How to Light a Rheem Water-Heater Pilot?

1
How to Light a Rheem Water-Heater Pilot?
2

• If you don't have any hot water, the first thing
  you should do is check to see if the pilot light
  on your Rheem water-heater has gone out. Rheem
  water-heater pilots need to be manually lit using
  the piezo ignitor striker built into the
  water-heater. It's important to know how to light
  the pilot on your water-heater, because you
  should always turn the pilot light off if you are
  leaving your home for an extended vacation.

3
Instructions

1. Rotate the gas knob on your Rheem water-heater
   clockwise until it is in the "Off" position.
2. Rotate the water-heater temperature dial
   counterclockwise until it is set to the lowest
   temperature setting. Wait five minutes to allow
   any gas in the water-heater to pass through.
3. Lift the outer door off of your Rheem
   water-heater. Rotate the gas knob
   counterclockwise until it is in the "Pilot"
   position.

4
Instructions
4. Push down the red button to the left of the
gas knob. Hold the red button down while pressing
the piezo ignitor striker, found to the immediate
right of the gas knob, repeatedly until the pilot
is lit. You can see the pilot light through the
viewing window on the water-heater's inner door.
Continue to hold down the red button for one
minute after the pilot is lit, and then release
it. The pilot will remain lit.
Article Source http//www.ehow.com/how_6464999_li
ght-rheem-water_heater-pilot.html Image Source
https//www.immerge.com.au/immerge-hot-water-syste
ms-melbourne/brands/rheem-hot-water
5. Replace your water-heater's outer door. Rotate
the gas knob counterclockwise until it reads
"On." Set the hot-water temperature dial to your
preferred water temperature.