ICSA 411: Week 2a Data Transmission

1
ICSA 411 Week 2aData Transmission

• Elizabeth Lane Lawley, Instructor

2
Electromagnetic Signals

• Function of time
• Analog (varies smoothly over time)
• Digital (constant level over time, followed by a
  change to another level)
• Function of frequency
• Spectrum (range of frequencies)
• Bandwidth (width of the spectrum)

3
Periodic Signal Characteristics

• Amplitude (A) signal value, measured in volts
• Frequency (f) repetition rate, cycles per second
  or Hertz
• Period (T) amount of time it takes for one
  repetition, T1/f
• Phase (F) relative position in time, measured in
  degrees

4
Analog Signaling

• represented by sine waves

phase difference
1 cycle
amplitude (volts)
time
(sec)
frequency (hertz)
cycles per second
5
Digital Signaling

• represented by square waves or pulses

1 cycle
amplitude (volts)
time
(sec)
frequency (hertz)
cycles per second
6
Digital Text Signaling

• Transmission of electronic pulses representing
  the binary digits 1 and 0
• How do we represent letters, numbers, characters
  in binary form?
• Earliest example Morse code (dots and dashes)
• Most common current form ASCII

7
ASCII Character Codes

• Use 8 bits of data (1 byte) to transmit one
  character
• 8 binary bits has 256 possible outcomes (0 to
  255)
• Represents alphanumeric characters, as well as
  special characters

8
Digital Image Signaling

• Pixelization and binary representation

Code 00000000 00111100 01110110 01111110 011
11000 01111110 00111100 00000000
9
Why Study Analog?

• Telephone system is primarily analog rather than
  digital (designed to carry voice signals)
• Low-cost, ubiquitous transmission medium
• If we can convert digital information (1s and 0s)
  to analog form (audible tone), it can be
  transmitted inexpensively

10
Voice Signals

• Easily converted from sound frequencies (measured
  in loudness/db) to electromagnetic frequencies,
  measured in voltage
• Human voice has frequency components ranging from
  20Hz to 20kHz
• For practical purposes, the telephone system has
  a narrower bandwidth than human voice, from 300
  to 3400Hz

11
Bandwidth

• Width of the spectrum of frequencies that can be
  transmitted
• if spectrum300 to 3400Hz, bandwidth3100Hz
• Greater bandwidth leads to greater costs
• Limited bandwidth leads to distortion
• Analog measured in Hertz, digital measured in baud

12
BPS vs. Baud

• BPSbits per second
• Baud of signal changes per second
• Each signal change can represent more than one
  bit, through variations on amplitude, frequency,
  and/or phase

13
Transmission Media

• the physical path between transmitter and
  receiver
• design factors
• bandwidth
• attenuation weakening of signal over distances
• interference
• number of receivers

14
Impairments and Capacity

• Impairments exist in all forms of data
  transmission
• Analog signal impairments result in random
  modifications that impair signal quality
• Digital signal impairments result in bit errors
  (1s and 0s transposed)

15
Transmission Impairments

• Attenuation
• loss of signal strength over distance
• Attenuation Distortion
• different losses at different frequencies
• Delay Distortion
• different speeds for different frequencies
• Noise

16
Types of Noise

• Thermal (aka white noise)
• Uniformly distributed, cannot be eliminated
• Intermodulation
• when different frequencies
• Crosstalk
• Impulse noise
• Less predictable

17
Transmission Media

• two major classes
• conducted or guided media
• use a conductor such as a wire or a fiber optic
  cable to move the signal from sender to receiver
• wireless or unguided media
• use radio waves of different frequencies and do
  not need a wire or cable conductor to transmit
  signals

18
Guided Transmission Media

• the transmission capacity depends on the distance
  and on whether the medium is point-to-point or
  multipoint
• e.g.,
• twisted pair wires
• coaxial cables
• optical fiber

19
Twisted Pair Wires

• consists of two insulated copper wires arranged
  in a regular spiral pattern to minimize the
  electromagnetic interference between adjacent
  pairs
• often used at customer facilities and also over
  distances to carry voice as well as data
  communications
• low frequency transmission medium

20
Twisted Pair Wires

• two varieties
• STP (shielded twisted pair)
• the pair is wrapped with metallic foil or braid
  to insulate the pair from electromagnetic
  interference
• UTP (unshielded twisted pair)
• each wire is insulated with plastic wrap, but the
  pair is encased in an outer covering

21
Twisted Pair Wires

• Category 3 UTP
• data rates of up to 16mbps are achievable
• Category 5 UTP
• data rates of up to 100mbps are achievable
• more tightly twisted than Category 3 cables
• more expensive, but better performance
• STP
• More expensive, harder to work with

22
Twisted Pair Advantages

• inexpensive and readily available
• flexible and light weight
• easy to work with and install

23
Twisted Pair Disadvantages

• susceptibility to interference and noise
• attenuation problem
• For analog, repeaters needed every 5-6km
• For digital, repeaters needed every 2-3km
• relatively low bandwidth (3000Hz)

24
Coaxial Cable (or Coax)

• bandwidth of up to 400 MHz
• has an inner conductor surrounded by a braided
  mesh
• both conductors share a common center axial,
  hence the term co-axial

25
Coax Layers
outer jacket (polyethylene)
shield(braided wire)
insulating material
copper or aluminum conductor
26
Coax Advantages

• higher bandwidth
• 400 to 600Mhz
• up to 10,800 voice conversations
• can be tapped easily (pros and cons)
• much less susceptible to interference than
  twisted pair

27
Coax Disadvantages

• high attenuation rate makes it expensive over
  long distance
• bulky

28
Fiber Optic Cable

• relatively new transmission medium used by
  telephone companies in place of long-distance
  trunk lines
• also used by private companies in implementing
  local data communications networks
• require a light source with injection laser diode
  (ILD) or light-emitting diodes (LED)

