Easy Steps to Replace an Epson Stylus NX300 Toner

1
Easy Steps to Replace an Epson Stylus NX300 Toner
2
If you are trying to print a photo or document on
the Epson Stylus NX300 and it displays you an
error message on the screen that one of the ink
cartridges is empty or low, you need to replace
the ink cartridge to continue printing. While an
ink cartridge is a thick or having blockage, you
may face printing issues like faded, washed or
missing colors. So, replace an empty or low
cartridges can fix the error and make your Stylus
NX300 to operate normally. At the same time, if
you are unable to handle it properly, you can
contact the Epson printer technical support
number to avail instant support or follow these
simple steps
Next
3
Step 1
At first, see the message shown on the printer
screen. Press the OK button located on the
Control Panel of the printer to fix the error.
Next
4
Step 2
Put your hands in the depressions on the scanner
bed sides, and lift up to uncover the top half of
the printer to open the location. Now, you should
check the carrier for the ink cartridge on the
printer right side.
Next
5
Step 3
Put your hands in the depression on the ink
cartridge carrier back side. Swipe the cover up
and near you to release it.
Next
6
Step 4
Press the release lever on the empty cartridge
back side, and swipe the cartridge up to take
away it from the carrier.
Next
7
Step 5
Shake the new toner gradually to allot the ink
inside it, and then take it out from its foil
package. Cover the protective film off of the
bottom and sides of the toner be careful not to
use the nozzle or electronic components.
Next
8
Step 6
Turn the ink cartridge, thus the nozzle surfaces
down and the release lever surfaces away from
you. Lower the toner into the empty slot on the
carrier unless the release lever connects.
Next
9
Step 7
Place the cover for the cartridge carrier to its
proper place, and lower the top of your printer
to close it.
Next
10
Step 8
Press the OK button on the printer control
panel, and wait for the screen to show a message
telling you that the Stylus NX300 printer is
ready to use. Press the Menu button to remove
the message and continue using the printer.
Next
11
However, if you are unable to replace your Epson
Stylus NX300 toner even after putting a lot of
efforts, you can call on the Epson printer
support phone number and ask the help of experts
to fix the problems.
Article Source http//bit.ly/2eqVSce
12
Thank You