Schionning Designs

1
Schionning Designs
Wilderness Assembly Demonstration
2
Step 1
Join Kit Panels Together
Lay panels between two 75 x 50 timber cleats.
Screw through for clamping.
Scarf Joint. Glue with microfibre blend
The long edges of the 2400 1200 sheets are
prescarfed. Lay out the sheets on a flat surface.
Glue the scarf joins with Microfibre Blend. Cut
through the tabs with a jig saw to remove the
pieces once joined.
Flat surface
Duflex Panel
19mm Duflex Panel
22mm Scarf / Z Join.
3
Step 2
Bulkheads and Temporary Frames stood-up and ready
for Hull Panels
Temporary Frame
Bulkheads
Strongback
4
Step 3
Hulls fitted to bulkheads starting from the
bottom of the hull.
Temporary Frame
Hull Panels
Strongback
5
Step 4
Hulls panels being glued directly to the
bulkheads.
Hull Panels.
Temporary Frame
Bulkheads.
Strongback
6
Step 5
Separate hulls are easily turned without cranes
etc. Now you are ready to set up in preparation
for joining main bulkheads.
Hull Panels.
Main Bulkheads not joined
Main Bulkheads not joined.
7
Step 6
Insert the middle part of the main Bulkheads.
This also helps determine set-up width.
Middle piece of main Bulkhead.
Hull Panels.
8
Step 7
The Bridgedeck panel is lifted into position.
Hull Panels.
Main Bulkheads.
Bridgedeck Panel.
9
Step 8
The rounded Nose Cone is installed finishing
off the front of the bridgedeck. The composite
forebeam and catwalk are also installed at this
stage.
Main Bulkheads
Bridgedeck Panel
Hull Panels.
10
Step 9
It is recommended to install your furniture kit
at this stage, even fairing and planking can be
done, making it far easier.
Main Bulkheads
Cockpit Furniture
Furniture Kit
Bridgedeck Panel
Catwalk
Nose Cone
Composite Forebeam
Hull Panels
11
Step 10
All decks are installed, next the cabin front and
sides are installed followed by the saloon top.
Saloon Top
Cockpit Furniture
Cabin Sides
Flat Decks
Nose Cone
Catwalk
Forward Strip Planked Decks
Hull Panels
Composite Forebeam