100 Vg Liquid in UK

1
Genesis Atomizer Coiling Guide
We felt we should include this Know How Guide
as weve had many calls about this. Many of you
will agree, building your first electronic
cigarette rebuildable atomizer is a pain.
You spend hours, even days watching reviews and
taking notes - seeing how easily the tutorial
oxidizes the wick and wire, setting the genesis
style atomizer up, applying the e liquid, then
presses the fire button and shows off their
evenly glowing coil atomizer ready to vape - only
to find something somewhere along the way has not
quite gone right for you. Weve all been there,
racking our brains as to what element of the
process you followed so meticulously has failed
you. My first genesis style rba took 4 hours to
setup properly! Im a perfectionist. You can only
imagine the frustration I went through - unless
of course you are in exactly the same boat - then
you'll no doubt know where I am coming from. I
recall someone once said when I was an amateur
vaper, "before attempting to build your genesis
Atomizer, make sure you have another one all
ready to use during the setup" This couldnt be
closer to the truth, or so I thought at the
time....
2
Step 1 CHECKLIST Have the following home tools
close at hand A Lighter A Screwdriver Wire
Cutters A Paperclip An Awl or similar fine
pointed tool
Gensis Atomizer A pre-oxidized and primed
stainless steel mesh wick Kanthal wire for the
coil Drill bit
3
PREPARE THE WICK The first thing we need to do is
prepare the wick and make sure it fits
comfortably in the Atomizer wick hole. Follow my
instructions below Straighten out the paperclip
completely Remove the wick from the bottle of VG
and insert it on to the paperclip Using the
lighter, hold one end of the paper clip and burn
all VG off the wick (If it lights on fire, leave
it until the fire goes out) A Your wick is now
ready for use.

4
MAKE THE COIL
using your thumbs and fore fingers starting at
the center of the wick, roll the wick through
your thumbs and fingers using reasonable pressure
outwards. This will tighten the roll and reduce
the diameter. Test the wick in the wick hole
again Repeat if neccessary
Taking the drill bit and the wire (I reccommend
Kanthal AWG 29, explained why here) Place one end
of the wire on the drill bit and hold it down
with your thumb Wrap as tightly as you can 5/6
Wraps (1.0 ohm), 6/7 Wraps (1.3 ohm) or 7/8 wraps
(1.5 ohm) The result will end up with this.