Title: Hybrid Ion and Chemical GEO Stationkeeping Maneuver Planning Software
1Hybrid (Ion and Chemical) GEO Stationkeeping
Maneuver Planning Software
- J. K. Skipper, D. Racicot, S. Li, R.
Provencherand J. Palimaka - Telesat Canada, Ottawa, Ontario, Canada
2Hybrid GEO Stationkeeping Maneuver Planning
SoftwareAbstract
- GEO Stationkeeping Flight Dynamics System a
suite of software applications to perform
Prediction, State Estimation and Maneuver
Planning functions - Telesat Canadas FDS used since 1976 to support
mission and S/K operations of over 40 satellites
from 5 S/C manufacturers - Orbit control (firing of thrusters to offset
perturbing effects of earth triaxiality, solar
radiation force and gravitational effects of sun
and moon) has historically used chemical
propellants to provide high thrust at relatively
low specific impulse (propellant efficiency) - Some new satellite designs use ion-electric
thrusters to generate much higher specific
impulses at lower thrust levels, resulting in
reduced propellant masses at launch and longer
propellant lifetimes - Depending on spacecraft design, orbit control may
use only ion thrusters or a combination of ion
and chemical propulsion systems - Telesats OnOrbit FDS includes Hybrid maneuver
planning function to simultaneously plan ion and
chemical maneuvers
3Hybrid GEO Stationkeeping Maneuver Planning
SoftwareIntroduction 1
- GEO orbit does not remain geostationary due to
perturbations - Luni-solar gravity precesses orbit plane
(direction and magnitude is influenced by a
6-month term in solar gravitational effect and a
18.6 year term due to the motion of the moons
ascending node) - Earth oblateness (equatorial bulge) acts with
luni-solar gravity to precess orbit plane - Triaxiality (longitudinal harmonics in
geopotential) causes satellite to accelerate east
or west toward longitude nulls (105.3W and
75.1E) - Solar radiation affects orbit eccentricity
(circularity) mean eccentricity vector
naturally traces out a near-circular path once
per year - Perturbations are offset by performing maneuvers
(thruster firings) to adjust orbit velocity - North-South maneuvers apply delta-velocity in
north or south direction to adjust orbit plane
(inclination) - East-West maneuvers apply positive or negative
change in spacecraft velocity to correct
eccentricity and longitude drift
4Hybrid GEO Stationkeeping Maneuver Planning
SoftwareIntroduction 2
- For all-chemical propulsion systems, North-South
and East-West maneuvers are largely uncoupled
(independent), and are typically performed once
every 1 or 2 weeks - With ion-electric systems, ion thrusters are
usually positioned and oriented to provide
north-south and nadir (earth-directed) components
of delta-velocity (thrust vector nominally
through CM) - Nadir delta-v causes shift in mean longitude with
each maneuver, and can be used to control
eccentricity - Mean longitude shift is offset by increasing
nominal orbit altitude - Low thrust of ion thrusters requires much more
frequent maneuvers than chemical e.g. two burns
(one north, one south) 12 hours apart every day - Ion maneuvers may be supplemented with chemical
maneuvers to provide drift-only or drift and
eccentricity control frequency of chemical
burns may range from twice per day to once every
2 weeks, depending on satellite design and ion
thruster firing strategy
5Hybrid GEO Stationkeeping Maneuver Planning
SoftwareNon-Singular Orbital Elements
- The satellite orbit may be represented by 6
non-singular orbital elements - Mean longitude drift rate (/day E)
- Mean right ascension of the satellite ( mean
longitude Greenwich Hour Angle) (E) - h1 e sin (??)
- k1 e cos (??)
- h2 sin i sin ? ? i sin ?
- k2 sin i cos ? ? i cos ?
