How to Fix iPad Screen

1
PRESENTATION ONDr phone fix
2
Welcome
3
How to Fix iPad Screen
4
If your iPad dropped accidentally and obtained an
ugly mark on its large touch screen, you should
not panic whatsoever. You can enjoy the services
of your phone all over again. If your warranty
has already elapsed, you will have to foot the
replacement cost. Apple has been offering repair
services over the years, but they are expensive.
Therefore, you might want to get some clues on
how to fix iPad screen. It is not an easy task,
but you might pull out of it successfully, if you
learn the technicalities, shop for quality
replacement screen and arm yourself with a
complete toolkit.
5
(No Transcript)
6
(No Transcript)
7
(No Transcript)
8
(No Transcript)
9
(No Transcript)
10

• Here is how to repair a broken iPad screen
• Place the device on a flat surface either a soft
  cloth or a rubber mat. Using the prying tool,
  remove the tabs near the edge of the damaged
  screen. At the same time, place another prying
  tool between the rear panel and the top left
  edge, to prevent the front panel from coming back
  into place.
• Now, use the prying tool to remove the tabs from
  the right edge. After you have released all the
  tabs, pull up the front panel from the back panel
  but do not take it out. This is because, it is
  still held underneath by the ribbon cables
  attached to the back panel.
• Detach the cables on the motherboard. In the
  process, you will be required to get out the
  digitizer, display data cables and light sensor.
  As you do this, ensure to be gentle and take note
  of the origins of the cables.

http//drphonefix.com
11
(No Transcript)
12
(No Transcript)
13

• Remove the three screws that hold the LCD
  brackets and display clips. You should use the
  Philips screwdriver to remove the screws. Then,
  get off the clips and the tape from the frame of
  the display. Check out for any remaining screws
  and loosen them too.
• Separate the LCD panel from display frame. The
  prying tool should enable you to detach the LCD
  from the adhesive that is holding it to the front
  glass panel.
• Remove the EMI tape on the top edge of the old
  screen and transfer it to the new one. Then,
  remove the Torx screws of the home button switch.
• Pass a heat gun on the adhesive securing the
  plastic frame to the front glass panel and remove
  it. Heat the plastic frame near the digitizer
  cable and separate it from the glass panel.
• Finally, fix the new iPad screen and reassemble
  the device without missing a single screw.

14
(No Transcript)
15
Fixing an iPad screen on your own, might take
your time and energy, but it is worth trying if
it is the only option on the board. However, if
this seems difficult, do not hesitate to take it
to a professional. It will save you, the headache
and some money.
16
For More Information
Drphonefix.com
17
Thank You