Title: Diffusion
1Diffusion
- Kausar Ahmad
- Kulliyyah of Pharmacy,IIUM
- http//staff.iiu.edu.my/akausar
2Contents
- Lecture 1
- Diffusion process
- Lecture 2
- Equations describing diffusion phenomena
- Methods to study diffusion
- Lecture 3
- Factors affecting diffusion process
- Applications
3Example
- Diffusion plays a key part in the movement of
oxygen from lungs to blood. - This is an example of diffusion of gas in liquid.
4Pulmonary gas exchange
- driven by passive diffusion.
- Substances move down a concentration gradient.
Oxygen moves from the alveoli (high oxygen
concentration) to the blood (lower oxygen
concentration, due to the continuous consumption
of oxygen in the body). - Conversely, carbon dioxide is produced by
metabolism and has a higher concentration in the
blood than in the air. Thus.
5Introduction
- Diffusion occurs in
- Gas
- Liquid
- Solid
- Effusion occurs in gas
- The process by which a gas escapes from its
container through a tiny hole into an evacuated
space.
6The Process of Diffusion
Molecule migration from region of high to low
concentration
Brownian movement of solute molecule
Achieve equilibrium state
7Passive Diffusion of Ions or Molecules
- The dashed line is a membrane that is permeable
to the molecules or ions illustrated as red dots.
- Initially all of the red dots are within the
membrane. - As time passes, there is net diffusion of the red
dots out of the membrane, following their
concentration gradient. - When the concentration of red dots is the same
inside and outside of the membrane the net
diffusion ceases. - However, the red dots still diffuse into and out
of the membrane, but the rates of the inward and
outward diffusion are the same resulting in a net
diffusion of zero.
8Rate of Diffusion
- Gas gt liquid gt solid
- Distances between molecules are much shorter in a
liquid than in a gas. - Collisions are much more frequent.
- Migration becomes lesser.
- Thus, diffusion is slower.
9atmosphere
Mountain Al-Quran 3527
Describe how these pictures can be related to the
diffusion process.
10Environmental Flow
- The environment demonstrates beautifully the
abilities of the three states to flow and
diffuse. - Atmospheric gases mix so well that the 80 km of
air closest to Earth has a uniform composition - Much less mixing occurs in the oceans, and the
differences in composition at various depths
support different species. - Rocky solids intermingle so little that adjacent
strata remain separated for millions of years.
11Diffusion in Polymers
- permeation
- diffusion of small molecules (permeants) through
a polymer - polymer self-diffusion.
12Permeation through Polymers
- Permeant molecule migrates through the voids
between the polymer chains. - Rate of diffusion depends on the size of the
permeant relative to the gaps between the
polymer molecules.
13Effect of polymer crystallinity
- Size effect is strongest for crystalline
polymers, where the material has a rigid
structure. - In elastomers, movement of thepolymer
molecules can allow free passage of
the permeating species, giving higher diffusion
rates which are less dependent on permeant
size.
14Self Diffusion of Polymers
- Occurs by threading of a molecule along its
length - a process called reptation by analogy
with the mechanism that a snake uses to move
along the ground. - In the polymer, a defect such as a kink in the
chain can move at random along the chain, thereby
driving the molecule through the material.
15Diffusion in liquids
- Diffusion in simple liquids is similar to the
diffusion of gas molecules as described in
kinetic theory, - the mean free path is very short (approximately
the size of a molecule). - The lack of a rigid lattice means that individual
atoms or molecules can move more freely, and
diffusion in liquids is usually characterised by
high diffusion rates.
End Lecture 1/3
16 17Ficks First Law of Diffusion
- Amount of substance, dm,
- diffusing in x direction,
- in time dt,
- across an area A,
- Is proportional to concentration gradient dc/dx.
