INTERNET ADDRESSING - PowerPoint PPT Presentation

1 / 39
About This Presentation
Title:

INTERNET ADDRESSING

Description:

IP Addresses often expressed in 'dotted-decimal. notation' made up of four 8 ... of allocated IPv4 addresses ... of Class A, B, C, classful network addresses ... – PowerPoint PPT presentation

Number of Views:134
Avg rating:3.0/5.0
Slides: 40
Provided by: robert119
Category:

less

Transcript and Presenter's Notes

Title: INTERNET ADDRESSING


1
INTERNET ADDRESSING
2
Internet Protocol Version 4 (IPv4)
  • In 1973, Vint Cerf and Bob Kahn (then working for
    DARPA) decided that a 32-bit address was more
    than adequate for the foreseeable future
  • Provides for 232 addresses
  • 4,294,967,296 IPv4 addresses

3
Robert Shaws Workstations 32-bit Address
10011100001101011000001000100000
IP Addresses often expressed in dotted-decimal
notation made up of four 8-bit (byte) values
10011100.00110101.10000010.00100000
156
.106
.130
.32
4
Internet Scaling Problems
  • Ability of Internet backbone routers to route
    traffic between increasing number of networks on
    the public Internet
  • Potential exhaustion of allocated IPv4 addresses

5
Scaling Ability of Internet backbone Routers to
route traffic
  • Router is device/software that determines the
    next network point to which a packet should be
    forwarded toward its final destination
  • Operates at network layer (layer 3) of the OSI
    Reference Model

6
Scaling Routing Problems
  • Routers create/maintain table of the available
    routes and conditions and uses this along with
    distance and cost algorithms to determine the
    best path for a given packet.
  • Exponential growth of Internet is reflected in
    growth of global routing tables and computing
    power needed to calculate routing table/topology
    changes

7
Exhaustion of IPv4 address space
  • Portions of the IP address space have not been
    efficiently allocated
  • Original allocation model of classful
    addressing was not efficient

8
Classful IP Addressing
  • When IP standardized in Sept 81, each system
    attached to IP network defined to have unique
    32-bit address
  • Some systems, like Routers, must have interfaces
    to more than one network so must be assigned a
    unique IP address for each network interface
  • Original idea was that different class size
    would reflect number of hosts in organizational
    networks

9
Classful IP Addressing
  • Two-level address structure created

Network-Number
Host-Number
or
Network-Prefix
Host-Number
  • First part identifies network on which the host
    resides
  • Second part identifies host on the given network

10
Primary ClassfulAddress Classes
11
Class A Networks (/8 Prefixes)
  • 8 bit network prefix with highest order set to 0
    followed by 7 bit network number and 24 bit host
    number
  • Maximum of 126 (27 -2) /8 networks can be defined

12
Class A Networks (/8 Prefixes)
  • Each /8 supports maximum of 16,777,214 (224-2)
    hosts per network
  • /8 contains 231 (2,147,483,648) addresses which
    is 50 of the total IPv4 address space

13
Class B Networks (/16 Prefixes)
  • 16 bit network prefix with highest order bits set
    to 1-0 followed by 14 bit network number and 16
    bit host number
  • Maximum of 16,384 (214) /16 networks can be
    defined

14
Class B Networks (/16 Prefixes)
  • Each /16 supports maximum of 65,534 (216-2)
    hosts per network
  • /16 contains 230 (1,073,741,824) addresses which
    is 25 of the total IPv4 address space

15
Class C Networks (/24 Prefixes)
  • 24 bit network prefix with 3 highest bits set to
    1-1-0 with 21 bit network number and 8 bit host
    number
  • Maximum of 2,097,152 (221) /24 networks can be
    defined

16
Class C Networks (/24 Prefixes)
  • Each /24 supports maximum of 254 (28-2) hosts
    per network
  • /24 contains 229 (536,870,912) addresses which
    is 12.5 of the total IPv4 address space

17
Recognizing Classful Addresses
  • A (/8 prefixes)
  • B (/16 prefixes)
  • C (/24 prefixes)
  • 1.xxx.xxx.xxx - 126.xxx.xxx.xxx
  • 128.0.xxx.xxx - 191.255.xxx.xxx
  • 192.0.0.xxx - 223.255.255.xxx

Where xxx host number
18
Limitations to Classful Addressing
  • During early days of Internet, appearance of
    unlimited IP address space allowed allocations
    be made on request and not need
  • Classful A, B, and C octet did not permit
    efficient allocation of finite address space (our
    shoe sizes are small, medium and large)

19
Limitations to Classful Addressing
  • Lets take a medium-size organization
  • /24 supports 254 hosts
  • /16 supports 65,534 hosts
  • Which would you choose?
  • In past, instead of assigning several /24
    addresss, were given a /16 which has led to
    premature depletion of /16 space
  • but /24s increase size of routing tables..

