PHONOCARDIOGRAPHY - PowerPoint PPT Presentation

About This Presentation
Title:

PHONOCARDIOGRAPHY

Description:

Title: PowerPoint Presentation Last modified by: computer24 Created Date: 1/1/1601 12:00:00 AM Document presentation format: On-screen Show (4:3) Other titles – PowerPoint PPT presentation

Number of Views:140
Avg rating:3.0/5.0
Slides: 41
Provided by: iam53
Category:

less

Transcript and Presenter's Notes

Title: PHONOCARDIOGRAPHY


1
PHONOCARDIOGRAPHY
Saumya Mohan Kumar T.E. Biomed-Roll No.55
7/13/2016
1
2
Index
  • Pioneers in auscultation
  • Development of Stethoscope
  • Development of Phonocardiograph
  • Heart sounds
  • Heart Murmurs
  • Basic Block Diagram and Instrumentation
  • Acquisition of phonocardiographic signals
  • Writing methods for phonocardiography
  • Pros and Cons
  • Scope
  • Echocardiography vs. Phonocardiography
  • Case Study

7/13/2016
2
3
Pioneers
  • Hippocrates laid the foundation for auscultation
  • Robert Hook realized diagnostic use of cardiac
    auscultation
  • Biggest breakthrough in auscultation
  • Rene Laennec invented stethoscope
  • Dr. Jean Bennett Maguire devised a method of
    real-time spectral phonocardiography for the
    detection and classification of heart murmurs.

4
Way to heart is through ears.
Development of Stethoscopes
Early monaural stethoscope
Modern binaural stethoscope
Modern electronic stethoscope
5
Working
  • Acoustic stethoscopes transmit sound mechanically
    from a chest-piece via air filled hollow tubes to
    the listener's ears.
  • The diaphragm and the bell work as two filters,
    transmitting higher frequency sounds and lower
    frequency sounds,
  • respectively.
  • Electronic stethoscopes function in a similar
    way, but the sound is converted to an electronic
    signal which is transmitted to the listener by
    wire.
  • Functionalities often included in electronic
    stethoscopes are amplification of the signal,
    filters imitating the function of the diaphragm
    and the bell and in some cases recording
    abilities to allow storage of data.

6
Advantages
  • Allow volume control of heart and lung sounds
    heard more easily without amplifying other
    sounds.
  • Even subtle changes in breath sounds can be
    picked up and magnified
  • Aid health-care professionals in hearing heart
    murmurs
  • Electronic stethoscopes also allow the user to
    distinguish between body sounds of high and low
    frequency.
  • They now have wireless capabilities, which allow
    data to be transferred to a computer or handheld
    device for storage and retrieval at a later time.

7
Disadvantages
  • Patients undergoing surgery have the sterile
    field invaded thereby risking infection
  • Patients are frequently awakened and disturbed
  • Serious developmental abnormalities in newborn
    infants who are frequently disturbed
  • In the absence of airtight seal between
    stethoscope and skin, which determines the
    quality of sound wave transmission, background
    noise is detected and physiologic sound
    transmission is impaired.
  • They are not capable of generating constructive
    interference of physiologic sound waves.

8
Phonocardiograph- an intelligent Stethoscope
  • Bioacoustic research
  • Establish a relationship between mechanical
    event- conduction of heart- within the body and
    the sounds these events give rise to.
  • The medical use of this knowledge is to link
    sounds that diverge from normality to certain
    pathological conditions.

9
  • Phonocardiograph Instrument used for recording
    sounds connected with the pumping action of heart

10
  • Phonocardiogram
  • A high fedility recording
  • representing the rhythmicity and
  • heart rate

7/13/2016
10
11
  • Phonocardiography the process of graphical
    recording of heart sounds or murmurs

12
Heart Sounds
  • Mechanical working processes of the heart
    produce sound which indicate health status of the
    individual.
  • The relationship between blood volumes, pressures
    and flows within the heart determines the
    opening and closing of the heart valves.
  • Normal heart sounds- lub and dub- occur during
    the closure of the valves.
  • The valvular theory states that heart sounds
    emanate from a point sources located near the
    valves.
  • In the cardiohemic theory the heart and the blood
    represent an interdependent system that vibrates
    as a whole and propagates sound as waves of
    alternate pressure.

