Title: 18th FORUM Energy Day in Croatia
118th FORUM - Energy Day in Croatia
HOW TO ADDRESS THE CHALLANGES OF THE CLIMATE
PRESERVATION Goran Granic, Ph.D. Helena Boic,
Ph.D. Damir Peut, M.Sc. Energy Institute
Hrvoje Poar Zagreb, 2 November 2009
2INTRODUCTION
- So far the energy system planning was based on
the cost function models and energy-technnological
-siting limitations - Dramatic reduction of CO2 and other greenhouse
gases emissions, financial support to renewable
energy and cogeneration producers, development of
new technologies and energy management concepts
require the use of optimisation models and
observations of longer periods of time (up to
2050)
3TERMS OF SIMULATION
- This paper analyses the possibilities for
applying the energy efficiency measures and using
renewable energy sources for heating, hot water
preparation, cooling, non-heat electricity and
electricity generation in the households by use
of the MARKAL model - The MARKAL model is the optimisation model for
energy system long term planning - The energy system of the Republic of Croatia was
observed (including all consumption sectors)
within the planning period upt to 2050 - The useful energy needs in all consumption
sectors were forecast by use of the MAED model
4TERMS OF SIMULATION
- The scenarios used in the analysis
- Reference Scenario (RS) includes all energy
efficiency measures which would be applied in the
energy system on the basis of least-cost
principle with a condition that there are no CO2
emission targets - Hurdle Rate Scenario (HS)
- CO2emission Targets Scenario (ES)
- Support Analysis Scenario (SS)
- The household sector is divided by consumption
categories - Single houses with central heating
- Single houses with room heating
- Apartments in buildings with central heating
- Apartments in buildings with room heating
5TERMS OF SIMULATION
- Beside households the Model covers other energy
consumption sectors - Servies consumption of useful energy for
heating, hot water preparation, cooling, and
non-heat electricity use - Industry consumption of useful energy for direct
and indirect heat, non-heat electricity use in
industry - Transport energy consumption in passenger (city
and inter-city) transport and freight transport
(air transport, maritime transport) - Agriculture and construction activity
electricity consumption, energy for thermal
needs, consumption of motor fuels - For new technologies the Technology Learning
option was used
6ENERGY EFFICIENCY MEASURES IN HOUSEHOLDS
- Insulation (envelops, cieling, windows) and low
energy houses - Gas condensing boilers
- Heat pumps
- Micro cogeneration
- Efficient lighting
- Thermostatic valves, room thermostates,
individual heat meters - Solar collectors and photovoltaic systems
- District heating (small cogenerations) using
pellets - Low energy technologies for non-heat use
(frigirators, chillers, laundry washers and
dryers, etc.) - Electricity losses reduction due to Stand-by
Power option
7ELECTRICITY GENERATIONCandidate Power Plants
- Hydro power plants
- Thermal power plants - coal-fired (conventional,
integrated coal gasification combined cycle, and
with CO2 capture and sequestration) - Thermal power plants - natural gas-fired
(conventional and with CO2 capture and
sequestration) - Nuclear power plant
- Wind power plants
- Geothermal power plants
- Biomass-fired power plants
- Solar power plants
- Public and industrial CHP plants
8ANALYSIS RESULTS Reference Scenario (RS)
The Reference Scenario comprises all those energy
efficiency measures which would be applied in the
energy system on the basis of least-cost
principle with a condition that there are no CO2
emission targets
- The resulst of the (optimisation) Model shows the
cost efficiency of introducing the energy
efficiency measures in households - Insulation carries the highest energy saving
potential in households (envelopes, celeing and
windows insulation) - The biggest energy savings in heating and hot
water preparation can be achieved in single
houses with central heating (households with
highest income and high energy consumption)
Reference scenario (RS)
9ANALYSIS RESULTS Hurdle Rate Scenario (HS)
- Hurdle rate is used for modelling non-economic
parameters, like consumer behaviour (specific
consumers preferences in product choice, e.g.
design), existence of different market barriers
which obstruct smooth entry of new technologies
(lack of funds, lack of legal regulations or
marketing activities) or yield levels (how many
years it takes for return on investment) as a
motive for buyers to decide on an investment.
