Make a reference orbit'

1
Commissioning
Make a reference orbit. - Beam will be tuned to
be passed to the centers of the references,
QD10, QF7, QD4A, QD2B and BDMP, with special
optics, which is turned on QF7, QD4A and QD2B
only. - The tuning to be centers of QD10 and
QF7 are done by using steering magnets, and
the tuning to be centers of QD4A, QB2B and BDMP
should be done by changing the strength of
the bending magnets for horizontally, by
changing the roll of the bending magnets for
vertically. - The quadrupoles are aligned with
respects to the QBPM center with movers.
2
Optics for initial commissioning
Screen ?
3
All of quadrupoles are turned on !
assuming the quadrupole setting errors of 100mm
4
After the Orbit Correction with Movers.
BBA resolutions are assumed to be 1mm.