ZOLL M SeriesE Series Biphasic: SpO2 SelfPaced Training Module

1
ZOLL M Series/E Series Biphasic SpO2 Self-Paced
Training Module 7
2
Objectives

• At the end of this module the participant can
• Place an SpO2 device.
• Configure alarms for the SpO2 option.
• Connect the SpO2 cable to the back of the
  machine.

3
Select a Sensor Site

• Choose a well-profused site
• Ring or middle finger of non-dominant hand
• Long or great toe
• Avoid extremity with a blood pressure cuff,
  arterial catheter or intravenous line

4
Sensor Re-Usable

• Place the patients digit inside the sensor
• The top and bottom half of sensor should be
  parallel for an accurate measurement

5
Sensor Re-Usable
The emitter and detector of the infrared light
should be vertically aligned Remove wrapping and
folk over finger, securing the wings in place
6
Sp02 Cable

• Verify that the SpO2 cable is connected to the
  SpO2 port on the back of the
• M Series/E Series

Co2 SpO2 Multifunction Cable ECG
7
Connecting the Sp02 Cable

• Whether using the disposable sensor or reusable
  sensor
• Align the Masimo logo from the sensor cable to
  the Masimo logo on the SpO2 cable and click
  together

8
Turn Selector Switch to Monitor (Gray) Defib
(Red) or Pacer (Green)

• Once the M Series/E Series is turned on, the SpO2
  measurement will appear in the left corner of the
  screen.
• To adjust the SpO2 alarm, access the Alarms
  softkey and use the Sp02 softkey to scroll to the
  desired setting

9
Reading the Display

• Pulse Oxymetry information is displayed in the
  SpO2 area as a number
• Also shown are the state of the alarm and the
  signal strength indicator

10
Displaying the SpO2 Menu

• By accessing the Param softkey, the menu will
  display the SpO2 option
• Press Select softkey until SpO2 is highlighted.
  Press the Enter softkey.

11
Changing the Sensitivity

• When the patient is exhibiting low blood flow,
  the sensitivity can be increased.
• Press the Sens. softkey and then use the Sens.
  softkey to scroll through the options. Pressing
  enter will select the option.

12
Printing the SpO2 Waveform

• Using the Wave2 softkey, press until the SpO2
  waveform displays under the ECG display
• Press the Recorder button to print a strip chart
• Press the Recorder button again to halt the strip
  chart printing

13
Factors That Can Affect SpO2

• Incorrect sensor application or use
• Dysfunctional hemoglobin (meth-hemoglobin)
• Excessive patient movement
• Hypotension, vasoconstriction, hypothermia
• Nail polish, fungus, acrylic nails

14

• This concludes Module 7 SpO2 Measurement. Please
  continue on with other modules which may be
  required at your facility