Title: Paddle Boat
1Paddle Boat
2Cut out boat patterns
3Glue hull patternto lumber
4Center hull patternon lumber
5Get a scroll saw for your bench
6Clamp saw base to table
7Begin sawing hullto shape
8Front of boat cutto pattern
9Hull sawed forpaddle location
10File hull to shape after cutting
11Mark for holesto be drilled
12Mark hull for location of cabin, mark inside
cabin corners
13USE DRILL PRESS WITH 1/4 DRILL BIT
14LINE UP BIT FOR DRILLING
15DRILL HOLES. HOLD HULL TIGHT TO TABLE
16HOLES COMPLETED
17Layout and glue cabin/paddle patterns on lumber
18Note 2nd side traced from pattern
19Saw out cabin parts, HAVE INSTRUCTOR CHECK BEFORE
CUTTING
- Second part identified with traced pattern
20File multiple parts at the same time, to get same
sizes
21Draw lines from corner to corner
22Lines drawn for drilling portholes
23Line up drill point with center
24Clamp downfor drilling
25Drill 1st hole,clamp downfor 2nd hole
26Portholes done
27You will need to get abrasive paper from your
instructor
- Check your written sanding directions for grit
sizes
28Use open coat garnet for sanding wood
29Use a sanding block on all flat surfaces
30Pull back top of block to insert paper
31Press down to get nails through paper
32Sand with the grain
33Clamp parts in vice for sanding
34Rotate parts in vice to sand all surfaces
35Clamp hull in vice and put cabin parts on hull
36Place cabin parts on hull
37Get clamp ready
38Test clamp w/roof
39Apply wood glue to parts and assemble on hull
40Apply glue to top of cabin walls and clamp roof on
41Fit paddles together
42Glue paddles with hot glue
43Glue dowels into holes
- Glue before gluing cabin or after cabin is dry
44Put glued boat into finishing room
45Put glued boat on shelf in finishing room
46Get rubber band from instructor and assemble
paddles to boat