Replacement Hot Tub Spa Control System Complete

1
Replacement Hot Tub Spa Control System Complete

• -By Hot Tub Parts FD

2
Replace your old spa control system 

• Are you looking for a circuit board or topside
  controller for your hot tub but finding them
  pricey and difficult to find?
• Replace your old spa control system with a new
  one instead of throwing it away and taking it to
  the landfill.
• For someone with ordinary mechanical abilities,
  installation is straightforward. The cost of
  replacing worn-out equipment components might be
  thousands of dollars less. 

3
Control system Know about It 

• The hot tub's brain is the spa pack or control
  system. This central nervous system controls spa
  operations and equipment, including the spa jet
  pumps, filtration time, and heating.
• Electronic, digital control systems and
  mechanical air controls are the two main controls
  utilized in hot tubs.

4

• Digital System - Solid-state computer-controlled
  systems are known as digital controllers. Onboard
  diagnostics and advanced filtering cycles are
  both supported by the circuit board. Using the
  control keypad on top of the spa, you may talk to
  your control pack. Error Codes will be shown if
  there are any problems.
• Air System - A puff of air is used to activate or
  deactivate a function in non-digital air systems.
  In the 1970s and 1990s, the early tubs employed
  pneumatic switch controls. Even if they are still
  accessible, most air systems have been replaced
  with digital controls. Digital controls are a
  great option if your tub has an outdated air
  system.

5
Options for a Control System

• Types of the heater- 
• Knowing what kind of heater it currently has is
  crucial when it comes time to repair your spa's
  control system. High Flow and Low Flow heaters
  are the two most common kinds of heaters.
• With your new spa control system, you will get a
  new heater. To ensure the safety of your new
  system, the piping and current pumps must be
  compatible with the new pack.

6

• A crucial part of components- 
• Digital or air controls have been picked, and the
  heater type has been chosen, so now you're ready
  to begin.
• Determine how many pumps and other circuits your
  tub will require as the next step in the wiring
  process.
• Follow each connection from the control system to
  its corresponding component to figure out what's
  in your tub. Make a note of the voltage on each
  data label after you've located it on the circuit
  board.

7

• It's time for the Installation and Setup process-
• Here is a broad summary of the procedures needed
  in installing a control system.
• The panel for accessing the spa's equipment may
  be opened.
• Ensure that all equipment is disconnected from
  the incoming power supply.
• It's time to get the hot tub out.
• Remove the spa control system's electrical and
  component cables (pump, blower, et cetera.).
• Remove and disconnect the controller from the
  topside.

8

• Silicone sealant or double-sided tape is used to
  connect most topsides. Fishing lines or dental
  floss may be used to access the tub's shell and
  topside.
• Remove the heater's piping.
• Removing the system's controls
• An evaluation of pumps and components should be
  made. Decide whether or not they can be reused or
  if you'll need to buy new ones.

9
To conclude- 

• To get expert advice, you may contact Hot tub
  Parts (Factory Direct) by calling them or
  visiting website to explore more. For more
  information about Spa Control System visit Hot
  tub parts FD.

10
Contact us

• Address 4 Sycamore Way
• Branford, CT 06405
• Tel [phone]
• Visit our website for more information
  https//www.hottubpartsfd.com/zencart/index.php

11
Thank you