Title: Newton
1Newtons Laws
2Isaac Newton
- Arguably the greatest physical genius ever.
- Came up with 3 Laws of Motion to explain the
observations and analyses of Galileo and Johannes
Kepler. - Invented Calculus.
- Published his Laws in 1687 in the book
Mathematical Principles of Natural Philosophy.
3What is Force?
- A force is a push or pull on an object.
- Forces cause an object to accelerate
- To speed up
- To slow down
- To change direction
4Newtons First Law
- The Law of Inertia.
- A body in motion stays in motion at constant
velocity and a body at rest stays at rest unless
acted upon by an external force. - This law is commonly applied to the horizontal
component of velocity, which is assumed not to
change during the flight of a projectile.
5The First Law is Counterintuitive
Aristotle firmly believed this. But Physics B
students know better!
6A force diagram illustrating no net force
7A force diagram illustrating no net force
8A force diagram illustrating no net force
9A force diagram illustrating no net force
10Another example illustrating no net force
11Newtons Second Law
- A body accelerates when acted upon by a net
external force. - The acceleration is proportional to the net force
and is in the direction which the net force acts. - This law is commonly applied to the vertical
component of velocity.
12Newtons Second Law
- ?F ma
- where ?F is the net force measured in Newtons (N)
- m is mass (kg)
- a is acceleration (m/s2)
13Units of force
- Newton (SI system)
- 1 N 1 kg m /s2
- 1 N is the force required to accelerate a 1 kg
mass at a rate of 1 m/s2 - Pound (British system)
- 1 lb 1 slug ft /s2
14Newtons Third Law
- For every action there exists an equal and
opposite reaction. - If A exerts a force F on B, then B exerts a force
of -F on A.
15Step 1 Draw the problem
Working a Newtons 2nd Law Problem
- Larry pushes a 20 kg block on a frictionless
floor at a 45o angle below the horizontal with a
force of 150 N while Moe pulls the same block
horizontally with a force of 120 N. What is
acceleration?
16Step 2 Diagram
Working a Newtons 2nd Law Problem
17Step 3 Set up equations
Working a Newtons 2nd Law Problem
Always resolve two-dimensional problems into two
one-dimensional problems.
18Step 4 Substitute
Working a Newtons 2nd Law Problem
- Make a list of givens from the word problem.
- Substitute in what you know.
19Step 5 Solve
Working a Newtons 2nd Law Problem
- Plug-n-chug.
- Calculate your unknowns.
- Sometimes youll need to do kimematic
calculations following the Newtons 2nd law
calculations.
20Gravity as an accelerating force
A very commonly used accelerating force is
gravity. Here is gravity in action. The
acceleration is g.
21Gravity as an accelerating force
In the absence of air resistance, gravity acts
upon all objects by causing the same
accelerationg.
22Gravity as an accelerating force
The pulley lets us use gravity as our
accelerating force but a lot slower than free
fall. Acceleration here is a lot lower than g.
232-Dimensional problem
- Larry pushes a 20 kg block on a frictionless
floor at a 45o angle below the horizontal with a
force of 150 N while Moe pulls the same block
horizontally with a force of 120 N. - a) What is the acceleration?
- b) What is the normal force?
24The problem of weight
- Are weight and mass the same thing?
- No. Weight can be defined as the force due to
gravitation attraction. - W mg
25Flat surfaces 1 D
- N mg for objects resting on horizontal surfaces.
26Ramps 2 D
The normal force is perpendicular to angled ramps
as well. Its always equal to the component of
weight perpendicular to the surface.
N mgcos?
27Ramps 2 D
How long will it take a 1.0 kg block to slide
down a frictionless 20 m long ramp that is at a
15o angle with the horizontal?
N mgcos?
28Applied forces affect normal force.
friction
applied force
weight
normal
N applied force
29Elevator Ride going up!
30Elevator Ride going down!
31Friction
- The force that opposes a sliding motion.
- Enables us to walk, drive a car, etc.
- Due to microscopic irregularities in even the
smoothest of surfaces.
32There are two types of friction
- Static friction
- exists before sliding occurs
- Kinetic friction
- exists after sliding occurs
- In general fk lt fs
33Friction and the Normal Force
- The frictional force which exists between two
surfaces is directly proportional to the normal
force. - Thats why friction on a sloping surface is less
than friction on a flat surface.
34Static Friction
- fs ? ?sN
- fs static frictional force (N)
- ?s coefficient of static friction
- N normal force (N)
- Static friction increases as the force trying to
push an object increases up to a point!
35A force diagram illustrating Static Friction
Normal Force
Applied Force
Frictional Force
Gravity
36A force diagram illustrating Static Friction
Normal Force
Bigger Applied Force
Bigger Frictional Force
Gravity
37A force diagram illustrating Static Friction
The forces on the book are now UNBALANCED!
Normal Force
Frictional Force
Even Bigger Applied Force
Gravity
Static friction cannot get any larger, and can no
longer completely oppose the applied force.
38Kinetic Friction
- fk ?kN
- fk kinetic frictional force (N)
- ?k coefficient of kinetic friction
- N normal force (N)
- Kinetic friction (sliding friction) is generally
less than static friction (motionless friction)
for most surfaces.
39Determination of the Coefficients of Friction
- Coefficient of Static Friction
- Set a block of one material on an incline plane
made of the other material. - Slowly increase angle of plane until the block
just begins to move. Record this angle. - Calculate ?s tan?.
40Determination of the Coefficients of Friction
- Coefficient of Kinetic Friction
- Set a block of one material on an incline plane
made of the other material. - Slowly increase angle of plane until the block
just begins to move at constant speed after
giving it a slight tap. Record this angle. - Calculate ?k tan?.
41Magic Pulleys
m1
m2
42Pulley problem
- Mass 1 (10 kg) rests on a frictionless table
connected by a string to Mass 2 (5 kg). Find (a)
the acceleration of each block and, (b) the
tension in the connecting string.
m1
m2
43Pulley problem
- Mass 1 (10 kg) rests on a table connected by a
string to Mass 2 (5 kg) as shown. What must the
minimum coefficient of static friction be to keep
Mass 1 from slipping?
m1
m2
44Pulley problem
- Mass 1 (10 kg) rests on a table connected by a
string to Mass 2 (5 kg). If ms 0.3 and mk
0.2, what is a) the acceleration and b) the
tension in the string?
m1
m2