- where
- e is the orbit eccentricity
- i is the orbit inclination (in radians)
- ? is the argument of perigee
- ? is the right ascension of the ascending node
6Hybrid GEO Stationkeeping Maneuver Planning
SoftwareManeuver Planning 1
- When a thruster is fired at satellite right
ascension a, changes in non-singular orbital
elements are determined by radial, tangential and
normal components of delta-velocity vector (DVR,
DVT, DVN)
7Hybrid GEO Stationkeeping Maneuver Planning
SoftwareManeuver Planning 2
- When inclination is close to zero, luni-solar
perturbations precess inclination vector (k2, h2)
primarily in h2 direction hence inclination
maneuvers are performed close to a 90 or 270 - Nadir (negative radial) component of DV at 90 or
270 results in change to k1 ? k1 component of
eccentricity may be controlled by choosing
relative sizes of north and south maneuvers - Shifting maneuver right ascensions away from 90
and 270 (i.e. toward 0 or 180) produces change
in h1 proportional to sum of nadir DVs - Possible ion-thruster planning strategies
include - Inclination only (chemical drift and eccentricity
control) - Inclination k1 (chemical drift and h1 control)
- Inclination eccentricity (chemical drift
control) - Can also define firing profiles in which ion
thrusters are not fired every day (e.g. 6 days
on, 1 day off in 7-day cycles) - For selected strategy and firing profile, daily
required changes in (k1, h1) and (k2, h2) are
determined and burn DVs and right ascensions are
computed
8Hybrid GEO Stationkeeping Maneuver Planning
SoftwareManeuver Planning 3
- Daily normal (N/S) component of ion burn ?Vs
and right ascension offsets
from (90, 270) can be determined by
solving the following equations - where
(CN CS are the north and south ion-thruster
cant angles), and
9Hybrid GEO Stationkeeping Maneuver Planning
SoftwareManeuver Planning 4
- The solution is
- Burn durations are computed from ?Vs
- where
- M is the satellite mass
- is the normal component of ?V
- F is the ion-thruster thrust
- C is the ion-thruster cant angle
- is the earth rotation rate
10Hybrid GEO Stationkeeping Maneuver Planning
SoftwareManeuver Planning 5
- Nadir component of DV from each ion maneuver
(-DVR) results in an eastward shift in mean
longitude - Average daily normal component of ion ?V is ?VN
?i Vsyn, where ?i is the average daily change in
inclination in radians - Average daily radial component of ?V from ion
maneuvers is - ?VR - ?VN tan C - ?i Vsyn tan C
- To offset average daily longitude shift due to
ion radial ?V, define nominal westward drift
target dN as - dN - ?l - 2 ?i tan C
- where dN (lt 0) is in deg/day East if ?i is
expressed in degrees - Note that dN does not depend on number of firing
days in cycle, only on average daily change in
inclination due to perturbations
11Hybrid GEO Stationkeeping Maneuver Planning
SoftwareManeuver Planning 6
- If chemical maneuvers are used to control one or
both components of eccentricity vector, classical
method of single- or double-burn drift ecc.
maneuvers performed once per cycle (e.g. every 7
or 14 days) may be used - If ion maneuvers fully control eccentricity, it
may be desirable to perform chemical drift
maneuvers in conjunction with ion maneuvers (i.e.
daily) two equal DV burns 12 hours apart change
drift without affecting eccentricity - In theory, if S/C is at correct longitude with
drift dN at start of cycle, daily drift maneuvers
are required only to offset drift change due to
triaxiality effect in practice, there may be
errors in longitude and drift at start of cycle - Errors are corrected over 2 cycles by defining an
intermediate drift target dint at end of first
cycle, and daily drift targets based on the
selected firing profile - Intermediate drift target is chosen such that the
time integral of drift relative to the nominal
drift target dN over 2 cycles equals the required
longitude change to correct the initial longitude
error - Daily drift targets are chosen to achieve dint at
the end of the first cycle and dN at the end of
the second cycle, such that drift corrections are
constant for each firing day of each cycle
12Hybrid GEO Stationkeeping Maneuver Planning
SoftwareManeuver Planning 7
- Sample drift profile over two 7-day cycles with
drift maneuvers (2 per day) performed on days 1,
2, 5 and 6 of each cycle - Each firing day of first cycle adjusts drift by
Dd1, each firing day of second cycle adjusts
drift by Dd2
13Hybrid GEO Stationkeeping Maneuver Planning
SoftwareOnOrbit FDS 1
- Telesat Canadas OnOrbit FDS includes Hybrid
maneuver planning application - Plans combined daily ion and bi-propellant
(chemical) stationkeeping maneuvers to control
inclination, eccentricity and drift/longitude for
stationkeeping cycles of up to 28 days - Eccentricity control may be done entirely with
ion thrusters, entirely with chemical thrusters,
or split between ion and bi-prop - Generates OnOrbit FDS events representing planned
maneuvers for the stationkeeping cycle - Generates maneuver messages / maneuver tables for
the planned maneuvers - Generates plots of predicted orbit dynamics
during the stationkeeping cycle
14Hybrid GEO Stationkeeping Maneuver Planning
SoftwareOnOrbit FDS 2
- Main window and planning input dialogs
15Hybrid GEO Stationkeeping Maneuver Planning
SoftwareOnOrbit FDS 3
- Typical 7-day cycle simulation
16Hybrid GEO Stationkeeping Maneuver Planning
SoftwareSummary
- A technique for simultaneously planning daily ion
and chemical maneuvers to control the orbital
effects of perturbations on Geostationary
satellites equipped with both ion-electric and
chemical propulsion systems has been developed
and implemented in Telesat Canadas OnOrbit FDS
Flight Dynamics System - The implementation allows for 3 possible
ion-thruster planning strategies - Inclination only (chemical drift and eccentricity
control) - Inclination k1 (chemical drift and h1 control)
- Inclination eccentricity (chemical drift
control) - and supports user-specified firing profiles for
cycles of up to 28 days - Release 1.0 of the OnOrbit FDS has been delivered
to L-3 Storm Control Systems, Inc. Release 1.1
is scheduled for delivery in 2Q 2004 and will be
used operationally to control Shin Satellites
iPSTAR-1 spacecraft