Higher hurdle rates were used for the following
technologies - Insulations, heat pumps, heat meters and solar
collectors 15 - Micro cogenerations and photovoltaic systems 25
10ANALYSIS RESULTS Hurdle Rate Scenario (HS)
- Total insulation needs in this Scenario are lower
than in the Reference Scenario - Unlike RS, in Hurdle Rate Scenario the highest
needs for insulation have the houses with central
heating and apartments with room heating - An example of comparison results (ratio of final
consumption of a specific measure to total final
consumption for heating) between RS and HS for
houses with central heating
Hurdle Rate Scenario (HS)
11ANALYSIS RESULTSComparison results for RS and HS
scenarios
Hurdle Rate Scenario (HS)
Reference Scenario (RS)
12ANALYSIS RESULTSScenario with CO2 emission
targets (ES)
- Scenario with CO2 emission targets (ES) includes
the Reference Scenario (RS), Hurdle Rate Scenario
(HS) and additional CO2 emission reduction target
of 50 in 2050 (according to recommendations of
the Directive 2009/29/EC) in relation to 1990 - Setting targets for CO2 emission increases the
needs for insulation in buildings
13ANALYSIS RESULTSSupport Analysis Scenario
- Analysis of support i.e., subsidies of investment
cost was performed for insulation and solar
collectors - Investment cost is subsidised by 10 to 70
providing that in this scenario the share of the
technology concerned in total final energy
consumption is equal to the relevant share in the
Emission Target Scenario - Savings potential of insulation in households
depends on investment, type of household
(purchasing power) and energy consumption - Well-off households (households with higher
energy use for heating) have a higher savings
potential of insulation - The results of the Support Analysis Scenario
roughly correspond with expected results of the
experience analysis
14ANALYSIS RESULTSSupport Analysis Scenario (PS)
- Levels of needed support for insulations
- Houses with central heating 70 from 2030
- Houses with room heating 70 from 2020
- Apartments with central heating 20 from 2015
- Apartments with room heating 50 from 2020 and
70 from 2030
Share of insulation in total energy consumption
for haeting
15ANALYSIS RESULTS
- Enhancing energy efficiency is the first priority
in any countrys energy startegy and policy, over
the entire process of energy production,
transformation, transmission, distribution and
consumption at end-user level. - By accomplishing an efficient energy system the
problems of mitigating CO2 and other green house
gases emission will be alleviated. - Energy efficiency as a measure is an obvious
solution it is economically viable and further
rise of energy prices will only add to its
significance. - Insulation in buildings has the highest potential
for enhancing energy efficiency. The assumed
insulation improvement of 5 at annual level in
Croatia translates in to business activities
worth 10 billion HRK (EUR 1.4 bn)
16CONCLUSION
- Steep decrease in CO2 and other GHG emissions
will mean a dramatic change of the relations
within the energy system, in terms both of
production and consumption of energy - In the energy consumption context, the end
customers switch from fossil fuel based
technologies to emission free technologies - Use of fossil fuels is concentrated in places
where their capture and sequestration is possible
(large CHP plants with CCS option) - The consumption of electricity generated from so
called clean technolgies) will increase
significantly, replacing other energy forms at
end user level.
17CONCLUSION
- By including the enviromental protection costs,
primarily the CO2 emission mitigation costs,
financial competitivness of the technologies will
be evaluated based on real energy prices - Expected is a significant development and use of
technologies, including nuclear technology, which
do not generate CO2 and other GHG emissions - Climate protection within the CO2 and GHG
emission mitigation is a feasible project which
must be based on an international agreement that
involves all countries
18CONCLUSION
- It is necessary to set up a general framework
for achieving the target energy policy and
climate preservation policy in the Republic of
Croatia - In every energy process (from production,
transformation, transmission, distribution to
final consumption) energy consumption should be
lower but without affecting the quality of
service - Enhancing energy efficiency in buildings
- Enhancing energy efficiency in all technological
processes - Encourage introduction of single evaluation of
enviromental protection costs, primarily of CO2
emission - Discourage the use of technolgies that increase
CO2 emission levels, and encourage all energy and
technological solutions that are viable in long
run in terms of climate preservation - Create all necessary conditions for permanent
increase of using renewable energy sources - Systematically promote technological advancement
with the aim to enhance energy efficiency and use
of renewable energy sources.
19THANK YOU!
www.eihp.hr