Title: Water Tank Waterproofing
1Waterproofing Expert Old by Establishment,
Young by Technology
- Water Tank Waterproofing / Water
ReservoirsWaterproofing is a State of Art.
Waterproofing is not difficult if you the
Solution for the problem. The difficult task of
Waterproofing is to find the Source of the
Problem. Varieties of sources are present in the
market for the problem if the sources are known
for illness, but where doctors fails is to find
the source and to fix it.
Call our expert 022 2508 0101
www.raja-n-raja.com mail_at_raja-n-raja.com
2- Water Tank/Reservoirs can be classified in to
following ways
Call our expert 022 2508 0101
www.raja-n-raja.com mail_at_raja-n-raja.com
3- As said earlier Waterproofing is state of Art. We
have to choose the systems as per the
requirements. - These waterproofing could be done in two Ways
- During Construction Phase
- After construction
- We dont need to tell you which is good way,
RIGHT!! - Waterproofing during construction eliminates the
scope of error and strengthens the structure.
Providing the great benefits and overview. - Never the less also, increases the life of
Waterproofing and Structure both. - Post Construction Waterproofing is said as
Rehabilitation in other word a REPAIR. Which is
effective but not as much as DC phase. Post
Construction Waterproofing has its own limitation
of Accessibility, Cost, Aesthetic and Pragmatic
on the top it is a protection shield and not the
original structure. -
- Here, we would discuss the Waterproofing of Over
Head Waterproofing, Underground Waterproofing and
Elevated Tank Waterproofing. In earlier
conversation we already talked about
Waterproofing a Swimming Pools. - Depending on the condition of your Site you can
choose the System
Call our expert 022 2508 0101
www.raja-n-raja.com mail_at_raja-n-raja.com
4- 1.During Construction Phase Waterproofing
- (A) Over Head Water Tank / Elevated Water Tank
- i.Surface Treatment before Casting
- - Finish the surface with smoothening tools to
the mother slab with 141 Cement to Sand mortar
to RajaCreteAP mixed well. - - Post finish apply Raja BaseCoat (Acrylic
Polymer based highly flexible waterproof coating)
to DFT of 2mm to 4mm for SLAB only. - ii.Casting
- -Add Raja CreteAD (An integreal Waterproofing
Compound) which reduces the void and makes
concrete impermeable. (It is to be added to
1Litre to 100Kgs of Cement by weight) - Raja CreteAD makes any concrete impermeable if
thickness of concrete is maintained at 6 inches
with prescribed dosage. - -If thickness is maintained at less than 6
inches additional waterproofing is required. - iii.Treatment after Casting Slab Retaining
Walls - - Applying Two Coats of Raja ChemCoat (Hybrid of
PU and Acrylic polymer, highly flexible,
Impervious and Elastic with High Bonding strength
even in constant contact of Potable Water) in a
DFT of 2mm per coat.
Call our expert 022 2508 0101
www.raja-n-raja.com mail_at_raja-n-raja.com
5- (B) Underground Water Tank
- i.Surface Treatment before Casting
- - Surface has to be sound enough, in case
bleeding surface use Raja Plug and seal off the
bleeding surface and in case of porus surface use
Raja PorSeal to seal off the porus surface. - - In case of Deeper Tank, Use Shabad stoned Box
Waterproofing to lower / break the negative water
pressure. Raja TripleAction in filling the slurry
in the joints. - - Finish the surface with smoothening tools.
- ii.Casting
- - Add Raja CreteAD (An integreal Waterproofing
Compound) which reduces the void and makes
concrete impermeable. (It is to be added to
1Litre to 100Kgs of Cement by weight) - Raja CreteAD makes any concrete impermeable if
thickness of concrete is maintained at 6 inches
with prescribed dosage. - - If thickness is maintained at less than 6
inches additional waterproofing is required. - iii.Treatment after Casting Slab Retaining
Walls - - Applying Two Coats of Raja CrMi (an intergral
Crystalline based Waterproofing to resist the
negative water pressure up to 10 bars).
Call our expert 022 2508 0101
www.raja-n-raja.com mail_at_raja-n-raja.com
6- 2.After Construction Waterproofing
(Rehabilitation) - (A) Over Head Water Tank / Elevated Water Tank
- i.Cleaning The surface
- - Clean the surface thoroughly for loose portion,
grece or any debris. - - Surface coating of the Primer is recommended to
ensure better adhesion of the Waterproofing
Coating to the parent structure. - ii.Waterproofing
- - Applying Two Coats of Raja ChemCoat (Hybrid of
PU and Acrylic polymer, highly flexible,
Impervious and Elastic with High Bonding strength
even in constant contact of Potable Water) in a
DFT of 2mm per coat. - (B) Underground Water Tank
- i.Cleaning The surface
- - Clean the surface thoroughly for loose portion,
grece or any debris. - - Surface coating of the Primer is recommended to
ensure better adhesion of the Waterproofing
Coating to the parent structure.
Call our expert 022 2508 0101
www.raja-n-raja.com mail_at_raja-n-raja.com
7- ii.Waterproofing
- - Depending on intensity, nature of leakage
various methods could be chosen - i.Injection Grouting
- ii.Laying Shabad Stoned Box Waterproofing
- iii.Crystalline Coating based Waterproofing.
- iii.Soil Stabilization Some time due to location
of our underground water tank, the backfilled
material or poured concrete gets washed off, and
could lead to water ingress, Use of Soil
stabilized material could help in arresting the
leakage problem. - For Thorough Description, CAD Drawings or
Perspective Illustration, TDS Contact Raja
Raja - These systems are tried, tested in labs and are
verified, approved by most of government bodies,
private entities and construction for over 30
years now across the globe. - The products mentioned in the systems are
specially procured, processed and manufactured
by/for Raja Raja only and are in sync with all
the products of Raja Raja. - To contact mail_at_raja-n-raja.com 022 25080101
Call our expert 022 2508 0101
www.raja-n-raja.com mail_at_raja-n-raja.com