- Thus, the diffusion rate is
- dm/dt constant(A)(dc/dx)
18- Constant is D, diffusion coefficient
(diffusivity) - Diffusion rate -gt dm/dt -DA(dc/dx)
- D is not constant, varies slightly with
concentration - D can be considered as mean value for
concentration range covered - -ve because it is in the direction of
decreasing concentration
19Ficks Second Law of Diffusion
- The concentration rate of change,
- within diffusional field,
- at a particular point,
- is proportional to rate of change in
concentration gradient. - Dc/dt D(d2c/dx2)
20Einsteins Law of Diffusion
- For diffusion of colloidal particles,
- D kT/f
- f friction coefficient
- k Boltzmann constant (1.38 x 10-23 JK-1)
- T absolute temperature (K)
21Stokes Law
- For spherical particles, friction coefficient is
- f 6??r
- ? viscosity of medium
- r radius of particle
22Stoke-Einstein Law
- Boltzmann constant, k R/N
- R gas constant (8.314 JK-1mol-1)
- N Avogadro number (6.022 x 1023 mol-1)
- From Einstein
- D kT/f
- D kT/ 6??r
- D RT/6N??r
23Measurement of Diffusion
- Porous disc method
- m -DA(c1 c2)(t1 t2)/L
- m amount of solute diffused
- c1,c2 solute concentration at either side of
the disc at time t1,t2 - A cross section of pores
- L effective length of pores
- A/L is obtained by calibrating the cell in solute
with known D
24Solution t1, c1
A
Solvent t2, c2
Path of a particle diffusing through porous disc
A
t1,c2
25Limitation of Porous disc method
- Calibration of cell with low molecular weight
solute may not be valid for high molecular weight
solutes. WHY???? - Trapped air bubbles in pores.
- Adsorption of molecules in pores.
26Diffusion through gels
x
- Mt Moe(-x2/4Dt)
- ln Mt ln Mo (-x2/4Dt)
- ln Mt ln Mo - (x2/4Dt)
- x2/4Dt ln Mo - ln Mt
- x2/t 2.303 x 4D(log Mo - log Mt)
- A plot of x2 against t gives a straight line,
- Slope 2.303 x 4D(log Mo - log Mt)
- D can be calculated
Solution M0
Gel
x2
t
27Continue Diffusion through gels
- Applications
- Cup plate method of assay of antibiotics
- Diffusion through agar gels seeded with test
organism - Zone of growth inhibition proportional to
antibiotic potency
28Continue Diffusion through gels
- Zone of growth inhibition proportional to
antibiotic potency
inhibition of growth zone
filled with antibiotic
29Membrane Functions
- A. Form selectively permeable barriers
- B. Transport phenomena
- 1. Passive diffusion
- 2. Mediated transport
- a. facilitated diffusion carrier/channel
proteins - b. active transport
- C. Cell communication and signaling
- D. Cell-cell adhesion and cellular attachment
- E. Cell identity and antigenicity
- F. Conductivity
30- Membrane allows separation of
- small molecules from
- big macromolecules
31Passive Diffusion
32Facilitated Diffusion
33Facilitated Diffusion
- This animation illustrates protein mediated,
facilitated diffusion out of a cell. - The protein is a uniporter, transporting one
substrate across the membrane. - In facilitated diffusion, the protein allows
molecules or ions to enter or leave the cell
moving DOWN their concentration gradient. - The concentration of molecules or ions
(illustrated by the red dots) is greater inside
the cell than outside the cell. Thus, the protein
carrier allows the red dots to leave, down their
concentration gradient. - If the concentration of red dots was higher
outside of the cell than inside of the cell the
protein would allow the dots to pass into the
cell just as easily.
34e.g. 1) Diffusion through Membrane
- Absorption of weakly acidic/basic drugs
- Passive diffusion of un-ionised molecule across
lipoidal membrane of GIT.
35e.g. 2) Diffusion through membrane
- Purification by dialysis
- Low MW impurities such as electrolytes are
separated from colloidal particles. - Cellophane sac (Visking tube) containing the
substance is immersed in large amount of water. - Pores of cellophane membrane are large enough for
low MW solutes to pass through,but larger ones
remain in the tube (MW cutoff point 50,000). - Water into which the small solutes diffused, will
be changed until the dialysate is free of
electrolytes (monitored by change in
conductivity).
36e.g. 3) Diffusion through membrane
- Diffusion from Dosage Form
- Drugs are incorporated in insoluble matrix e.g.
wax, fatty alcohol, polymer - GIT fluid penetrate the pores and drug particles
are leached out. - The diffusion of drug through the insoluble
liquid-filled matrix is achieved via a tortuous
path.
37Rate of drug released from one surface of
insoluble matrix (Higuchi,1963)Q DeCs(2A
eCs)t/t)1/2
- Q amount of drug released per unit area at time,
t - D diffusion coefficient
- e porosity of matrix
- Cs solubility of drug
- A concentration/amount of drug in the tablet
- ? tortuosity of matrix
End Lecture 2 /3
38 39Factors affecting DiffusionFicks First Law
dm/dt -DA(dc/dx), Stoke-Einstein Law D
RT/6N??r
- Area (A)
- As surface area /cross-sectional area of pores
increases,amount of solutes diffused, dM or
M,increases. - E.g. amount absorbed in small intestine is higher
than in stomach. - Concentration gradient (dc/dx)
- As the concentration gradient (difference)
increases, dM or M increases
40Continue Factors affecting Diffusion
- Time (t)
- As duration increases, dM or M increases,until
saturation is obtained. - Distance or thickness (x or L)
- As distance/thickness increases, dM or M
decreases. - E.g. transdermal drug delivery depends on
location due to varying thickness of the skin
thigh, arm, chest, back, sole, palm, back of ear. - Temperature (T)
- As temperature increases,diffusion
coefficient,D,increases, dM or M increases
41Continue Factors affecting Diffusion
- Frictional coeffiecient (f)
- As f increases, D decreases, dM or M decreases.