7/13/2016
12
13
(No Transcript)
14
(No Transcript)
15
(No Transcript)
16
  • The second sound (S2) signals the end of systole
    and the beginning of diastole
  • It is heard at the time of the closing of the
    aortic and pulmonary valves
  • S2 is probably the result of oscillations in the
    cardiohemic system caused by deceleration and
    reversal of flow into the aorta and the pulmonary
    artery

17
  • A third heart sound (S3)
  • connected with the diastolic filling period. The
    rapid filling phase starts with the opening of
    the semilunar valves.
  • attributes energy released with the sudden
    deceleration of blood that enters the ventricle
    throughout this period
  • A fourth heart sound (S4)
  • connected with the late diastolic filling period
  • occur during atrial systole where blood is forced
    into the ventricles.

18
Basic Heart Sounds in a Phonocardiogram Recording
19
Heart murmurs
  • Murmurs are extra heart sounds that are produced
    as a result of turbulent blood flow which is
    sufficient to produce audible noise.
  • Innocent murmurs are present in normal hearts
    without any heart disease.
  • Pathologic Murmurs are as a result of various
    problems, such as narrowing or leaking of valves,
    or the presence of abnormal passages through
    which blood flows in or near the heart.
  • Heart murmurs occur when the blood flow is
    accelerated above the Reynolds number, which
    induces non-stationary random vibrations, that
    are transmitted through the cardiac and thoracic
    tissues up to the surface of the thorax
  • They are graded by intensity from I to VI.
  • Grade I is very faint and heard only with special
    effort
  • Grade VI is extremely loud and accompanied by a
    palpable thrill

20
Factors involved in production of murmurs
21
Heart Cycle
Name
Events
20
15
Pressure (kPa)
10
5
0
PCG
ECG
Time 0 (sec)
0.4
0.8
0.3
0.5
0.6
0.7
0.1
0.2
22
Basic Block Diagram
7/13/2016
22
23
Instrumentation
  • Piezoelectric sensor to convert sound or
    vibrations to electricity
  • Crystal or moving coil microphone having
    frequency response between 5Hz and 1000Hz
  • Similar response characteristics
  • Offer selective high pass filter to allow
    frequency cutoff
  • Bandwidth 20- 2000Hz
  • Amplify signal
  • Permit selection of suitable frequency bands
  • Avoid aliasing
  • Separate louder low frequency signals from
    lower intensity, much informative high frequency
    murmurs.
  • Basic transducer ?
  • Amplifier ?
  • Filter ?

7/13/2016
23
24
  • Recording envelope of higher frequency over 80Hz
    along with actual signals below 80Hz.
  • Increase the power of incoming signal
  • Efficiency is more
  • Effect of noise is lowered
  • Signal is converted to digital form and stored
    permanently
  • For faithful recording of heart sounds
  • Integrator ?
  • Power Amplifier ?
  • DAC and Readout or high frequency chart recorder
    or ? oscilloscope or headphones

25
Sensors
  • Sensors used when recording sound
  • ? Microphones
  • ? Accelerometers
  • These sensors have a high-frequency response that
    is quite adequate for body sounds.
  • The microphone is an air coupled sensor that
    measure pressure waves induced by chest-wall
    movements
  • The accelerometers are contact sensors which
    directly measures chest-wall movements
  • For recording of body sounds,
  • ? condenser microphones
  • ? piezoelectric accelerometers
  • have been recommended.

26
Acquisition of Phonocardiographic Signals
  • Microphones picks up
  • (i). Heart sounds
  • (ii). Heart murmurs
  • (iii). Extraneous noise in the immediate
    vicinity of the patient
  • Group 1-
  • (i) . Contact microphone
  • (ii). Air coupled microphone
  • Group 2-
  • (i) Crystal microphone
  • (ii) Dynamic microphone

27
Group 1 Microphones
  • Contact Microphone
  • also known as a pickup or a piezo microphone
  • made of a thin piezoelectric ceramic round disc
    (ve) glued to a thin brass or alloy metal disc
    (-ve)
  • designed to transmit audio vibrations through
    solid objects.
  • contact mics act as transducers which pick up
    vibrations and convert them into a voltage which
    can then be made audible.

28
Group 1 Microphones
  • Air coupled Microphones
  • shows a low-pass frequency response because of
    its air-chamber compliance.
  • In the pass band, it is considered that the
    microphone has a flat response, where the
    mechanical impedance of air chamber is much
    higher than that of chest wall, the vibration of
    the measured chest-wall surface is stopped by
    both the air chamber and the coupler surface in
    contact with the chest wall.
  • The sound pressure, or normal stress exerted on
    the chamber should be constant to keep a flat
    response.

