S-72.245 Transmission Methods in Telecommunication Systems (4 cr) - PowerPoint PPT Presentation

About This Presentation
Title:

S-72.245 Transmission Methods in Telecommunication Systems (4 cr)

Description:

In the Costas PLL (below) two phase discriminators are used to: ... Costas PLL detector. for DSB. PD: phase detector (=multiply LPF) Loop drives phase. error to zero ... – PowerPoint PPT presentation

Number of Views:26
Avg rating:3.0/5.0
Slides: 15
Provided by: TKO54
Category:

less

Transcript and Presenter's Notes

Title: S-72.245 Transmission Methods in Telecommunication Systems (4 cr)


1
S-72.245 Transmission Methods in
Telecommunication Systems (4 cr)
  • Review

2
25
3
(No Transcript)
4
(No Transcript)
5
(No Transcript)
6
PLL based frequency synthesizer
Reference signal fin is locked for instance to
the fundamental frequency of a crystal oscillator
By adjusting the divider different frequencies
can be produced whose phase is locked into fin
7
Detecting DSB using PLL-principle
  • An important application for PLLs is in
    synchronization of receiver local oscillator in
    synchronous detection
  • In the Costas PLL (below) two phase
    discriminators are used to
  • cancel out DSB modulation x(t) in the driving
    signal
  • synchronize the output frequency to the center
    frequency of the DSB spectra (the suppressed
    carrier)
  • to detect the DSB signal

PD phase detector (multiplyLPF)
Costas PLL detector for DSB
LPF yields constant (zero) output when loop is
locked to carrier
Loop drives phase error to zero
8
PAM Power Spectral Density (PSD)
  • PSD for PAM can be determined by using a general
    expression
  • For uncorrelated message bitsand
    thereforeon the other hand
    and

Amplitude autocorrelation
Total power
DC power
9
PAM Power Spectral Density (PSD)
  • PSD for PAM can be determined by using a general
    expression
  • For uncorrelated message bitsand
    thereforeon the other hand
    and

Amplitude autocorrelation
Total power
DC power
10
Example
  • For unipolar binary RZ signal
  • Assume source bits are equally alike and
    independent, thus

11
Equalization Removing Residual ISI
  • Consider a tapped delay line equalizer with
  • Search for the tap gains cN such that the output
    equals zero at sample intervals D except at the
    decision instant when it should be unity. The
    output is (think for instance paths c-N, cN or
    c0)that is sampled at
    yielding

12
Tapped Delay Line Matrix Representation
  • At the instant of decision
  • That leads into (2N1)x(2N1) matrix where (2N1)
    tap coefficients can be solved

13
Example of Equalization
  • Read the distorted pulse values into matrix from
    fig. (a)and the solution is

Question what does thesezeros help because they
dont exist at the sampling instant?
Zero forced values
14
Monitoring Transmission Quality by Eye Diagram
Required minimum bandwidth isNyqvists
sampling theorem
Given an ideal LPF with the bandwidth B it is
possible to transmit independent symbols at the
rate
Write a Comment
User Comments (0)
About PowerShow.com