20
Subnetting
  • In 1985, RFC 950 defined procedure to support
    subnetting or division of a Class A, B, or Cs
    into smaller pieces
  • To overcome
  • Internet routing table growth
  • need to request additional network numbers when
    installing new networks

21
Subnetting - More Hierarchy to Classful Addresses
22
Subnetting
  • Example site with several logical networks can
    be assigned a single /16 (Class B) network
    address
  • Traffic forwarded by router to interior subnets
    based on 3rd octet value
  • Subnet structure is never visible outside of
    private network

23
Subnetting
130.5.32.0 130.5.64.0 130.5.96.0 130.5.128.0 1
30.5.160.0
130.5.192.0 130.5.224.0
Private Network
130.5.0.0
INTERNET
router
24
Subnetting Advantages
  • Size of global Internet routing tables does not
    grow
  • Local administrator can deploy additional subnets
    without obtaining a new network number
  • Route flapping (rapid changing of routes) within
    private network does not affect Internet routing
    tables

25
Extended Network Prefix
  • Internet routers use only network prefix of
    destination address to route traffic to subnetted
    environment
  • Routers within subnetted environment use
    extended-network-prefix to route between subnets

26
Extended Network Prefix
  • Extended-network-prefix identified by subnet
    mask
  • For example, if you have /16 address of 130.5.0.0
    and you want to use the 3rd octet to represent
    subnet-number, the subnet mask is 255.255.255.0

27
Extended Network Prefix
  • Subnet masks bits set to
  • 1 if examining system should treat corresponding
    bit as part of extended network prefix
  • 0 if examining system should treat corresponding
    bit as part of the host number

IP Address 130.5.5.25
10000010.00000101.00000101.00011001
Subnet Mask 255.255.255.0 11111111.11111111.1111
1111.00000000
28
Extended Network Prefix
  • Instead of dotted-decimal notation used in
    subnet mask (255.255.255.0), standards now refer
    to extended-network-prefix length
  • So network address 130.5.5.25 with subnet mask of
    255.255.255.0 can also be expressed as
    130.5.5.25/24

29
Variable Length Subnet Masks
  • In 1987, RFC 1009 specified how a subnetted
    network could use more than one subnet mask
  • When a network is assigned more than one subnet
    mask, it is consider a network with variable
    length subnet masks since extended-network-prefix
    es have different lengths

30
Variable Length Subnet Masks
  • VLSM supports more efficient use of an
    organizations assigned IP address space
  • With only a single subnet mask across a network
    prefix, an organization was locked into a fixed
    number of fixed size subnets

31
Variable Length Subnet Masks
  • Example fixed /22 extended network prefix means
    hosts fixed at 210-2 (1,022 hosts)

host-number of bits
Subnet-number of bits
Network Prefix
130.5.0.0/22 10000010.00000101.00000000.00000000
Extended-Network Prefix
32
Variable Length Subnet Masks
  • VLSM permits slicing and dicing subnets into
    different sizes and therefore numbers of hosts in
    subnets
  • VLSM also supports recursive division of an
    organizations address space so it can be
    reassembled and aggregated to hide the complexity
    of routing information at each level

33
Route Aggregation
34
Route Aggregation
35
Classless Inter-Domain Routing (CIDR)
  • CIDR documented in Sept 1993 in RFC 1517, 1518,
    1519, and 1520
  • Eliminates concept of Class A, B, C, classful
    network addresses
  • Supports route aggregation where single routing
    table entry can represent thousands of classful
    routes

36
Classless Inter-Domain Routing (CIDR)
  • Uses generalized concept of network prefix and
    routers use this prefix rather than first 3 bits
    of an IP address to determine dividing point
    between network number and host number
  • Supports deployment of arbitrarily sized networks
    (shoes come in all sizes)

37
Classless Inter-Domain Routing (CIDR)
  • In classless environment, prefixes are viewed as
    bitwise contiguous blocks of IP address space
  • For example, all prefixes with a /20 prefix
    represent the same amount of host address space
    (212 or 4,096)

38
Classless Inter-Domain Routing (CIDR)
  • Example of /20 (212 or 4,096 hosts) assigned to
    traditional classful Class A, B, and C

Traditional A 10.23.64.0/20
00001010.00010111.01000000.00000000
Traditional B 130.5.0.0/20
10000010.00000101.00000000.00000000
Traditional C 200.7.128.0/20 11001000.00000111.1
0000000.00000000
39
Most Commonly Deployed CIDR Address Blocks
Write a Comment
User Comments (0)
About PowerShow.com