200-301 VOL1 Question

1

• 200-301 Cisco Certified Network Associate (CCNA)
  VOL1
• QUESTION NO 1
• In wireless networking, what are the three main
  802.11 frame types?
• Control
• Data
• Version
• Management
• Beacon
• Answer A, B, D

• QUESTION NO 2
• A Computer at a remote site sends a packet to a
  server located at a Corporate Data Center with a
  destination IP address of 226.1.5.10. What is the
  most likely type of traffic that is being used
  here?
• Traffic sent to the corporate email server to
  retrieve emails
• Traffic sent to an FTP server to retrieve a file
• Traffic sent to a conferencing server to
  participate in a companywide video conference.
• Traffic sent to a telephony server so that a
  voice call can be made using a calling
  application.
• Answer C

• QUESTION NO 3
• A network Engineer has just configured a new
  floating static route on router R1 to be used as
  a backup route to a remote router R2. After
  making this change, traffic begins taking this
  new route. What could be a cause for this?
• This is the expected behaviour, when a floating
  static route is configured traffic will
  temporarily sent across the newly configured
  link.
• The floating static route was incorrectly
  configured with an administrative distance that
  was too low.
• The floating static route was incorrectly
  configured with an administrative distance that
  was too high.
• The floating static route is using a next-hop IP
  address that is unreachable.
• Answer B

2

• QUESTION NO 4
• In a small EIGRP network, routers R1 and R2 are
  EIGRP neighbors and have been configured with
  default values. R1 and R2 are connected via two
  different 100 MB links. What must be configured
  on these two routers for traffic to load balance
  over these two links?
• R1 and R2 must have variance configured the EIGRP
  process.
• Variance must be configured on router R1 only.
• EIGRP load balancing must be enabled under the
  EIGRP process of routers R1 and R2.
• Nothing needs to be configured, the traffic will
  load balance automatically.
• Answer D

• QUESTION NO 5
• A new network administrator has just been hired
  to manage an existing multi-vendor network
  consisting of numerous devices. There is
  currently no network documentation, and he has
  been tasked with getting a better understanding
  of the physical topology of this network. Which
  protocol should the network administrator enable
  to gain visibility into the physical connections
  that are used be-tween these network devices?
• LLDP
• CDP
• BFD
• STP
• Answer A

QUESTION NO 6 You need to design an IP
addressing scheme for a new network that should
be routable internally only, and not be
reachable from the Internet. The network consists
of one flat network, and should accommodate up
to 150 hosts. Wasting of IP addresses should be
avoided. Which of the following would be the
best subnet to use? A. 11.1.1.0/24 B.
192.168.1.0/25 C. 172.30.1.0/24 D.
172.33.1.0/24 Answer C
3

• QUESTION NO 7
• Which of the following are the core components of
  an 802.1x architecture? (Choose three)
• Authenticator
• Supplicant
• Wireless Lan Controller
• Authentication server
• LDAP server
• Answer A, B, D

• QUESTION NO 8
• A new Wireless LAN Controller was just purchased
  and you need to connect to the console to begin
  the initial configuration. What are the terminal
  emulator settings that should be used for this
  connec-tion?
• A.
• 9600 baud
• 8 data bits
• 1 stop bit
• No parity
• No hardware flow control
• B.
• 9600 baud
• 16 data bits
• no stop bit
• No parity
• No hardware flow control
• C.
• 19200 baud
• 8 data bits
• no stop bit
• parity

4

• No parity
• hardware flow control
• Answer A
• Reference https//www.cisco.com/c/en/us/support/d
  ocs/wireless/4400-series-wireless-lan-
  controllers/69719-wlc-lwap-config.html

QUESTION NO 9 Refer to the following network

• Host PC1 is unable to ping Server 1. Traceroutes
  show that the packets are load balanced to
  Router 3 and Router 4 before timing out. What is
  the most like reason for this?
• PC1 has an incorrect default gateway set.
• Load balancing between Router 2 and routers
  Router 3 and Router 4 are causing issues.
• Server 1 has an incorrect default gateway set.
• Router 2 is blocking ICMP via an ACL.
• Answer C

