Ultima

1
Ultima X3 Gas Monitor
2
Ultima X3 Technology

• ModBus output
• Multisensing
• Up-to 3 sensors per transmitter
• Signal Boost

3
Ultima X3 ModBus Output

• ModBus RTU
• Industry standard
• More available data than any sensor / transmitter
  on the market
• Over 200 datum
• Prosoft Tested
• Certified
• Compatible with Allen-Bradley PLC

4
Ultima X3 Multi-Sensing

• Up-to 31 monitors on one network
• Up-to 3 sensors per monitor
• Total of 93 sensors on one bus network
• Half duplex
• Multi-drop

5
Ultima X3 Power Parameters
6
Ultima X3 Network Topography
7
Ultima X3 Maximum Sensor Combinations
Electrochemical Catalytic Bead Infrared
3 0 0
2 1 0
2 0 1
1 1 1
1 2 0
1 0 2
0 3 0
8
Ultima X3 Without Remote Power
Electrochemical Catalytic Bead Infrared
3 0 0
2 1 0
2 0 1
1 1 1
1 2 0
1 0 2
0 3 0
Only One Catalytic Bead sensor allowed with
Infrared sensor
9
Ultima X3 Examples
10
Ultima X3 Main PCB

• Same sensor to main PCB wiring scheme
• Total of three sensor connectors
• 100 ft - 4 wire
• 2 power
• 2 comms
• 3000 ft 5 wire
• 2 power
• 3 comms

11
Ultima X3 Signal Boost Requirements

• Signal converter PCB added to main enclosure if
  signal boost needed for any sensor

12
Ultima X3 Signal Boost Requirements

• Signal converter PCB required at each remote
  sensor
• External power supply required for remote sensors

13
Ultima X3 Display Sequence

• Similar display sequence as standard X
• Gas type
• Gas reading
• Sensor flag details sensor number

14
Ultima X3 Fault Condition

• Fault message appears for particular sensor
• Display locks
• Condition must be acknowledged before display
  will cycle.

15
Ultima X3 Alarm Condition

• Alarm flag is displayed
• Display locks
• Display clears
• Unlatched alarm clears
• IR / push-button reset after latched alarm
  condition goes below set point

16
Ultima X3 Relay Configurations

• Standard (as shipped)
• Each sensor alarm tied to different relay

17
Ultima X3 Relay Configurations

• Optional setting through Controller
• Each sensor tied to different relay
• One alarm set point per sensor

18
Ultima X3 Calibration

• Will require a two man calibration with increased
  remote sensing distances
• Sensor exchange program available
• How the program works
• Replacement modules are shipped at pre-determined
  intervals of 1, 2, 3, 6, and 12 months.
• Sign a program agreement for your choice of 1, 2,
  or 3 years.
• Receive a pre-calibrated sensor module plus
  complete calibration documentation in a
  returnable, pre-labeled container
• The shipping container, which identifies the
  sensor type, is used for return of the old sensor
  module.

19
Ultima X3 Technology

• ModBus RTU output
• Multi-sensing capabilities, allowing up-to three
  sensors to one monitor
• Signal boost option, allowing for up-to 3000ft.
  between remote sensor and monitor