EASCO BOILER CORP.

1
Field Erected Packaged Quality Steel
Boilers

• EASCO BOILER CORP.
• 1175 Leggett Avenue
• Bronx, New York 10474 USA
• Tel [phone]
• Fax [phone]

2
EASTMOND ORGANIZATION

• With over 40 years of excellence and 20,000
  boilers made A. L. Eastmond Sons, specializes
  in the manufacturing of Quality Built Commercial
  Steel Boilers.
• Uniquely positioned in the market place by are
  Field Erect Capabilities, ability to custom
  design boilers to your specification, and as
  owner of the exclusive rights to produce the
  Federal Boiler design we guarantee your
  complete satisfaction.
• A. L. Eastmond Sons also offer a wide range of
  services from tank cleaning/ waste disposal,
  temporary heat and expert responsive repair - you
  will benefit from our comprehensive and thorough
  solutions to meet every Boiler Room need.

3
MANUFACTURERS OF ASME SECTION I AND IV
PRESSURE VESSELS
4
(No Transcript)
5
EASCO SERIES SM4 SCOTCH MARINE BOILERS

• STEEL 3-PASS, FULL WATER BACK SCOTCH DESIGN.
• LOW PRESSURE STEAM 15 PSIG.
• HOT WATER TO 160 PSIG (250 DEGREES F).
• FROM 20 TO 1000 BHP.
• FULL 5SQ. FT. OF FIRESIDE HEATING SURFACE PER
  BHP.
• CONSTRUCTED IN ACCORDANCE WITH ASME SECTION IV.
• MINIMUM REFRACTORY MATERIALS.
• LARGE FURNACE VOLUME. LOW HEAT RELEASE RATE.
• FULLY PACKAGED OR FIELD ERECTED.
• NATURAL OR DIGESTED GAS, FUEL OIL OR COMBINATION
  TO MEET ANY REQUIREMENTS.

DEVELOPED BY EASCO ALONG WITH NEW YORK STATE
ENERGY RESEARCH AND DEVELOPMENT AUTHORITY, FOR
HIGH EFFICIENCY, LOW EMISSIONS AND SUPERIOR STEAM
QUALITY PERFORMANCE.
6
EASCO SERIES SM4 CONSTRUCTION FEATURES
7
EASCO SERIES SM4 CONSTRUCTION FEATURES
8
EASCO SERIES SM4 CONSTRUCTION FEATURES
9
EASCO SERIES SM4 CONSTRUCTION FEATURES
10
EASCO SERIES SM4 CONSTRUCTION FEATURES
11
EASCO FIELD ERECTED STEEL BOILERS
You need IT HERE. You need IT NOW AND you need
IT within budget. IT is the comfort, reliability
and operational ease only a firetube boiler can
provide. HERE in a mechanical room where your old
inefficient boiler is buried three sub-basements
deep. NOW we can field erect 100 HP boiler in
your basement in less than a week IMPOSSIBLE ?
EASCO does the impossible. Our ASME-certified
factory craftsmen built the finest quality,
fully-warrantied steel firetube boilers on your
job site in a matter of days.
With EASCO field-erected boilers you can select
from 4 versatile designs for low-pressure steam
and hot water heating (15 PSIG Steam, up to 160
PSIG Hot Water).
12
EASCO FIELD ERECTED BOILERS
13
TURBO-RING FORCED DRAFT BURNERSGas, Oil or
Combination Dual-Fuel Units

• Overall Capabilities
• 3 to 1,000 boiler horsepower
• 100,000 to 42,000,000 BTU/hr input

Applications Firetube, watertube and cast iron
boilers, dryers, airheaters, incinerators, solid
fuel ignitors and others.
14
GENERAL FEATURES

• Factory wired, assembled and tested
• 100,000 to 42,000,000 BTU/hr input
• Natural gas, LP gas, fuel oil 2, 4, 6,
  combination gas/oil.
• UL, CSA, IRI, FM, BAR, CSD-1, NFPA.

• Turbo-Ring Forced Draft Burners
• Factory wired, assembled and tested.
• Patented stainless steel head combines a
  ring of recessed gas ports with controlled
  primary air, providing maximum
• flame retentions.
• Mechanical pressure, air or steam atomizing oil
  systems.

15
GORDON-PIATT/JOHN ZINK FORCED DRAFT BURNERS

• UL, FM, IRI pre-piped and wired gas train.
• Control cabinets, boiler control panels and
  centers.
• Fuel oil transfer oil pump systems.
• To meet UL or any specific requirements.

16
EASCO/GPEG THERMAL LOW NOx REDUCTION SOLUTION

• Flue gas recirculation systems.
• Steam injection systems.
• Internal recirculation systems.

• Flue gas recirculation (FGR) is UL Listed and
  provides for Low NOx operation for both gas and
  fuel oil.
• Steam injection (SI) is UL Listed and is cost
  effective for gas burners but provides no
  reduction on oil. The SI system requires a steam
  supply.
• For straight gas, John Zink Gordon-Piatt has a UL
  Listed internal recirculation system.