AO Series 10 Illuminator pattern

1
AO Series 10 Illuminator pattern with cover.
Replaces Mirror mount.
3
4
2
2
1
1
5
5
This cover could be wider if you Have more room.
2
(No Transcript)
3
(No Transcript)
4
Cardboard mock up of full cover pattern. Cover
could be larger Than pattern shows- but I drew
tight so I could get two from the Wal Mart
cookie sheet.
Hand holding a CF ballast, and ballast mounted.
Ballast covers are removed, and the spool
flanges trimmed just bit, to fit.
5
5
2
1
AO Series 10 Illuminator Cutting patterns- One
piece base, partial cover Replaces mirror mount
in base.
3
4
1
2
5
6
Cardboard mock up w/ cover in place. Note that
tail of cover goes under fold in the back- so
offset the bend-over on the back, to allow
clearance. Cover attaches with sheet metal
screw(s) in the back, and in front, the tabs
catch the mirror mount screws.
An example of the earlier pattern cut and bent
up. Ballast can be under cover, but some
insulated wiring is exposed. Ballast should be
used with its cover.