Title: LMS2000 Installation
1LMS2000 Installation OperationsTraining
2Introduction
- Course Objectives
- Training to install and operate the LMS2000
system (NMS) - Introduction
- Expectations
3Training Outline
- Two days
- LMS review
- Data flow from Internet to subscriber
- Installation
- NMS functionality
- Device configuration process
- LMS Operations and Maintenance
- Future Developments
4Schedule
5Reference Material
- LMS2000 User Guide
- Abbreviations and Acronyms Appendix E
- Default configuration
- EUM Quick Reference Guide
- CD-ROM and binder containing
- Handouts
- Slide show
6SAFETY
- Common sense
- Grounding and electrical
- Regulatory notices
- Racks weigh 155 lbs
- Reference APCD-LM010-A
7LMS Overview
8LMS2000 Components
- NAP - Network Access Point
- CAP - Communications Access Point
- CCU - CAP Communications Unit
- EUM - End User Modem
- NMS - Network Management System
- Reference APCD-LM010-A Chapter 1
9Network Configuration
Reference APCD-LM010-A Chapter 1.4
10Data Flow
Reference APCD-LM010-A Chapter 1.5
11Data Routing
- Routers are connected to two or more networks
- Router have two or more IP addresses
- Routers are gateways to networks
- Routing tables provide instructions to the next
link in the network - EUM and CCU are routers
- Reference APCD-LM010-A Chapter 1.5
12Routing 1
13Routing 2
14Routing 3
15Internet - Subscriber Routing 4
16CCU-EUM Routing 5
17Two EUMs Routing 6
18Quick Reference Sheet
19Factory Defaults
- NAP
- CAP
- CCU
- EUM
- NMS
- Reference APCD-LM010-A Appendix A
20Network Configuration
Reference APCD-LM010-A Chapter 1.4
21Installing the NAP and CAP
Reference APCD-LM010-A Chapter 2
22 Pre-Install
- Site preparation
- antenna/cable install
- Lightning protection
- power
- grounding
- After unpacking check for damage
- NAP/CAP shipped wired and pre-configured with
defaults - Cables and tools
- Reference APCD-LM010-A Chapter 2
23NAP and CAP Install
- UPS
- Battery reconnect
- Turn on UPS power switch
- Three LED's indicating battery charge. Three is
fully charged. - Computer symbol (router/switch)LED green
- Verify rack/device cooling fans working
- Verify switch POST results
- Connect backhaul
- Reference APCD-LM010-A Chapter 2
24CCU Verification
- Main power light ON
- CCU should beep once after powered up
- Network Interface Card link light ON
- CCU cooling fan ON
- \Reference APCD-LM010-A
25NMS Set Up
- Set up NMS Workstation
- PC plus UPS
- Connect to NAP switch (port 2)
- Ping CAP switch from NMS workstation
- Reference APCD-LM010-A Chapter 3.1
26NMS
Reference APCD-LM010-A Chapter 3
27NMS Functionality
- Controls and manages the LMS2000 System
- GUI interface
- SNMP
- Authentication and security
- Bandwidth management functionality
- Backup
- UPS
- Reference APCD-LM010-A Chapter 3.1
28NMS Workstation Components
- PC
- Microsoft Windows NT 4.0 SP6a
- WaveRider LMS2000 NMS Software
- Microsoft SQL Server 7.0
- Vircom VOP RADIUS Server
- Castlerock SNMPc 5.0
- Veritas Backup Exec 8.0
- UPS
- Reference APCD-LM010-A Chapter 3.1
29NMS Tour
- Checklist of features and icons
- Reference APCD-LM010-A Chapter 3
30NMS Tree
- Philosophy
- Associations
- Linking
- NMS Tree
- System
- Inventory
- Devices
- Accounts
- Subscribers
- Service Levels
- Reference APCD-LM010-A Chapter 3.1
31RADIUS Server
32RADIUS Server 2
33Bandwidth Management Functionality
- Based upon service levels associated by
subscriber - Controls bandwidth EUMs can utilize
- Controlled by NAP router
34SNMPc
- Tool
- Alerts
- Device statistics
- Trends
- Reporting
- Device and system monitoring
- www.castlerock.com
- Reference APCD-LM010-A Chapter 4
35SNMPc Server Configuration
- Configure SNMPc Server
- Password, adding/discovering devices
- Add SNMP Communities
- Network Map
- Remember to update the SNMPc
- Reference APCD-LM010-A Chapter 4.2
36Device and System Configuration
Reference APCD-LM010-A Chapter 5 6
37Component Configuration
- Out of the box defaults
- Configuration procedure
- Make changes then
- Apply
- Connect
- Update
- Disconnect
- Link to
38NAP Configuration
- Confirm/change
- Router/switch/UPS IPs and Destination Netmask
- Device
- Trap server
- Configuration Process
- Create CCU in inventory as required
- Apply, connect, update, disconnect
- Link to
- Reference APCD-LM010-A Chapter 5.1
39CAP Configuration
- Verify Switch/UPS defaults
- Configuration Process
- Apply, connect, update, disconnect
- Link to
- Reference APCD-LM010-A Chapter 5.2
40CCU Configuration
- 2 or 4 CCUs in a CAP
- Default configuration
- Radio/Ethernet IP Addresses
- SNMP/RADIUS
- Routing
- Password
- Reference APCD-LM010-A Chapter 6
