5 Tips To Choose Best Industrial Piping Solutions

1
5 Tips To Choose Best Industrial Piping Solutions

• Zentech Systems Solutions
• Top Air Compressor Supplier in East India

2
Introduction

• Choosing the right industrial piping solutions
  for a business is the most crucial decision that
  needs to be taken.
• Wrong or improper piping systems can bring about
  many adversities, resulting in huge losses for
  businesses.
• In the scenario of the compressed air piping
  setup not being done well, the overall energy
  costs will soar up.

3
Choosing The Right Piping Material

• Compressed air piping comes in a variety of
  options, like galvanised, aluminium, plastic
  (PVC), stainless steel, copper, PPCH and black
  iron.
• Galvanised Pipes are primarily common, as
  galvanising coating increases service span and
  provides a certain level of rust resistance.
• Both aluminium and copper are corrosion-resistant
  and lightweight.
• Plastic pipes also degrade over time and become
  brittle, increasing the possibilities of leaks or
  explosions as they age.

4
PPCH Technology

• This innovative technology of PPCH FR V2
  pneumatic pipes and fittings is the ultimate
  replacement for all kinds of compressed air
  application.
• Energy saving product PPCH has Lowest RA value
  and High Flow Coefficient C compared to
  competitors.
• UV Resistant
• Flame retardant
• Leak-proof
• Corrosion free

5
Choosing The Right Piping Size

• To avoid excessive fluctuations in air pressure,
  the two most important aspects of the compressed
  air system are Total airflow (CFM) and Minimum
  required operating pressure (PSI).
• When the pipes are too small, the distance the
  air has to travel is longer, experiencing more
  friction which ultimately slows down the air
  even more.
• Larger pipes have the capacity to store more air
  though its not the most effective way to store
  air.
• Its more cost-efficient to just buy more or
  larger air receiver tanks.

6
Making Efficient Piping Layout

• The most complex challenges that come up in the
  process of designing a compressed air piping
  system are sharp angles, obstructions and
  moisture.
• Any sharp angle in the piping system is
  guaranteed to slow down the airflow, reducing
  pressure.
• Hence, it is advisable to go for smoother corners
  ranging from 30-45 degrees.
• To deal with this unavoidable phenomenon, dryers
  and coolers can be installed to reduce the
  percentage of water content in the compressed air
  before it enters the piping system.

7
Install Drip Legs

• A drip leg is a piece of attachment that allows
  the condensed water to escape from the pipe,
  which compressors squeeze out of the air without
  doing any damage to your equipment.
• A drip leg is very easy to set up, and it is
  strongly recommended even if a dryer is already
  present.

8
Install Ball Valves Unions

• There can be damages or breaks in any system part
  or component, requiring urgent changes or
  repairs.
• One should always install a ball valve, either
  before or after all major components to
  facilitate easy repairments.
• Installing a union before or after all major
  components as well as between pipes is
  recommended.

9
Zentech offers best compressor installation
services and accessories that suit the
requirement of several air fitting equipments in
various specifications.
10
Thanks!

• Contact us
• Zentech Systems Pvt Ltd
• BMC - Block F, Hatiara Majher Para, Near Chhai
  Factory, Kolkata - 700157
• Email cf_at_crescentfoundry.in