1
Stickplane assemble plans
Slot for stab
Slot for wing
The outlines shown on this page are drawn to
scale. The easiest way to build this stickplane
is to print this page and cut out each of the
airplane elements then use a glue stick to glue
the outlines to balsa sheet. Next cut out around
each outline, remove the outlines before the glue
hardens. Fit all the parts together before you
perform the final assemble. If you would like to
add a little color refer to the next page for the
trim patterns. Apply these patterns before you
perform the final assemble.
Fuselage, 1/16 hard balsa or ply
Slot for handle
Stab, 1/16 hard balsa or ply
Wing, 1/16 hard balsa or ply
Handle, 1/8 hardwood dowel
2
Stickplane trim sheets
District 8
District 8
NSRCA
AMA
If you would like to dress up your stickplane use
these trim sheets. Print this sheet using a color
printer and glossy paper for the best effect.
These patterns are slightly oversize allowing you
to trim for perfect fit after you glue the trim
sheet to each element of the stickplane.
3
(No Transcript)