Smartphone Repair and Service With Cheap Cost (1)

1
Smartphone Repair and Service With Cheap Cost
2
Smartphone Repair and Service With Cheap Cost
Searching for phone repair services. Then
contact our efficient and skilled team to search
out additional regarding our numerous services
created to satisfy your actual wants. All our
professionals have a lot of experience and we
guarantee you will get answers for all your
quires. We have a tendency to waiting to
listen to from you and to answer any queries you
will wear. However we are able to do best serve
your desires.
3
Smartphone Repair and Service With Cheap Cost
About iPhone X
The iPhone X is Apple's most breakable phone yet,
which means you're probably going to crack your
display at some point. iPhones service and repair
shop Apple wants to try to charge you almost 300
to fix it for you, but I've got a way that'll
save you some dough. Today I'm going to show you
how to replace the display, and I'll show you how
to maintain face ID when you make the swap.
Remember that by opening your device, you are
losing water resistance, so be sure to apply new
adhesive to your display when you reassemble your
phone. We'll have a link to that guide in the
description below. For this repair, you're going
to need a P2 pentalobe screwdriver, a, tri-point
Y000 driver, a spudger, tweezers, an iOpener, an
iSclack, and opening picks.
4
Smartphone Repair and Service With Cheap Cost
Start by removing the strangely long P2 pentalobe
screws by the lightning connector. Next use an
iOpener to soften the adhesive on the edge of the
phone. This will also help you insert an opening
pick to cut away the adhesive. Once you get to
the side with the power button, be careful. The
display connectors reside on this side, and going
in too deep with your pick can damage them. Go
all around the phone, making sure you cut away
the remaining adhesive. The iPhone X still opens
up to the right, just like the iPhone 7 and 8,
but all the connectors are now under one bracket
to rule them all. Go ahead and remove those five
tri-point screws and lift the bracket away with
your tweezers. Grab your spudger and pray to the
cable gods that you disconnect the right cables.
Just kidding, I'll show you where to start. Start
it by removing the battery.
5
Smartphone Repair and Service With Cheap Cost
It's the third one up from the bottom. Then
disconnect the three display connectors. It's
easier if you just follow the cables to its
connector on the logic board. With all the
connectors disconnected, you can remove the old
display. To retain face ID you must swap over
the original front sensor assembly to your new
display. Moving on to the top of the display,
remove the wide 000 screws near the infrared
camera port. Beneath that screw lies a small
metal grounding clip. If it didn't come out
already with the screw, go ahead and remove it.
Next, remove two more wide 000 screws holding
the speaker and sensor assembly down. Using a
spudger, gently pry below the highest fringe of
the speaker, assembly, and flip it down and
removed from the highest fringe of the display.
Just be careful because the speaker is still
attached via a thin cable.
6
Smartphone Repair and Service With Cheap Cost
Heat up your iOpener and lay your display over it
near the top. This will soften the adhesive
securing the sensors. Phone battery replacement
shop Carefully, slide the flat edge of your
spudger underneath the flex cable below the
microphone. Then twist gently to separate the
microphone while being careful not to strain or
damage the flex cable. If needed, use the point
of the spudger to finish separating the
microphone from its notch on the front panel.
Grab a pick and slide it under the flex cable
and proximity flood illuminator. Work the pick
left to right carefully. Gently wiggle and lift
to separate the module from the front panel.
Cheap phone repair shop Using tweezers, wiggle
the ambient light sensor and lift it from its
notch on the display. With the entire ambient
light sensor un-adhered, you can remove it from
the display.
7
Smartphone Repair and Service With Cheap Cost
If you've successfully removed the entire ambient
light sensor then you're all good for now, but if
the white diffuser strip detached and stayed in
the display, then you need to carefully dig that
out. That's all for this repair. Be sure to
click that subscribe button so you've got the
latest repair and teardown videos in your back
pocket for your next fix. Sarasfix Smartphone
Screen replacement shop prove our devotion to you
as we promise to keep up the best level of
quality and commitment your satisfaction is our
only concern contact us immediately and allow us
to show you all the wonderful choices we've
got. For more information reach us
https//www.sarasfix.com
8
We are construction partners who are passionate
about what we do and our partners success.
CONTACT INFORMATION
234A Shaftesbury Avenue, London, WC2H 8EG
020 7240 6320
info_at_sarasfix.com www.sarasfix.com