5
QUESTION NO 10 Refer to the following network

• Regarding traffic between PC1 and Server 1 in
  this network, between which two devices is a 32-
  bit header added to the packet between the layer
  2 header and the IP packet?
• Between Router 1 and Router 2
• Between Switch 2 and Routers 3 and 4.
• Between Switch 3 and Server 1.
• Between Switch 1 and Router 1.
• Answer A

QUESTION NO 11 A network administrator performs
the following on router R1 R1 configure
terminal Enter configuration commands, one per
line. End with CNTL/Z. R1(config) interface gig
0/0 R1(config-if) switchport R1(config-if)
switchport mode trunk
6

• R1(config-if) switchport port-security
• Based on this, what will be the resulting
  violation mode when the show port-security
  command
• is issued for this interface?
• Protect
• Restrict
• Shutdown
• On
• Answer C

QUESTION NO 12 The login password for a router
has been forgotten and needs to be reset. Which
configuration register value must be set in the
router in order to cause the router to boot up
without requiring a password? A. 0x2102 B.
0x2042 C. 0x2242 D. 0x2142 Answer D

• QUESTION NO 13
• An engineer needs to configure router R1 to send
  log messages of severity level notifications and
  lower syslog server at 10.22.22.55. How can this
  be achieved?
• A. R1(config) logging 10.22.22.55/24
  R1(config) logging level 4
• R1(config) logging 10.22.22.55 R1(config)
  logging trap 5
• R1(config) logging 10.22.22.55 R1(config)
  logging level 5
• R1(config) logging 10.22.22.55 R1(config)
  logging trap 4
• Answer B

QUESTION NO 14
7

• Which of the following describe the valid port
  states in the operation of the 802.1D protocol?
• Disabled, Discarding, Learning, Forwarding
• Disabled, Blocking, Listening, Learning,
  Forwarding
• Discarding, Learning, Forwarding
• Enabled, Blocking, Listening, Learning,
  Forwarding
• Answer B

• QUESTION NO 15
• Which of the following are the three components
  of the Three-tier Hierarchical Networking Model
  used in the classical Cisco networks design?
  (Choose three)
• Distribution
• Core
• Spoke
• Access
• Leaf
• Spoke
• Answer A, B, D

• QUESTION NO 16
• Within the Cisco Wireless LAN Controller and
  lightweight AP QoS configuration profile, which
  level should be selected for voice over wireless?
• Platinum
• Bronze
• Gold
• Silver
• Answer A

• QUESTION NO 17
• In IPv4, the Address Resolution Protocol (ARP) is
  used to find the layer 2 MAC address associated
  with a layer 3 IP address. How is this same
  functionality done in IPv6?
• IPv6 ARP
• Link Local addressing
• Anycast addressing

8
D. Neighbor Discovery Protocol Answer D
QUESTION NO 18 While configuring a router, you
accidentally mistype a command and the following
happens
R1conffig
Translating "conffig"...domain server
(255.255.255.255)
Unknown command or computer name, or unable to
find computer address

• You want to avoid this behavior, but dont have a
  valid DNS server that can be used to resolve
• host names to IP addresses. What should be
  configured to do this?
• R1(config)no ip domain-lookup
• R1(config)domain-lookup disable
• R1(config)ip domain-name none
• R1(config)no dns-lookup
• Answer A

• QUESTION NO 19
• What benefit does the Simultaneous Authentication
  of Equals (SAE) perform in the WPA3
  authentication method?
• SAE adds a step to a password connection that
  makes it impossible for brute force attackers to
  expose the password
• SAE creates an encryption algorithm for the
  password during transit of the data
• SAE negotiates with the server and jumbles up a
  password so that brute force attackers cannot
  figure it out.
• SAE uses CCM 192-bit encryption to encrypt
  passphrase during the data transit
• Answer A

• QUESTION NO 20
• Which of the following are First Hop Redundancy
  protocols based on industry standards and work
  in a multi-vendor network environment? (Choose
  all that apply)
• HSRP
• GLBP

9

• VRRP
• PVSTP
• Answer B, C