Having Asphalt Shingle Roofing

1
Having Asphalt Shingle Roofing

• Being a starter, strip by cutting the tabs off a
  roof shingles with a roofing blade. After that
  cut 6 inches off one end. Positioning the trimmed
  roof shingles on the roof with the cut edges
  overlapping the rake (edge) and eave (bottom by
  1/2 to 3/4 inch. Nail the roof shingles on the
  roof with 4 galvanized roofing nails, located 3
  to 4 inches from the eaves. Cut the tabs off one
  more shingle and placed the full size on the
  roof. Butt it against the first shingle and also
  accomplish in place with galvanized roofing nails
  spaced 12 inches apart. Continue cutting and also
  setting up along the roof till you have installed
  the starter strip from one side to the other.
• Put a shingle on the roof to make sure that the
  reduced edge overlaps the cutter apron at the
  eaves no more than 3/4 inch. Measure from the
  side for the roof to the top of the roof shingles
  and also snap a chalk line this distance from the
  side along the whole roof. Do not make use of red
  chalk because red pigment will stain roofing
  material. Apply the first shingle of the initial
  program. Begin at the side as well as start with
  a full roof shingles. Position the roof shingles
  to overhang the eaves and also rake edges by 3/4
  inches. Toenail the tile in position with 4
  nails.

2
(No Transcript)
3

• As soon as the very first Asphalt Roofing gets
  on, relocate to the first roof shingles of the
  second course. This aids straighten the shingles
  correctly and implies you do not need to move
  across the roof for every shingle. Cut 6 inches
  off completion of a roof shingles. Align the
  bottom edge of the shingle with the top of the
  cutouts in the initial shingle. Nail it in place
  according to the supplier's directions. With 2
  shingles in position, begin the 3rd training
  course. Cut 12 inches off the end of a shingle.
  Line up the edge with the side of the roof, and
  line up all-time low with the top of the
  intermediaries in the tile listed below. Nail in
  place continue up the roof to the sixth program,
  trimming each shingle to be 6 inches narrower
  than the one below it. After the 6th course, you
  will apply a complete length roof shingles along
  the edge of the roof.
• Return the lower edge of the roof to reach the
  space next to the 1st shingle you set up. Butt a
  full-length tile alongside it and accomplish in
  place. Function your means up the roof, nailing a
  solitary unabridged roof shingles next tot each
  of the shingles already in position. After you've
  completed the 6th program, nail a full-length
  roof shingles in position to start the seventh
  course. Step and also snap a chalk line
  throughout the leading to make certain that the
  row is straight. Break a line every seven rows to
  make sure that you can remedy any mistakes before
  they get also serious. Continue functioning
  diagonally up as well as throughout the roof. All
  the shingles are full -size, except those
  shingles so that each is 6 inches narrower than
  the one listed below. When the rake tile is just
  6 inches wide, start the pattern over, using a
  complete roof shingles above it.