Title: Amateur Radio Jeeparty
1(No Transcript)
2THIS
IS
AMATEUR RADIO JEEPARTY
3 With
Your
Host...
YOUR NAME
4Special Op./ Operating Practices
License/ Operator Duties
Antennas/ Electronics
Electrical
RF Safety
FCC Rules
100
100
100
100
100
100
200
200
200
200
200
200
300
300
300
300
300
300
400
400
400
400
400
400
500
500
500
500
500
500
5- What government agency grants your amateur radio
license? - The Department of Defense
- The Federal Communications Commission
- The Department of Commerce
- The State Licensing Bureau
A 100
6B. The Federal Communications Commission
A 100
7Incorrect
A 100
8- If you forget to renew your amateur license and
it expires, may you continue to transmit? - Yes, any time for up to two years (the grace
period for renewal) - Yes, but only if you identify using the suffix
GP - Yes, but only during authorized nets
- No, transmitting is not allowed
A 200
9D. No, transmitting is not allowed
A 200
10Incorrect
A 200
11- Which of the following is a prohibited amateur
radio transmission? - Using an autopatch to seek emergency assistance
- Using an autopatch to call a tow truck
- Using an autopatch to pick up business messages
- Using an autopatch to call home to say you are
running late
A 300
12C. Using an autopatch to pick up business messages
A 300
13Incorrect
A 300
14- Besides normal identification, what else must a
US station do when sending third-party
communications internationally - The US station must transmit its own call sign at
the beginning of each communication, and at least
every ten minutes after that - The US station must transmit its own call sign at
the beginning of each communication, and at least
every five minutes after that - The US station must transmit both call signs at
the end of each communication - Each station must transmit its own call sign at
the end of each transmission, and at least every
five minutes after that
A 400
15C. The US station must transmit both call signs
at the end of each communication
A 400
16Incorrect
A 400
17- What is the basic principle of radio
communications? - The peak-to-peak voltage of a transmitter is
varied by the sidetone and modulated by the
receiver - A transmitter separates information to be
received from a radio wave - A DC generator combines some type of information
into a carrier wave so that it may travel through
space - A radio wave is combines with an information
signal and is transmitted a receiver separates
the two
A 500
18D. A radio wave is combines with an information
signal and is transmitted a receiver separates
the two
A 500
19Incorrect
A 500
20- Why should you use only good quality coaxial
cable and connectors for a UHF antenna system? - To keep RF loss low
- To keep television interference high
- To keep the power going to your antenna system
from getting too high - To keep the standing-wave ratio of your antenna
system high
B 100
21B 100
22Incorrect
B 100
23- Which sideband is commonly used for 10-meter
phone operation? - Amplitude-compandored sideband
- Lower sideband
- Upper sideband
- Double sideband
B 200
24C. Upper sideband
B 200
25Incorrect
B 200
26- Why should you keep transmissions short when
using a repeater - To see if the receiving station operator is still
awake - A long transmission may prevent someone with an
emergency from using the repeater - To give any listening non-hams a chance to
respond - To keep long-distance charges down
B 300
27B. A long transmission may prevent someone with
an emergency from using the repeater
B 300
28Incorrect
B 300
29- When may false or deceptive signals or
communications be transmitted by an amateur
station? - Never
- When operating a beacon transmitter in a fox
hunt exercise - When playing a harmless practical joke
- When you need to hide the meaning of a message
for secrecy
B 400
30B 400
31Incorrect
B 400
32- What devise could boost the low-power output from
your hand-held radio up to 100 watts? - A voltage divider
- A voltage regulator
- An impedance network
- A power amplifier
B 500
33D. A power amplifier
B 500
34Incorrect
B 500
35- What is the name for the operating position where
the control operator has full control over the
transmitter? - Field point
- Auxiliary point
- Control point
- Access point
C 100
36C. Control point
C 100
37Incorrect
C 100
38- What should you do before you transmit on any
frequency? - Check your antenna for resonance at the selected
frequency - Listen to make sure that someone will be able to
hear you - Listen to make sure others are not using the
frequency - Make sure the SWR on your antenna feed line is
high enough
C 200
39C. Listen to make sure others are not using the
frequency
C 200
40Incorrect
C 200
41- What is your responsibility as a station
licensee? - You must allow another amateur to operate your
station upon request - You are responsible for the proper operation of
the station in accordance with the FCC rules - You must notify the FCC if another amateur acts
as the control operator - You must be present whenever the station is
operated
C 300
42B. You are responsible for the proper operation
of the station in accordance with the FCC rules
C 300
43Incorrect
C 300
44DAILY DOUBLE
DAILY DOUBLE
Place A Wager
C 400
45- If you are using a language besides English to
make a contact, what language must you use when
identifying your station? - The language being used for the contact
- English
- The language being used for the contact, provided
the US has a third-party communications agreement
with that country - Any language of a country that is a member of the
International Telecommunications Union
C 400
46B. English
C 400
47Incorrect
C 400
48- If you let another amateur with a higher class
license than yours control your station, what
operating privileges are allowed? - All the emission privileges of the higher
license, but only the frequency privileges of
your license - Only the privileges allowed by your license
- Any privileges allowed by the higher license, as
long as proper identification procedures are
followed - All the frequency privileges of the higher
license, but only the emission privileges of your
license
C 500
49C. Any privileges allowed by the higher license,
as long as proper identification procedures are
followed
C 500
50Incorrect
C 500
51- Which of the following is the best way to install
your antenna in relation to overhead electric
power lines? - Always be sure your antenna wire is higher than
the power line and crosses it at a 90-degree
angle - Always be sure your antenna is lower than the
power line, and crosses it at a small angle - Always be sure your antenna and feed line are
well clear of any power lines - Only use vertical antennas within 100 feet of a
power line
D 100
52C. Always be sure your antenna and feed line are
well clear of any power lines
D 100
53Incorrect
D 100
54- Which of the following is NOT an important
consideration when selecting a location for a
transmitting antenna? - Nearby structures
- Height above average terrain
- Distance from the transmitter location
- Polarization of the feed line
D 200
55D. Polarization of the feed line
D 200
56Incorrect
D 200
57- What is parallel-conductor feed line?