29
Fiber Optic Layers

• consists of three concentric sections

30
Fiber Optic Types

• multimode step-index fiber
• the reflective walls of the fiber move the light
  pulses to the receiver
• multimode graded-index fiber
• acts to refract the light toward the center of
  the fiber by variations in the density
• single mode fiber
• the light is guided down the center of an
  extremely narrow core

31
Fiber Optic Signals
fiber optic multimode step-index
fiber optic multimode graded-index
fiber optic single mode
32
Fiber Optic Advantages

• greater capacity (bandwidth of up to 2 Gbps)
• smaller size and lighter weight
• lower attenuation
• immunity to environmental interference
• highly secure due to tap difficulty and lack of
  signal radiation

33
Fiber Optic Disadvantages

• expensive over short distance
• requires highly skilled installers
• adding additional nodes is difficult

34
Wireless (Unguided Media) Transmission

• transmission and reception are achieved by means
  of an antenna
• directional
• transmitting antenna puts out focused beam
• transmitter and receiver must be aligned
• omnidirectional
• signal spreads out in all directions
• can be received by many antennas

35
Wireless Examples

• terrestrial microwave transmission
• satellite transmission
• broadcast radio
• infrared

36
Terrestrial Microwave Transmission

• uses the radio frequency spectrum, commonly from
  2 to 40 Ghz
• transmitter is a parabolic dish, mounted as high
  as possible
• used by common carriers as well as by private
  networks
• requires unobstructed line of sight between
  source and receiver
• curvature of the earth requires stations (called
  repeaters) to be 30 miles apart

37
Microwave Transmission Applications

• long-haul telecommunications service for both
  voice and television transmission
• short point-to-point links between buildings for
  closed-circuit TV or a data link between LANs
• bypass application

38
Microwave Transmission Advantages

• no cabling needed between sites
• wide bandwidth
• multichannel transmissions

39
Microwave Transmission Disadvantages

• line of sight requirement
• expensive towers and repeaters
• subject to interference such as passing airplanes
  and rain

40
Satellite Microwave Transmission

• a microwave relay station in space
• can relay signals over long distances
• geostationary satellites
• remain above the equator at a height of 22,300
  miles (geosynchronous orbit)
• travel around the earth in exactly the time the
  earth takes to rotate

41
Satellite Transmission Links

• earth stations communicate by sending signals to
  the satellite on an uplink
• the satellite then repeats those signals on a
  downlink
• the broadcast nature of the downlink makes it
  attractive for services such as the distribution
  of television programming

42
Satellite Transmission Process
satellite transponder
dish
dish
22,300 miles
uplink station
downlink station
43
Satellite Transmission Applications

• television distribution
• a network provides programming from a central
  location
• direct broadcast satellite (DBS)
• long-distance telephone transmission
• high-usage international trunks
• private business networks

44
Principal Satellite Transmission Bands

• C band 4(downlink) - 6(uplink) GHz
• the first to be designated
• Ku band 12(downlink) -14(uplink) GHz
• rain interference is the major problem
• Ka band 19(downlink) - 29(uplink) GHz
• equipment needed to use the band is still very
  expensive

45
Satellite Advantages

• can reach a large geographical area
• high bandwidth
• cheaper over long distances

46
Satellite Disadvantages

• high initial cost
• susceptible to noise and interference
• propagation delay

47
Common Carriers

• a government-regulated private company
• involved in the sale of infrastructure services
  in transportation and communications
• required to serve all clients indiscriminately
• services and prices from common carriers are
  described in tariffs

48
Leased (or Dedicated) Lines

• permanently or semi-permanently connect between
  two points
• economical in high volume calls between two point
• no delay associated with switching times
• can assure consistently high-quality connections

49
Leased (or Dedicated) Lines

• voice grade channels
• normal telephone lines
• in the range of 300 Hertz to 3300 Hertz
• conditioning or equalizing
• reduces the amount of noise on the line,
  providing lower error rates and increased speed
  for data communications

50
T-1 Carrier

• also referred to as DS-1 signaling
• provides digital full-duplex transmission rates
  of 1.544Mbps
• usually created by multiplexing 24 64-Kbps voice
  or 56-Kbps data lines
• higher speeds are available with T-3 (45Mbps) and
  T-4 services (274Mbps)
• in Europe, E-1 (2.048Mbps) is used instead of T-1

51
Integrated Services Digital Network (ISDN)

• all-digital transmission facility that is
  designed to replace the analog PSTN
• basic ISDN (basic rate access)
• two 64Kbps bearer channels 16Kbps data channel
  (2BD) 144 Kbps
• broadband ISDN (primary rate access)
• twenty-three 64Kbps bearer channels 64 data
  channel (23BD) 1.536 Mbps

52
Past Criticism of ISDN

• Innovations Subscribers Dont Need
• It Still Doesnt Network
• It Still Does Nothing
• Why so much criticism?
• overhyping of services before delivery
• high price of equipment
• delay in implementing infrastructure
• incompatibility between providers' equipment.

53
ISDN Channel Definitions

• B (bearer) channels
• 64 kbps channels that may be used to carry voice,
  data, facsimile, or image
• D (demand) channels
• mainly intended for carrying signaling, billing
  and management information to control ISDN
  services (out-of-band control messages)
• may be either 16 or 64 kbps

54
Two Levels of ISDN Service

• basic rate interface (BRI)
• 2B (64 kbps) D (16 kbps) 144 kbps
• primary rate interface (PRI)
• 23B (64 kbps) D (64 kbps) 1.536 Mbps
• North American standard
• 30B (64 kbps) D (64 kbps) 1.984 Mbps
• European standard