Follow Self Guideline for Paintless Dent Repair

1
Self Guidelines for
Paintless Dent Repair Service
Collision center of Temecula
http//www.collisioncenteroftemecula.com/
2
How Paintless dent removal works?

• Paintless dent repair (PDR) is a collection
  of techniques for removing minor dents and dings
  from the auto body. It is also known as paintless
  dent removal. A ample range of damage can be
  repaired using PDR however, usually if there is
  paint damage, PDR may be unsuitable.
• The most common practical use for PDR is to
  repair of hail damage, door dings, minor body
  creases, and minor bumper indentations from a
  vehicle's exterior surface panels without
  disturbing the look of a car.

3
How to repair a dent in your car?

• Here I am going to discuss with you some steps
  that used to complete the dent repair are as
  follows
• Firstly examine the hub of the cavity, and drill
  a hole in the dent with a 1/8 inch drill bit.
  Otherwise, you can use glue handgun to glue a
  synthetic adapter at the center of the dent. Dent
  removal kits include the glue handgun and
  synthetic adapter.
• The second step is to attach the dent pulling
  tool to the plastic circle that is glued on the
  dent by the glue gun. Now with the help of dent
  pulling tool pull it out.
• Now carefully hammer the dent using the hammer
  that is specially designed for automotive
  (metalworking hammer), at the same time holding
  the dolly firmly in opposition to the dent back.
  So it may be required to go underside the car in
  order to reach the backside of the dent.

4

• Use a medium grit disk mounted on a drill to
  grind the paint down to the bare metal, now
  extending the affected area out at least one inch
  around the dent itself. Then fill the entire area
  with good quality body filler.
• Allow the body filler to dry completely, and then
  carefully sand the area with sandpaper which has
  been wrapped around a wood block. When sanding,
  starts with a 36-grit sandpaper and work up to a
  120-grit sandpaper.
• Use a spray primer to prime the affected area,
  but one thing you should keep in mind that the
  spray primer is specially designed for the use of
  automotive. Now we have to use six coats of
  primer, each coat allow to dry before apply to
  next primer coat.
• Sand the primer using a 600-grit wet and dry
  sandpaper. You can use this step to remove any
  scratches. The affected area should then be
  touched up with a matching automotive paint. If
  there is difference in paint leveling and it is
  not smooth then repaint and resand the affected
  area until you have a soft surface.

5

• Now you need not to worry about your car
  dents. If you are unable to remove your car dents
  by yourself. You just need to visit Collision
  Repair Center of Temecula. We follow the above
  mentioned procedure to remove a dent or ding.

6
Contact Us

• You may contact at
• Phone [phone]
• Fax [phone]
• Email us at assignments_at_ccot.us
• Address Commerce Center Drive , Temecula, CA
  92590
• For More Information visit on our website
  http//www.collisioncenteroftemecula.com/
• Working days and hours MONDAY - FRIDAY 730 AM
  5 30 PM ?AVAILABLE
• Thank You !