Title: Cabling a Safer Britain
1Cabling a Safer Britain
2Mission Statement
- The ACI initiative involves the cable systems
supply chain end to end - from manufacturer
through installer to end-user - to ensure that
cable systems and products purchased and
installed throughout the UK are safe,
fit-for-purpose and fully compliant with the
requisite specifications, standards and approvals.
3- The distribution of non-approved, counterfeit
and unsafe products throughout the UK is
creating major risks for the Industry and
the UK community. - These products directly undermine UK European
Approval Standards. - It is estimated that 20 of cable products in
the supply chain are non-approved, unsafe or
counterfeit. - The problem is becoming an increasing issue
with major incentives for unscrupulous
manufacturers and distributors to offer such
products.
4Fake Fire Resistant Cables
Cable markings 2x1.5mm² sq. FIRE FLEX 300/500
VOLT BS6360 BS6387 CAT B IEC 331 BRITISH MADE
CABLE
- Key points
- Not fire resistant PVC insulation PVC sheath
fails within 2 mins - Not compliant with any standards marked on sheath
- Copper coated steel conductors low conductivity
not compliant - Steel circuit protective conductor low
conductivity not compliant - Probably not British made
5Fake Fire Resistant Cables
Cable markings 2x1.5mm² SQ FIRE FLEX FIRE
RESISTANT CABLE LPCB 682a/01 BS5839-12002 26.2d
BS 6360/BS6387 CWZ BS EN 50200 PH30 300/500V
BRITISH MADE CABLE
- Key points
- Not fire resistant PVC insulation
polyethylene sheath - Not compliant with any standards marked on sheath
- Copper coated aluminium conductors low
conductivity not to spec - Undersize circuit protective conductor also Cu
coated Al - Not LPCB approved uses another manufacturers
approval number - Probably not British made
6Fake Approval Mark
Cable markings ltHARgt 1 x 10 sqmm² BS 6004
- Key points
- Counterfeit ltHARgt registered trade mark
- HAR Approval Body is not identified
- Undersized conductor only suitable for use as a
6 sqmm cable - Incorrect marking Harmonised Code Designation
is missing - No manufacturers name or trademark
- Similar problem cable marked 16 sqmm seen
7Non-compliant PVC Arctic grade Flex
Cable markings ltHARgt 3183AG 1.5 SQMM BS6500
- Key points
- Undersize conductor low conductivity - about
1mm² instead of 1.5mm² - Cable sheath falls apart in low temperature bend
test - Not compliant with standard marked on sheath
8Non-compliant PVC Arctic grade Flex
9Non-compliant Armoured cables
Cable Markings KAYDOUR ELECTRIC Grade 1100V as
per BS5467 35 Sqmm
- Key points
- Insufficient steel wire armour conductivity
wire diameter too small - Armour wires not sufficiently galvanised
corrosion evident - Insufficient copper conductor conductivity more
like a 25 mm² - Not complaint with standard marked on sheath
10Other examples
- Reels marked 100 on the label with no unit of
measure (although the invoice states 100m)
actually measured as 100 yards (92m) - BASEC label on reels although product not BASEC
approved - Reels marked 100m yet measure at 94m
- Printing of deliberately incorrect, false or
misleading information on cables / labels / reels - Cables with no markings on them whatsoever
11- Risks Statistics
- Parliamentary questions elicited the information
that more than a quarter of the electrical fires
in England are due to problems with wires, cables
and leads to appliances. - Government ministers revealed that there were
4093 fires across England in 2007 that were
attributable to faulty wires and cables in homes
and businesses. This is 27 of all electrical
fires - and this rate has increased over the
previous five years. - These statistics also show that there were 15
fatalities and 1200 non-fatal injuries due to
faulty wires and cables over the past 5 years. - Tabled by C Huhne MP for Eastleigh
- Statistics from Department of Communities and
Local Government
12ACI
- EASTLEIGH MP WARNS ON FIRE DEATHS FROM FAULTY
CABLES - Eastleigh MP Chris Huhne has warned that many
lives could be lost in fires caused by
sub-standard imports of electrical cable. - This shoddy cable is a threat to British lives
and local jobs and we must fight it vigorously
said Mr Huhne. Buying cheap sub-standard cable
is a clear fire risk and could expose builders
and wholesalers to actions for negligence or
worse. - Mr Huhne has tabled parliamentary questions on
behalf of Prysmian, a major local employer in
Bishopstoke that produces EU-tested quality
cable. More than a quarter of the electrical
fires in England are due to problems with wires,
cable and leads to appliances. - In answer to Mr Huhne, government ministers
revealed that there were 4,093 fires across
England in 2007 that were attributable to faulty
wires and cables in homes and businesses. This is
27 per cent of all electrical fires. - This is a terrible danger and a wholly avoidable
problem if people take care to rewire with cable
that is made to EU standards rather than buy
cheap but dangerous cable from unscrupulous
suppliers said Mr Huhne.