- Viscosity (h)
- f ? h and D ? 1/h, as h increases, dM or M
decreases. - Particle size (r)
- f ? r and D ? 1/r, as r increases, dM or M
decreases. - Pore size or porosity
- As porosity increases, dM or M increases.
42Continue Factors affecting Diffusion
- Tortuosity
- As t increases, dM or M decreases.
- Solute interaction with gel matrix or diffusion
medium. - Pore size of gel decreases.
- Viscosity of liquid within the pores increases.
- Affects network structure of gel.
- Opposite charge of matrix ionised groups may
result in adsorption,thus retarding diffusion. - E.g. gelatin
43Continue Factors affecting Diffusion
- Gelatin
- Contain -NH2 and -COOH groups
- pH influences ionisation
- In acidic condition, gel is positively charged
- In alkaline condition, gel is negatively charged
44Application of Diffusion
- Determine physical parameters of particle
- E.g. D kT/6??r
- Chromatography
- Size exclusion chromatography - separate large
molecules from small ones - Sample analysis using HPLC
45Continue Application of Diffusion
- Dialysis
- Isolation of impurities from colloidal particles
- E.g. Removal of low MW water-soluble proteins
from natural rubber latex, a possible source of
allergens. - Isolation of drugs from cream base
- Haemodialysis/purification of blood remove
small MW metabolic waste product while preserving
high MW components.
46Continue Application of Diffusion
- Drug release from control-release preparations
- Matrix system
- Coating system opacifier, taste-masking,
control-release - Transdermal system
- Reservoir system
- Matrix system control-release
47Continue Application of Diffusion
- Drug release from ointment/cream
- Gastro intestinal absorption of drugs
- Drugs pass through membrane can be either
active or passive transport - Passive transport simple diffusion driven by
differences in drug concentration on the two
sides of the membrane animation
48Continue Application of Diffusion
- Transcorneal permeation
- Permeability coefficient for undissociated drugs
- Percutaneous absorption passage through skin
- Dissolution of drug in its vehicle
- Diffusion of solubilised drug (solute) from
vehicle to surface of skin - Penetration of drug through layers of skin esp.
stratum corneum - Buccal absorption
- Suppository (bioadhesive)
49Lateral Diffusion of Proteins
- The cell is gray.
- The green dots indicate fluorescently labeled
antibodies which have bound to proteins on the
surface of the cell. - The green dots move across the surface of the
cell. - A tiny but intense laser beam is applied, which
bleaches the flourescent labels in a small area
on the surface of the cell. - This photobleaching produces a patch of unlabeled
cell surface that appears gray. - With time, however, proteins with fluorescent
labels that were not bleached diffuse back into
the area which was bleached and the bleached
proteins diffuse away. - The bleached spot disappears and the cell is
uniformly labeled again. - This type of experiment has been used to provide
evidence that proteins are free to diffuse
laterally across the plane of the membrane.
http//bio.winona.msus.edu/berg/ ANIMTNS/difusean.
htm
50Diffusion of Membrane Proteins
- use antibodies to couple fluorescent dyes to
specific membrane proteins. - proteins of human cells were labeled with blue
dye and the proteins of mouse cells were labeled
with red dye. - view cells with a fluorescence microscope and see
the individual proteins diffusing on the human
and mouse cells. - the human and mouse cells were subjected to
conditions which allowed the cells to fuse
together forming a living hybrid cell with two
nuclei. - the fluorescently labeled proteins of the human
and mouse cells diffuse across the plane of the
membrane, intermingling together and completely
randomizing their distribution in less than one
hour.
- http//bio.winona.msus.edu/berg/ANIMTNS/Prot-dif.h
tm
51References
- EA Rawlins, Bentleys Textbook of Pharmaceutics
8th Ed., Bailliere Tindall (1984) Chapter 8
Diffusion - http//bio.winona.msus.edu/berg/ANIMTNS/Prot-dif.h
tm - http//cr.middlebury.edu/biology/labbook/diffusion
// - http//www.d.umn.edu/sdowning/Membranes/lectureno
tes.html - http//www.biologycorner.com/bio1/diffusion.html