nearly independent
    phenomenon
  • Path loss variation with distance (Large Scale
    Propagation )
  • Slow log-normal shadowing (Medium Scale
    Propagation )
  • Fast multipath fading. (Small Scale Propagation )
  • Each of these phenomenon is caused by a different
    underlying physical principle and each must be
    accounted for when designing and evaluating the
    performance of a cellular system.

9
Transmission path between Tx and Rx
  • Line of Sight (LOS)
  • Non Line of Sight (NLOS)

10
Radio Propagation Mechanisms
  • The physical mechanisms that govern radio
    propagation are complex and diverse
  • Generally attributed to the following four
    factors
  • Direct Mode
  • Reflection
  • Diffraction
  • Scattering.
  • They have an impact on the wave propagation in a
    mobile communication system
  • The most important parameter, Received power is
    predicted by Large Scale Propagation models based
    on the physics of reflection, diffraction and
    scattering

11
Radio Propagation Mechanisms
  • Illustration ..

12
Line of Sight (LOS)
  • Line-of-sight is the direct propagation of radio
    waves between antennas that are visible to each
    other.
  • This is probably the most common of the radio
    propagation modes at VHF and higher frequencies.
  • Radio signals can travel through many
    non-metallic objects, radio can be picked up
    through walls. This is still line-of-sight
    propagation.
  • Examples would include propagation between a
    satellite and a ground antenna or reception of
    television signals from a local TV transmitter.

13
Mobile Radio Propagation with respect to LOS
  • The received signal is directly received at the
    receiver the effects such as reflection,
    diffraction and scattering doesnt affect the
    signal reception that much.

14
Free Space Propagation Model
  • Free space propagation model is used to predict
  • Received Signal Strength when the transmitter and
    receiver have a clear, unobstructed LoS between
    them.
  • The free space propagation model assumes a
    transmit antenna and a receive antenna to be
    located in an otherwise empty environment.
    Neither absorbing obstacles nor reflecting
    surfaces are considered. In particular, the
    influence of the earth surface is assumed to be
    entirely absent.
  • Satellite communication systems and microwave
    line-of-sight radio links typically undergo free
    space propagation.

15
Free Space Propagation Model
  • Path Loss
  • Signal attenuation as a positive quantity
    measured in dB and defined as the difference (in
    dB) between the effective transmitter power and
    received power.
  • Friis is an application of the standard Free
    Space Propagation Model
  • It gives the Median Path Loss in dB ( exclusive
    of Antenna Gains and other losses )

16
Friis Transmission Equation (Far field)
  • clear, unobstructed line-of-sight path ?
    satellite and fixed microwave
  • Friis transmission formula ? Rx power (Pr) vs.
    T-R separation (d)

17
Friis Free Space Equation
  • Pt Transmitted power,
  • Pr(d) Received power
  • Gt Transmitter antenna gain,
  • Gr Receiver antenna gain,
  • d T-R separation distance
  • L System loss factor not related to propagation

18
Friis Free Space Equation
  • ? wavelength c / f (m)
  • So, as frequency increases, what happens to the
    propagation characteristics?
  • L system losses (antennas, transmission lines
    between equipment and antennas, atmosphere, etc.)
  • L 1 for zero loss
  • d T-R separation distance (m)
  • Signal fades in proportion to d2

19
Friis Free Space Equation
  • The ideal conditions assumed for this model are
    almost never achieved in ordinary terrestrial
    communications, due to obstructions, reflections
    from buildings, and most importantly reflections
    from the ground.
  • The Friis free space model is only a valid
    predictor for Pr for values of d which are
    in the far-field of the Transmitting antenna

20
Free Space Propagation Model
  • Thus in practice, power can be measured at d0 and
    predicted at d using the relation

21
Example 1
  • Find the far-field distance for an antenna with
    maximum dimension of 1 m and operating frequency
    of 900 MHz.

22
Example 2
  • If a transmitter produces 50 watts of power,
    express the transmit power in units of (a) dBm,
    and (b) dBW. If 50 watts is applied to a unity
    gain antenna with a 900 MHz carrier frequency,
    find the received power in dBm at a free space
    distance of 100 m from the antenna, What is Pr
    (10 km)? Assume unity gain for the receiver
    antenna.

23
Solution example 2
24
Non Line of Sight (NLOS)
  • There are three basic propagation mechanisms in
    addition to line-of-sight paths
  • Reflection - Waves bouncing off of objects of
    large dimensions
  • Diffraction - Waves bending around sharp edges of
    objects
  • Scattering - Waves traveling through a medium
    with small objects in it (foliage, street signs,
    lamp posts, etc.) or reflecting off rough surfaces

25
NLOS
26
Reflections
  • Reflection occurs when RF energy is incident upon
    a boundary between two materials (e.g.
    air/ground) with different electrical
    characteristics
  • Example reflections from earth and buildings
  • These reflections may interfere with the original
    signal constructively or destructively

27
Reflections
  • Upon reflection or transmission, a ray attenuates
    by factors that depend on the frequency, the
    angle of incidence, and the nature of the medium
    (its material properties, thickness homogeneity,
    etc.)
  • The amount of reflection depends on the
    reflecting material.
  • Smooth metal surfaces of good electrical
    conductivity are efficient reflectors of radio
    waves.
  • The surface of the Earth itself is a fairly good
    reflector...

