Silicone Rubber Keypad Manufacturer

1
Silicone Rubber Keypad Manufacturer in Singapore
2
Recently, manufacturers have started to move away
from ordering molded keypads as separate
components for their equipment interfaces.
Instead they are saving time and money by
ordering entire control assemblies that include
keypad and circuitry. Faster Equipment
Manufacture Time is money and if a manufacturer
can produce a device faster, that translates to
lower expenses and greater profits.
3
Process optimization leads to more efficient
production lines that is important during these
highly competitive times. Even a small advantage
translates to major savings for a company when
performed over large production runs. Using
keypad assemblies rather than separate molded
keypads, circuit boards and associated components
simplifies the manufacturing process.
4
It's easier to install a single subassembly
rather than several parts. It's faster and there
are fewer chances for mistakes that could cause
faults in the device. This means fewer devices in
the reject bin and less need for replacement
manufacturing. Faster production and lower
failure rate allows organizations to improve
fabrication rates and get more devices
manufactured in a day.
5
Easier Parts Management Most devices produced
today involve thousands of parts from individual
screws to major subassemblies. The logistics
involved keeping inventories up and manufacturing
lines supplied is daunting. Reducing the number
of components by using control assemblies rather
than separate molded keypads simplifies the parts
management process.
6
Using assemblies can also drop the number of
vendors needed. A traditional control design may
involve getting molded keypads from one place,
circuit boards from another and other interface
components from still more vendors. If any of
these vendors experiences a production problem or
goes out of business, the entire assembly process
comes to a halt.
7
Component Compatibility Manufacturers are never
completely sure components from different vendors
will work together. Ordering parts manufactured
to tight tolerances is expensive, but allowing
variations that are too large guarantees
headaches as different components don't quite fit
with each other.
8
Ordering a control assembly from a single vendor
ensures each component has already been tested
with each other. Molded keypads are already fit
into the frames and contacts are perfectly lined
up to match the underlying circuitry. Clients
don't have to worry about small differences in
manufacturing from different vendors leading to
misaligned controls and non-functioning control
panels.
9
Many keypad manufacturers offer assembly services
in addition to their standard keypad products.
Clients need to provide a schematic bill of
materials and component requirements to start the
process to create completed and tested control
assemblies.
10
Companies that transition from ordering separate
components to using sub assemblies are often
surprised by how much and how quickly their
production efficiency improves. The Silicone
keyboard usually has high flexibility and
sensitivity. It is usually used in high-end
mobile phones that still use Custom Keypad model
in the input system.
11
To Order Find Out More Information On Touch Panel
Suppliers Please Come And Visit Us Today
Onwards..!
Polytech Component Pte Ltd Contact Us 10 Ubi
Crescent 04-68 Singapore - 408564 Tel 1 65
6742 7738 Tel [phone] Fax 65
6749 7793 Mail enquiry_at_polytech.com.sg Web
http//www.polytech.com.sg/