Title: Fall Protection
1Fall Protection
- Safety Risk Management Services
- UW-Stout
2Introduction
- Falls are the second leading cause of
occupational fatalities and disabling injuries in
the United States. - Each year, over 500 workers die in fall- related
accidents. - Over 300,000 workers suffer a disabling injury.
- Most of these accidents occur from falls from
elevations of _____ feet or less.
3Fall Protection Requirements
- 1926.501 Duty to have fall Protection
- 1926.502 Fall Protection systems criteria and
practices
41926.501 - Duty to have Fall Protection
- All fall protection required by this section
shall conform to the criteria set forth in
1926.502 - The employer shall determine if the
walking/working surfaces on which its employees
are to work have the strength and structural
integrity to support employees safely.
5Duty to have Fall Protection
- Unprotected sides and edges. Each employee on a
walking/working surface (horizontal vertical
surface) with an unprotected side or edge which
is 6 or more above a lower level shall be
protected from falling by the use of guardrail
systems, safety net systems, or personal fall
arrest systems (PFAS).
6Background
- The standard identifies 15 areas or activities
where some type of fall protection is needed if
the potential fall distance is six feet or greater
7Areas/activities covered
- Leading edges (different levels)
- Hoist areas
- Holes (including skylights)
- Ramp, runways other walkways
- Excavations
- Overhead bricklaying related work
- Wall openings
8Areas/activities covered
- Roofing
- Walking/Working surfaces not otherwise addressed
9Exception
- The provisions of this sections do not apply when
employees are making an inspection,
investigation, or assessment of workplace
conditions prior to the actual start of work or
after all work has been completed.
10Leading Edge
- Definition--The edge of a floor, roof, or
formwork for a floor or other walking/working
surface (such as the deck) which changes location
as additional floor, deck, etc. is added. A
leading edge is considered to be an unprotected
side edge during periods when it is not
actively under construction.
11Leading Edge
- Each employee who is constructing a leading edge
6 or more above lower levels shall be protected
from falling unless the employer can demonstrate
it creates a greater hazard to use a fall
protection system.
12Leading Edge
- Each employee on walking/working surfaces shall
be protected from falling through holes
(including skylights) more than 6 feet above
lower levels, by Personal Fall Arrest Systems
(PFAS), covers, or guardrail systems erected
around such holes.
13Holes
- Each employee on walking/working surfaces shall
be protected from falling through holes
(including skylights) more than 6 feet above
lower levels by PFAS, covers, or guardrail
systems. - Employees shall be protected from tripping in or
stepping into holes and from objects falling
through holes.
14Excavations
- Excavations. Each employee at the edge of an
excavation 6 feet or more in depth shall be
protected from falling by guardrail systems,
fences, or barricades when the excavation are not
readily seen because of plant growth or other
visual barrier.
15Excavations
- Excavations. Each employee at the edge of a
well, pit, shaft, and similar excavation 6 or
more in depth shall be protected from falling by
guardrail systems, fences, barricades, or covers.
16Low-Slope roofs
- Definitiona slope to 4 to 12
- Working 6 or more above lower level shall be
protected from falling by - Guardrail system
- Safety net system
- Personal fall arrest system
- Warning line and one of the above
- Warning line and safety monitoring system
17Steep Roofs
- Each employee on a steep roof with unprotected
sides and edges 6 or more above lower levels
shall be protected from falling by guardrail
systems with toe boards, safety net systems, or
PFAS.
18Steep roof - Example
19Low-slope roof - Example
20Low-slope roof - Example
21Low-slope roof - Example
- How would you change that light?
- Articulating lift?
- Extension ladder?
- Hang over edge?
- All of the above require special procedures.
Know them!
22Low-slope roof - Example
- Walkway between EHS and Voc. Rehab.
23Low-slope and Steep-roof
24Protection from Falling Objects
- When an employee is exposed to falling objects,
the employer shall have each employee wear a
hard hat and shall implement one of the
following - Erect Toe boards, screens or guardrail
- Erect a canopy
- Barricade the area
251926.502 Fall protection systems
- General Requirement Fall Protection must be
provided and installed before the employee begins
the work that requires fall protection.
