Tray Tools, Materials

1
Tray Tools, Materials Processes
2
The Pillar Drill
The Pillar Drill can be used to drill wood,
metal, and plastic. As a general rule the larger
the hole you are trying to drill the slower the
drill should rotate.
When using this (or any other machine) it is
important to read the safety notice on the wall
to make sure you understand how to use the
machine safely.
When using the Pillar Drill you must Wear
Goggles Tie any long hair back Tuck in any loose
clothing
3
The Pillar Drill
On / Off Switch
Depth Stop
Drill Chuck Chuck Guard
Machine Vice
Chuck Key
4
Screwdriver Bit
Cordless Drill
Keyless Chuck
Forward / Reverse Switch
Adjustable Clutch
On / Off switch
The Cordless Drill can be fitted with a drill
bit (1mm to 10mm) for drilling small holes, a
Countersink bit for countersinking holes or a
Screwdriver bit for driving in screws.
Battery Pack
5
Drill Bits

• Twist Drills
• (Used for drilling wood, metal and plastic)
• 2) Reduced Shank Twist Drill
• (As above but reduced shank allows larger drill
  bits to be fitted in a chuck)
• 3) Dowel bit
• (Used to drill clean holes in wood for dowel
  joints)
• 4) Spade Bit
• (Used for drilling large holes in wood)
• 5) Masonry Bit
• (Used to drill holes in concrete)
• 6) Forstner Bit
• (Used to drill clean flat bottomed holes in
  wood. Available in a wide range of sizes 6 50mm)