SEALING the ENGINE - PowerPoint PPT Presentation

1 / 14
About This Presentation
Title:

SEALING the ENGINE

Description:

Explain process of repairing cracks by welding. ... Improper torquing Corrosion CRACK DETECTION Visual Inspection Magnetic Particle Inspection (MPI) ... – PowerPoint PPT presentation

Number of Views:75
Avg rating:3.0/5.0
Slides: 15
Provided by: rickk9
Category:

less

Transcript and Presenter's Notes

Title: SEALING the ENGINE


1
SEALING the ENGINE
  • Chapter 5
  • Classroom Manual
  • Page95
  • Lab Manual
  • Page 113

CBC AUTOMOTIVE RK
2
OBJECTIVES
  • Locate cracks in castings.
  • Explain process of repairing cracks by welding.
  • Properly install common engine gaskets including
    cyl. head valve cover gaskets.
  • Properly install typical lip seals.
  • Extract broken fasteners.
  • Perform thread repair.

CBC AUTOMOTIVE RK
Page 113
3
INTRODUCTION
  • Cracked castings - Repair or Replace?
  • Other causes of leakage,
  • Worn or damaged seals
  • Gaskets
  • Threaded holes can be damaged from,
  • Improper torquing
  • Corrosion

CBC AUTOMOTIVE RK
Page 113
4
CRACK DETECTION
  • Visual Inspection
  • Magnetic Particle Inspection (MPI)
  • Magnetic Fluorescent
  • Spray Penetrant Dye
  • Pressure Testing
  • On-car
  • Off-car

CBC AUTOMOTIVE RK
Page 114
5
CRACK REPAIR
  • Pinning Cracks
  • Welding Cracks
  • Chemical Crack Repair
  • Ceramic block sealers
  • Epoxy

CBC AUTOMOTIVE RK
Page 115
6
GASKET INSTALLATION
  • Follow instructions.
  • Thoroughly clean the mating surface.
  • Match to old gasket.
  • Check for proper fit.
  • Never reuse gaskets.

CBC AUTOMOTIVE RK
Page 118
7
CYLINDER HEAD GASKET
  • Must be capable of withstanding tremendous heat
    and pressure.
  • Follow gasket makers instructions on whether or
    not to use sealant.
  • What type of sealant and how much?
  • Run thread chaser in bolt holes.

CBC AUTOMOTIVE RK
Page 119
8
USING STRAIGHTEDGE
CBC AUTOMOTIVE RK
9
VALVE COVER GASKETS
  • Check cover flanges for straightness.
  • Use load spreaders when available.
  • Use sealants only when necessary and not to much.
    See P5-8

CBC AUTOMOTIVE RK
Page 120
10
SEAL INSTALLATION
  • Install with lip (and garter spring) toward
    liquid.
  • Lubricate lip before installation.
  • Use sealant on the outside of steel seals.
  • Use a seal installer.

CBC AUTOMOTIVE RK
Page 122
11
USING SEALANTS
  • Use proper sealant for application.
  • Do not use sealants unless specified in service
    manual or by gasket manufacturer.
  • Types of sealants
  • Hard drying
  • Aerobic (RTV)
  • Anaerobic

CBC AUTOMOTIVE RK
Page 122
12
FASTENERS
  • ID fasteners by
  • Nominal diameter
  • Pitch (Threads per Inch)
  • Length
  • Strength

CBC AUTOMOTIVE RK
13
THREAD REPAIR
  • See Handout

CBC AUTOMOTIVE RK
14
THREAD REPAIR
  • See Handout

CBC AUTOMOTIVE RK
Write a Comment
User Comments (0)
About PowerShow.com