IETF-68, IETF ECRIT / IEEE Joint Meeting1 - PowerPoint PPT Presentation

1 / 10
About This Presentation
Title:

IETF-68, IETF ECRIT / IEEE Joint Meeting1

Description:

Various updates on LLDP (IEEE 802.1AB) and LLDP-MED (ANSI/TIA-1057) Peter Blatherwick Dan Romascanu IETF-68, IETF ECRIT / IEEE Joint Meeting Caveat This is not a ... – PowerPoint PPT presentation

Number of Views:67
Avg rating:3.0/5.0
Slides: 11
Provided by: ava86
Learn more at: http://www.ietf.org
Category:
Tags: ecrit | ieee | ietf | joint | meeting1

less

Transcript and Presenter's Notes

Title: IETF-68, IETF ECRIT / IEEE Joint Meeting1


1
Various updates on LLDP (IEEE 802.1AB) and
LLDP-MED (ANSI/TIA-1057)
  • Peter Blatherwick
  • Dan Romascanu
  • IETF-68, IETF ECRIT / IEEE Joint Meeting

2
Caveat
  • This is not a formal liaison or anything like it
  • Peter Blatherwick just a guy who happens to be
    Editor of LLDP-MED (ANSI/TIA-1057)
  • Dan Romascanu just a guy who happens to attend
    IEEE 802.1

3
TIA TR-41.4 Status, LLDP-MED ECS
  • ANSI/TIA-1057, Link Layer Discovery Protocol for
    Media Endpoint Devices (LLDP-MED)
  • Provides VoIP extensions to IEEE 802.1AB LLDP,
    including endpoint location (and lots more)
  • Published April 2006
  • No currently active project in TR-41.4
  • TSB-146-A, IP Telephony Support for Emergency
    Calling Service (2nd revision)
  • Provides informational overview and possible
    usages of relevant technologies for device
    location and other ECS needs, including LLDP-MED,
    DHCP-based, SNMP-based, WLAN scenarios
  • Publication pending
  • TR-41.4 liaison with NENA
  • Responding to NENA requirements TRs (in progress)
    ? almost all NENA location requirements well met
    by LLDP-MED, some cannot be realistically met by
    any location method
  • Possible LLDP-MED extensions talked about (not
    committed to)
  • Ability to support location by reference and/or
    delivery of PIDF-LO objects directly
  • Ability to indicate location determination method
    used (manual, GPS, triangulated, etc)
  • Ability to indicate ECS call in progress
  • Possible relay/forwarding mechanisms to provide
    end device with LLDP-MED location, independent of
    the access network mechanism in use (could be
    DHCP, L7 LCP, network-specific / proprietary )
  • Support for device-specific location in WLAN
    environments (note LLDP-MED supports AP-specific
    location today)

4
IEEE 802.1ABrev
  • Revision of IEEE 802.1AB LLDP
  • PAR approved November 2006
  • New information elements and a mechanism for
    faster exchange of information (fast start) for
    early exchange of capabilities
  • Similar to and compatible with LLDP-MED Fast
    Start (some open questions)
  • Mainly to support layer 2 Congestion Management
    and Audio-Video Bridging
  • Can also be used to push location information
    (same as LLDP-MED today)
  • New destination addresses and explicit forwarding
    rules to accurately define the topology over
    transparent forwarding devices like the ones
    defined by IEEE 802.1ad (provider bridges) and
    802.1aj (two-port media relays TPMR)
  • Breaks the original assumption that all LLDP
    devices are connected on the same media (LLDP-MED
    would remain single L2 link-specific)
  • Support for IEEE 802.3at (extended Power over
    Ethernet, PoE Plus)
  • Liaison with TIA TR41.4
  • see http//www.ieee802.org/1/files/public/docs2007
    /liaison-to-tr41-4-0307.txt

5
IEEE 802.3at PoE Plus
  • IEEE 802.3at to provide higher power PoE, with
    management
  • Many management needs aligned with LLDP-MED
    Extended Power via MDI TLV (aka Extended PoE
    TLV)
  • High synergy, since wired Ethernet IP Phones and
    other VoIP endpoints are a large category of
    devices, almost all using PoE
  • LLDP-MED Extended PoE TLV accepted as basis for
    PoE management
  • 3 proposals at March IEEE 802.3 plenary, all use
    LLDP-MED data content (unclear which accepted
    meeting was just last week)

6
Some questions / issues for discussion
  • Can IEEE 802.11 / .16 and others use LLDP-MED as
    the method for location acquisition in WLAN
    environments ??
  • IETF ECRIT currently references LLDP-MED as the
    single method for location acquisition at Layer 2
    (of 3 methods total)
  • Yet another method at Layer 2 would be confusing,
    wasteful, and add complexity (bad)
  • Requirements
  • Requesting location (vs continuous update)
  • What are the specific IEEE groups to work with on
    these topics?

7
  • Backup Material

8
Background
  • TIA TR-41.4
  • Engineering subcommittee in TIA, mandate for User
    Premises Telecommunications Requirements / IP
    Telephony Infrastructures
  • LLDP-MED (ANSI/TIA-1057)
  • VoIP-specific set of extensions to LLDP (IEEE
    802.1AB), created by TR-41.4
  • Leverages LLDPs excellent extensibility
    properties
  • Defines several new TLVs (Type-Length-Value) for
  • LAN Policy (Diffserv, Layer 2 Priority, VLAN)
  • Location Identification (IETF compatible civic
    and geo location, plus ELIN)
  • Extended Power Over Ethernet
  • Inventory management
  • Also defines some new protocol behaviour (Fast
    Start) and a few constrains on base LLDP

9
How LLDP / LLDP-MED Works (10,000 m view)
  • Very simple / robust
  • Simple one-way periodic advertisement, no
    Ack/Nak, command/response, etc.
  • Frames contain formatted records (TLVs)
  • Simple time-to-live mechanism for data aging
  • Fast Start protocol mechanism speeds startup
    and initial autoconfiguration
  • Data containers defined by local and remote MIBs
    (SNMP is not mandatory)
  • Small number of mandatory TLVs, several optional
    TLVs are defined
  • Efficient and secure
  • Transmissions contained to individual L2 links
    (not broadcast)
  • Runs after 802.1X authentication, preventing
    unauthorized access to VoIP network
  • Highly extensible
  • Easily defined Organization Specific TLVs (e.g.
    TIA, vendor-specific, etc)
  • Very clear methods to define agreed data formats
    (local and remote MIB extensions)

10
LLDP-MED Content
Write a Comment
User Comments (0)
About PowerShow.com