26Fall Protection Systems
- Guardrail systems
- Safety Net systems
- Personal fall arrest systems (PFAS)
- Positioning device systems
- Warning line systems
- Controlled access system
- Safety monitoring system
27Personal Fall Arrest System
- PFAS is a system to arrest an employee in a fall
and consists of an anchorage, connectors, body
belt or body harness and may include a lanyard,
deceleration device, lifeline, or combination of
these. - The use of a body belt for fall arrest is
prohibited!
28Personal Fall Arrest System
- Personal fall arrest systems (PFAS) and their use
shall comply with the provisions covering
Connectors Dee-rings Snaphooks Webbing
Lifelines Lanyards Ropes Anchorages etc. - Specific details pertaining to the above can be
found in 29CFR 1926.502(d).
29Personal Fall Arrest System
- The attachment point of the body harness shall be
located in the center of the wearers back near
shoulder level, or above the wearers head. - PFAS and components subjected to impact loading
shall be immediately removed from service and not
used again and until inspected by competent
person to be undamaged suitable for reuse.
30Personal Fall Arrest System
- PFAS shall be inspected prior to each use for
wear, damage and other deterioration, and
defective components shall be removed from
service. - PFAS shall not be attached to guardrails or used
to hoist materials
31Competent Person
- Construction personnel who will be responsible
for supervision on job sites where fall hazards
exist. Knows OSHA competent person requirements
for fall protection, fall hazard identification,
how to select the proper protective system and
the importance of planning for fall protection.
32Safety Monitoring System
- Safety Monitoring System is
- a safety system in which a competent person is
responsible for recognize fall hazards. - Shall warn the employee when it appears the
employee is unaware of a fall hazard or is acting
in an unsafe manner.
33Safety Monitoring System
- The Monitor
- Shall be on the same walking/working surface and
within visual sighting distance of the employee
being monitored. - Shall be close enough to communicate orally with
the employee. - Shall NOT have other responsibilities which could
take the monitors attention from the monitoring
function.
34Safety Monitoring System
- Mechanical equipment shall not be used or stored
in areas where safety monitoring systems are
being used to monitor emp. - No employee, other than an employee engaged in
roofing work on low-sloped roofs or an employee
covered by a fall protection plan, shall be
allowed in an area where an employee is being
protected by a safety monitor system.
35Safety Monitoring System
- Each employee working in a controlled access zone
shall be directed to comply promptly with fall
hazard warnings from safety monitors.
36Ladder Safety and Support Systems
- Examples of some of the locations that can be
on campus
37Ladder Safety Fall Protection
- Light Pole at Williams football stadium.
- Notice vertical wire cable
38Ladder Safety Fall Protection
- Light Pole at Williams football stadium.
- Notice vertical wire cable
39Ladder Safety Fall Protection
- Light poles east of outdoor track
40Ladder Safety Fall Protection
- Light Pole east of outdoor track
- Notice vertical wire cable
41Ladder Safety and Support Systems
- All safety devices must be capable of
withstanding, without failure, a drop test
consisting of a 500 pound weight. - All safety devices must permit the worker to
ascend or descend without continually having to
hold, push, or pull any part of the device,
leaving both hands free for climbing
42Ladder Safety and Support Systems
- All safety devices must be activated within 2
feet after a fall occurs, and limit the
descending velocity of an employee to 7
feet/second or less. - The connection between the carrier or lifeline
and the point of attachment to the body belt or
harness must not exceed 9 inches in length.
43Ladder Safety Devices
- Mountings for rigid carriers must be attached at
each end of the carrier, with intermediate
mountings, spaced along the entire length of the
carrier, to provide the necessary strength to
stop workers falls.
44Rope Grab
- Def. - Is a deceleration device which travels on
a lifeline and automatically, by friction,
engages the lifeline and locks so as to arrest
the fall of an employee. A rope grab usually
employs the principle of inertial locking,
cam/level locking, or both.
45Self-retracting lifeline/lanyard
- Def. Is a deceleration device containing a
drum-wound line which can be slowly extracted
from, or retracted onto, the drum under slight
tension during normal employee movement, and
which, after onset of a fall, automatically locks
the drum and arrests the fall.
46Steps to follow
- Determine if walking/working surfaces are
structurally safe - Conduct a fall protection hazard assessment
- Eliminate the need for fall protection if
possible - Select the appropriate type of fall protection
system
47Steps to follow
- Develop rescue retrieval procedures
- May involve calling 911
- Contact your supervisor if you have any
questions!
48Dont improvise!
49Dont take chances!
- Does this look acceptable?
- Any questions?
50Dont take chances when climbing!