41EUM Configuration
- Determine deployment details
- Add and edit EUM properties in database
- Enable Radio
- Update EUM device properties
- Link to
- CCU
- Subscriber
- Service Level
- Deploy
- Reference APCD-LM010-A Chapter 6
42EUM Configuration 2
- Connect to NAP/CAP switch
- Confirm/Change
- Radio/Ethernet Parameters
- IP Routing
- SNMP
- Subscriber
- Update device configuration
- Change Ethernet IP address from default to
subscriber - Reference APCD-LM010-A Chapter 7
43EUM Configuration 3
- Save configuration to file
- Create association with CCU
- Add EUM to CCU Configuration (IP Route, EUM ID
and IP) - Add EUM route to NAP Router
- ENABLE RADIO
- Now ready for deployment
- Reference APCD-LM010-A Chapter 7
44Deploy EUM
- Install/mount EUM in destination location
- Attach antenna or 50 Ohm terminator
- RADIO ENABLED
- Reference APCD-LM010-A Chapter 7.11
45Device and System Testing
- Test connectivity
- NAP/Internet
- NAP/CAP
- NAP/EUM
- EUM tests
- Continuous receive
- Continuous transmit
- Loopback
- Reference APCD-LM010-A Chapter 8
46Dont Forget
- Linking
- Accounts
- Subscribers
- Service levels
- Inventory
- Apply
- Connect
- Update
- Security (passwords)
47Install Review
- Follow installation instructions
- If youre not sure call WaveRider support
- SNMPc set up
- Configure steps
- Apply
- Connect
- Update
- Link to
- Dont forget security/change the passwords
48Install Quiz
- Add/Configure CCU2 with EUM201. EUM Ethernet IP
249.249.140.250 - Enable an Account, Service Level Nickel 800 KBPS,
Subscriber (your company)
49Operations
Reference APCD-LM010-A
50Customer Management
- Accounts management
- Entering/Disabling/Enabling an Account
- Subscriber management
- Adding/Disabling/Enabling/and Removing an EUM
from a subscriber - Deleting a subscriber
- Service levels
- Defining,Linking, Deleting
- Reference APCD-LM010-A
51Monitoring
- Forewarning
- Preventative maintenance
- Use SNMPc
- Alerts/Statistics for
- NAP router
- CAP/NAP switch
- CCU/EUM
- UPS
- Backhaul
- Reference APCD-LM010-A Chapter 10
52Operational Statistics
- Diagnostics Tab / Radio PER
- Statistics Tab
- CCU/EUM Version
- Network IP
- SNMPc Trends
- Reference APCD-LM010-A Chapter 10
53Reports
- Accounts
- Service Level
- CCU/EUM Version
- Network IP
- SNMPc Trends
- Reference APCD-LM010-A Chapter 11
54Logs
- RADIUS Server
- Microsoft NT Server event log and statistics
- Reference APCD-LM010-A Chapter 103 10.4
55Backups
- Veritas Backup Exec 8.0
- Think about your backup plan
- Optional
- SQL module permits live database backup
- Reference APCD-LM010-A Chapter 9
56LMS Maintenance
Reference APCD-LM010-A Chapter 12
57Maintenance
- General maintenance
- environment
- cleaning
- cooling fans (racks, devices)
- Power outages
- Confirm UPS battery health
- Hardware (cables)
- Reference APCD-LM010-A Chapter 12
58NMS Maintenance
- PC
- Microsoft Windows NT
- NT event log (size)
- Web reports cleanup (size)
- Log files (size)
- SQL database (auto-scheduled)
- Reference APCD-LM010-A Chapter 12
59Power Outages
- EUM auto-recovery
- NAP auto-recovery
- CAP and CCUs auto-recovery
- NMS will require intervention
- Reference APCD-LM010-A Chapter 12.2
60Firmware Updates
- Update the EUMs first then CCUs
- Configuration through
- FTP
- Telnet
- Synchronize configuration with NMS database
- Reboot will be required when
- updating firmware using FTP
- updating LMS or third party software
- Reboot will be required via Telnet
- Reference APCD-LM010-A Chapter 14
61Troubleshooting
- Install problems
- Connectivity problems see LMS User Guide
Chapter15 - Dont forget to use SNMPc
- Check you cables
- Ethernet
- RF
- Reference APCD-LM010-A Chapter 15
62Operations and Maintenance Review
- Customer management
- System management
- Beware - report and log size!
- Trends and statistics
- Backups
- Maintenance
- Power outages
- Auto-recovery
- Reference APCD-LM010-A Chapters 10,11,12
63Operations Quiz
- Conduct a scheduled tape backup of
SNMPc5.0\backup. Restore to C\temp - Add CAP2 and CCU1. Update SNMPc
- Change subscriber for EUM102
- Change
- Service level
- Subscriber
- Account
- Ethernet IP
64Future Developments
65Future Developments
- DHCP Relay
- RFSM (redundant CCU)
- RIP Routing (CCU/EUM)
- Improved Receive Sensitivity (CCU/EUM)
- EUM Capacity (20 -gt30)
- Advanced Bandwidth Management
- RSSI EUMs will have a direct read out of the
Receive Signal Strength - Time of Day based policies
66Q4 Developments
- Q4 Feature Releases
- Higher CCU/EUM Output Power
- Polling MAC
- Advanced Billing Support
- Usage (data transferred)
- Data Rate
- Time-of-Day
67Course Review?