Title: Fluid Dynamics
1TOPIC 5
- Bernoullis Equation- Mechanical Energy Balance
2Mechanical Energy Balance
From the energy equation (4.5) dividing by mass
and assuming incompressible flow
Lets define the friction heating per unit mass
3Mechanical Energy Balance
(5.1)
This is the Mechanical Energy Balance or
Bernoullis equation
By dividing eq. (5.1) with g we obtain the head
form of the Mechanical Energy Balance
(5.2)
- F /g (sometimes symbolized as hL ) is the
friction or head loss
4Example Pumping n-pentane
- The figure below shows an arrangement for pumping
n-pentane (r 39.3 lbm/ft3) at 25C from one
tank to another, through a vertical distance of
40 ft. All piping is 3-in I.D. Assume that the
overall frictional losses in the pipes are given
by the following expression - (losses) 2.5 V2 ft2/s2 2.5 V2/gc ft.lbf/lbm.
- The pump and its motor have a combined efficiency
of 75. If the mean (average) velocity, V is 25
ft/s, determine - (a) The power required to drive the pump
5Simplifications
- Assumptions
- Steady, incompressible, frictionless (inviscid)
flow - No heat transfer or change in internal energy, no
shaft work - Single input-output
- Bernoullis equation (5.1) reduces to
(5.3)
In terms of heads (units of length)
(5.4)
6Example Pumping n-pentane (contd)
- For the pumping n-pentane example, shown in page
5.4 determine - (b) The pressure at the inlet of the pump and
compare it with 10.3 psia, which is the vapor
pressure of n-pentane at 25C - (c) The pressure at the pump exit
- Note For simplicity you can ignore friction in
the short length of pipe leading to the pump inlet
7Example Tank Draining (Torricellis equation)
- Consider a tank full of water and open at the
top. There is a hole near the bottom, the
diameter of which is small compared with the
diameter of the tank. Find the velocity of the
fluid leaving the tank. (The velocity of the
fluid in the tank itself can be treated as
negligible).