- Two wires side-by-side held apart by insulating
material - Two wires twisted around each other in a spiral
- A center wire inside an insulating material that
is covered by a metal sleeve or shield - A metal pipe that is as wide or slightly wider
that a wavelength of the signal it carries
D 300
58- Two wires side-by-side held apart by insulating
material
D 300
59Incorrect
D 300
60- Where would you install a balun to feed a dipole
antenna with 50-ohm coaxial cable? - Between the antenna and the ground
- Between the transmitter and the coaxial cable
- Between the coaxial cable and the antenna
- Between the coaxial cable and the ground
D 400
61C. Between the coaxial cable and the antenna
D 400
62Incorrect
D 400
63- If you are told that your amateur station is
causing television interference, what should you
do? - Connect a high pass filter to the transmitter
output and a low-pass filter to the antenna-input
of the television - Immediately turn off your transmitter and contact
the nearest FCC office for assistance - First make sure that your station is operating
properly, and that it does not cause interference
to your own television - Continue operating normally, because you have no
reason to worry about the interference
D 500
64C. First make sure that your station is operating
properly, and that it does not cause interference
to your own television
D 500
65Incorrect
D 500
66- For best protection from electrical shock, what
should be grounded in an amateur station? - The power supply primary
- The antenna feed line
- All station equipment connected to a common
ground - The AC power mains
E 100
67C. All station equipment connected to a common
ground
E 100
68Incorrect
E 100
69- Which instrument would you use to measure
electric current? - An ohmmeter
- A wavemeter
- An ammeter
- A voltmeter
E 200
70C. An ammeter
E 200
71Incorrect
E 200
72- Which of the following best describes a variable
capacitor? - A set of fixed capacitors whose connections can
be varied - Two sets of rotating conducting plates separated
by an insulator, which can be varied in surface
area exposed to each other - A set of capacitors connected in a
series-parallel circuit - Two sets of insulating plates separated by a
conductor, which can be varied in distance from
each other
E 300
73B. Two sets of rotating conducting plates
separated by an insulator, which can be varied in
surface area exposed to each other
E 300
74Incorrect
E 300
75- How can amateur station equipment best be
protected from lighting damage? - Use heavy insulation on the wiring
- Never turn off the equipment
- Disconnect the ground system from all radios
- Disconnect all equipment from the power lines and
antenna cables
E 400
76D. Disconnect all equipment from the power lines
and antenna cables
E 400
77Incorrect
E 400
78- Which instrument would you use to measure
electric potential or electromotive force? - A voltmeter
- An ammeter
- A wavemeter
- An ohmmeter
E 500
79E 500
80Incorrect
E 500
81- Why do exposure limits vary with frequency?
- Lower-frequency RF fields have more energy than
higher-frequency fields - Lower-frequency RF fields penetrate deeper into
the body than higher-frequency fields - The bodys ability to absorb RF energy varies
with frequency - It is impossible to measure specific absorption
rates at some frequencies
F 100
82C. The bodys ability to absorb RF energy varies
with frequency
F 100
83Incorrect
F 100
84- What is one biological effect to the eye that can
result from RF exposure? - The strong magnetic fields can cause blurred
vision - It can cause heating, which can result in the
formation of cataracts - The strong magnetic fields can cause polarization
lens - It can cause heating, which can result in
astigmatism
F 200
85B. It can cause heating, which can result in the
formation of cataracts
F 200
86Incorrect
F 200
87- Which of the following radio frequency emissions
will result in the least RF radiation exposure if
they all have the same peak envelope power (PEP)? - Two-way exchanges of phase-modulation (PM)
telephony - Two-way exchanges of frequency-modulated (FM)
telephony - Two-way exchanges of Morse Code (CW)
communication - Two-way exchanges of single-sideband (SSB)
telephony
F 300
88D. Two-way exchanges of single-sideband (SSB)
telephony
F 300
89Incorrect
F 300
90- At what frequencies do the FCCs RF radiation
exposure guidelines incorporate limits for
Maximum Permissible Exposure (MPE)? - All frequencies below 30 MHz
- All frequencies between 300 kHz and 100 GHz
- All frequencies above 300 GHz
- All frequencies between 20,000 Hz and 10 MHz
F 400
91B. All frequencies between 300 kHz and 100 GHz
F 400
92Incorrect
F 400
93- Why is it a good idea to adhere to the FCCs
Rules for using the minimum power needed when you
are transmitting with your hand-held radio? - Large fines are always imposed on operators
violating this rule - To reduce calcification of the NiCd battery pack
- To reduce the level of RF radiation exposure to
the operators head - To eliminate self-oscillation in the receiver RF
amplifier
F 500
94C. To reduce the level of RF radiation exposure
to the operators head
F 500
95Incorrect
F 500
96The Final Jeopardy Category is Electronics
Antennas Please record your wager.
Click on screen to continue
97- What may happen if a SSB transmitter is operated
with the microphone gain set too high? - It may cause digital interference to computer
equipment - It may cause interference to other stations
operating on a higher frequency band - It may cause atmospheric interference in the air
around the antenna - It may cause splatter interference to other
stations operating near its frequency
Click on screen to continue
98D. It may cause splatter interference to other
stations operating near its frequency
Click on screen to continue
99Thank You for Playing Amateur Radio Jeeparty!
Game Designed By C. Harr-MAIT Brent Barber