29
Group 2 Microphones
  • Crystal Microphones
  • uses the piezoelectric effect of Rochelle salt,
    quartz, or other crystalline materials.
  • This means that when mechanical stress, due to
    heart sounds, is placed upon the material, a
    voltage electromagnetic force is generated.
  • Since Rochelle salt has the largest voltage
    output for a given mechanical stress, it is the
    most commonly used crystal in microphones.
  • smaller in size, more sensitive than dynamic ones

30
a diaphragm that is mechanically linked to the
crystal so that the sound waves are indirectly
coupled to the crystal.
a crystal is mounted so that the sound waves
strike it directly
31
Group 2 Microphones
  • Dynamic Microphones
  • consists of a moving coil with fixed magnetic
    core inside.
  • This moving coil moves with heart sounds, and
    produces voltage because of its interaction with
    magnetic flux

32
Technical design of Microphone
  • It does not transform acoustic oscillations into
    electrical potentials uniformly for all
    frequencies.
  • Hence heart sound recording done with microphone
    is valid for a particular type of frequency
    only..
  • Hence microphones of various types cannot be
    interchanged.

33
Writing methods for phonocardiography
  • Requires a writing system capable of responding
    to 2000 Hz.
  • Types of writing methods
  • (i). Mechanical Recorders
  • (ii). Optical Galvanometric Recorders
  • (iii). Envelope detection
  • (iv). Direct recording using Ink Jet
    Recorders
  • (v). Electrostatic Recorder
  • (vi). Thermal Recorder

34
Ink Jet Recorders
  • Merits
  • very little loss of diagnostically important
    information
  • eliminates the effort and delay of photographic
    processing
  • immediacy of the results affords a means for
    continuously monitoring the records for quality
    and special content at the time of registration.
  • Demerits
  • writing recorders with an upper frequency
    response of 150 Hz cannot be used to write
    frequencies that lie beyond their working range.
  • can only record heart sound intensity picked up
    every 10 msec.

35
Envelope Detection
  • Uses artificial frequency of about 100 Hz in
    heart sound amplifier
  • Employed to oscillate stylus so that high
    frequency sounds are modulated by 100Hz

36
  • Pros
  • Can provide real-time traces of heart beats,
    movement and breathing. Taken together this can
    provide a unique view of cardiac condition.
  • Passive, therefore inherently safe and can be
    used for long periods.
  • Inherently cheap, (low data rates), and ideal for
    screening of large populations and home
    monitoring.
  • simple, low cost, houses the necessary
    opto-electronic elements. and non-invasive
    PC-based system that is capable to process real
    time fetal phonocardiographic signal
  • Cons
  • Existing microphones are bulky and obtrusive
  • Signal to noise ratio influenced motion artifacts
  • Inherently 1 dimensional
  • Extended instruments are intended for a pass
    band from 0.2 to100 Hz with nonlinear
    distortions to 10.
  • Recording of frequency components above this
    limit is related with an appreciable drop in
    amplitude of recording and an increase in
    distortions.
  • The use of contacting transducers to sense the
    vibrations is inappropriate.

37
Scope
  • Further Work
  • 1. Design of clinical prototype
  • 2. Improvements to signal conditioning and
    control electronics
  • 3. Investigate wireless links for cordless
    monitoring
  • 4. Remote measurement of small displacements at
    compliant surfaces
  • Suggested Applications
  • Remote sensing of sub 50 micron displacements
  • Adult and fetal phonocardiography and phonography
  • Remote measurements of compliant materials in
    wind-tunnels
  • Infrasound intensity measurement
  • Biomedical instrumentation
  • Low-cost and low power confocal microscopy
  • Cell culture measurement

38
The two not alternative, and the less
contradictory, but mutually supplementing
methods.
  • Echocardiography
  • better diagnosis of mitral valve defects
    ,evaluating the degree of its stenosis and
    characterizing the morphological changes of the
    valve.
  • more informative about tricuspid valve defects
  • echocardiographic data on the changes in the left
    ventricular outflow tract help to explain the
    origin of the spindle-form systolic murmur.
  • Phonocardiography
  • better diagnosing of mitral
  • insufficiency, diagnosis of
  • aortic valve defects
  • more informative about state of aortic valves
  • interpretation of systolic murmur was rather
    complicated, although they are often seen on
    phonocardiographic data of normal individuals and
    patients with heart diseases.

39
Case Study
40
(No Transcript)
Write a Comment
User Comments (0)
About PowerShow.com