28
Ground Reflection (2-Ray) Model
  • In a mobile radio channel, a single direct path
    between the base station and mobile is rarely the
    only physical path for propagation
  • Hence the free space propagation model in most
    cases is inaccurate when used alone
  • Hence we use the 2 Ray GRM
  • It considers both- direct path and ground
    reflected propagation path between transmitter
    and receiver

29
Ground Reflection (2-Ray) Model
  • This was found reasonably accurate for predicting
    large scale signal strength over distances of
    several kilometers for mobile radio systems using
    tall towers ( heights above 50 m )

30
Ground Reflection (2-Ray) Model
  • Good for systems that use tall towers (over 50 m
    tall)
  • Good for line-of-sight microcell systems in urban
    environments
  • ETOT is the electric field that results from a
    combination of a direct line-of-sight path and a
    ground reflected path

31
Ground Reflection (2-Ray) Model
  • The maximum T-R separation distance ( In most
    mobile communication systems ) is only a few
    tens of kilometers, and the earth may be assumed
    to be flat.
  • ETOT The total received E-field,
  • ELOSThe direct line-of-sight component
  • Eg The ground reflected component,

32
Example 3
  • A mobile is located 5 km away from a base station
    and uses a vertical ?/4 monopole antenna with a
    gain of 2.55 dB to receive cellular radio
    signals. The E-field at 1 km from the transmitter
    is measured to be 10 Exp-3V/mn. The carrier
    frequency used for this system is 900 MHz
  • (a) Find the length and the gain of the receiving
    antenna
  • (b) Find the received power at the mobile using
    the 2-ray ground reflection model assuming the
    height of the transmitting antenna is 50 m and
    the receiving antenna is 1.5 m above ground.

33
Solution 3
34
Diffraction
  • Occurs when the radio path between sender and
    receiver is obstructed by an impenetrable body
    and by a surface with sharp irregularities
    (edges)
  • The received field strength decreases rapidly as
    a receiver moves deeper into the obstructed
    (shadowed) region, the diffraction field still
    exists and often has sufficient strength to
    produce a useful signal.
  • Diffraction explains how radio signals can travel
    urban and rural environments without a
    line-of-sight path

35
Illustration of Diffraction
36
Diffraction
  • The phenomenon of diffraction can be explained by
    Huygen's principle, which states that all points
    on a wave front can be considered as point
    sources for the production of secondary wavelets,
    and that these 'wavelets combine to produce a new
    wave front in the direction of propagation
  • The field strength of a diffracted wave in the
    shadowed region is the vector sum of the electric
    field components of all the secondary wavelets in
    the space around the obstacle.

37
Illustration of diffraction II
38
Next time ..
  • Scattering ..

39
Scattering
  • The medium which the wave travels consists of
    objects with dimensions smaller than the
    wavelength and where the number of obstacles per
    unit volume is large rough surfaces, small
    objects, foliage, street signs, lamp posts.

40
Illustration ..
41
Scattering
  • Generally difficult to model because the
    environmental conditions that cause it are
    complex
  • Modeling position of every street sign is not
    feasible.

42
We also have looked at ..
  • Propagation in free space always like light
    (straight line)
  • Received power proportional to 1/d² (d
    distance between sender and receiver)
  • Receiving power additionally influenced by
  • shadowing
  • reflection at large obstacles
  • refraction depending on the density of a medium
  • scattering at small obstacles
  • diffraction at edges

43
Conclusion
  • As a mobile moves through a coverage area,
    different propagation mechanisms have an impact
    on the instantaneous received signal strength.
  • When a mobile has a clear LoS path to the
    base-station
  • Diffraction and scattering will not dominate the
    propagation.
  • When a mobile is at a street level without LOS
  • Diffraction and scattering will dominate the
    propagation.

44
Conclusion Urban Cellular Systems
  • No direct LoS path between Transmitter and
    Receiver
  • Presence of high-rise buildings causing severe
    diffraction loss.
  • Due to multiple reflections from various objects,
    the electromagnetic waves travel along different
    paths of varying lengths.
  • The interaction between these waves causes
    multipath fading at a specific location,
  • Strengths of the waves decrease as the distance
    between the transmitter and receiver increases.
Write a Comment
User Comments (0)
About PowerShow.com