13The problem
- Through the supply chain many organisations have
purchased, stocked or installed some of these
products - The vast majority of these are not even aware of
the seriousness of the problem - AND they cannot really tell by looking at a cable
that something is not as it should be
14- Liabilities Responsibilities
Health Safety at Work Act
Electricity at Work Regulations
- Unlimited Fine
- 2 Years Imprisonment
15- Liabilities Responsibilities
Consumer Protection Action
For Corporate Manslaughter Police and HSE will
prosecute
Unlimited fine levied on Company Up to 10
annual turnover
Life imprisonment for any Senior Manager
involved in sale of the unsafe products
16ACI Co-ordination
- The Approved Cables Initiative is the BCA
Co-ordinated Group - - working with the Supply Chain Representative
Bodies including -
- To address the issue of unsafe, unapproved and
counterfeit cable entering the UK supply chain.
17Communicate
Educate
Investigate
Eradicate
Legislate
18 19- Listing of Approved Suppliers / Products
- Listing of manufacturers / distributors of
non-approved cable
Seminars and Presentations
Wholesaler/Contractor Meetings Workshops
ECA NICEIC Regional Forums
Link to related programmes
- Educate wholesalers and contractors at point of
sale to identify Approved versus non-approved
cable.
20Investigate
- Obtain samples of unsafe/unapproved cable and
test them - Involve all the supply chain in this policing of
non-approved cable products, not just
manufacturers - Ensure fast response on testing cycle and feedback
21Eradicate
- Once proven then communicate and take action as
appropriate - Involve police, HSE, Trading Standards
- Communications to include
- Manufacturer of non-approved cable
- Distributor(s) of non-approved cable
- Head Office of wholesaler(s) whose branches sell
non-approved cable - NICEIC, ECA, EDA, ENA (risk alert message to all
members to check / be alert for this product /
manufacturer / wholesale branch / distributor)
22- Legislate
- Co-ordinated campaign to increase regulation and
standards for supply of cable products into the
UK market - Implement lobbying campaign through Government,
Regulatory Bodies, Industry Associations to
highlight the issues and generate demand for
change and improved standards
23 24Major customers
Industry supply chain associations
Edmundson
ECA
Rexel
EDA
ANEW
NICEIC
Fegime
ESC
ENA
- conference
- Workshops
- Executive forums National
- Executive Forums
- Regional Conferences
- In-house Publications
- Local
Alliance Partners
Strategic Suppliers
25 2) Tools
- BASEC Logos Distinct, separate marks for
approved products - and
for quality management systems - Cable Marking Wallet card checklist of
required cable markings - Wallet Card Listing of Approved Products
Approved Suppliers - Go/No-go Gauge Simple gauge to help check
cable wire sizes - Cable Resistance Simple resistance tester
for Wholesaler Branches - and
Contractors / Installers
26 3) Samples Testing
- Increase collection rate of suspect cables
- Increase testing facilities available
- Reduce testing and reporting feedback timetable
cycle to 2 weeks maximum
27 4) Policing Framework
- Prepare process and procedures for
implementation - HSE
- Trading Standards
- BASEC
- Police
- Deliverables
NAME
SHAME
PENALTIES
28 5) Legislate
- Plan lobbying programme
- Co-ordinated campaign with Government Regulator
Bodies. - High level Programme to secure new legislation
29 6) Funding
- Funding budget of 400k is required to finance
this campaign over the next 3 years. - Support by all parties is critical to ensure
a successful outcome.
30Summary
- The ACI is the most important campaign that the
BCA has tackled in past 10 years. - This issue must be tackled head-on and eradicated
in the long term. - The ACI touches and involves everyone in the
cable systems supply chain - It is the responsibility of everyone in the
supply chain to get involved. - The ACI will only be successful if the supply
chain demonstrably co-ordinates to address this
issue and the campaigns.
31- If you are going to buy a parachute.
- Would you buy the cheapest one?
32ACI Progress Current Status
- Support secured of EDA, ECA, ESC, NICEIC, ENA
- Support secured of all major customers
- Paper and presentation at ECA conference May
2009 - Commitment and support of local MPs
- Meeting with HSE and agreed posting of ACI
messages - Liaison with BBC regarding fake electrical
products programmes - Liaison with ESC counterfeit programme
- Liaison with BEAMAs Electrical Bulldog
initiative - Briefed EU Cable Trade Association who will copy
our programme - Legal opinions on naming and shaming
- BASEC Drafts for 2 distinct logos, quality
system and product - Planning of PR campaign BASEC and BCA
- ACI Summary presentation complete
- ACI Website planning
- First article in preparation
- 6 months action programme prepared