Title: BTeV Pixel Silicon Detector
1BTeV Pixel Silicon Detector
- Test beam results 1999-2000
- J.A. Appel, J.N. Butler, G. Cardoso, H. Cheung,
G. Chiodini D.C. Christian, E.E. Gottschalk, B.K.
Hall, J. Hoff, P. A. Kasper, R. Kutschke,
S.W.Kwan, A. Mekkaoui, R. Yarema, and S.
Zimmermann - Fermi National Accelerator Laboratory
- C. Newsom - University of Iowa
- A. Colautti, D. Menasce, and S. Sala -
INFN(Milan) - R. Coluccia and M. Di Corato - Universita di
Milano - M.Artuso and J.C. Wang Syracuse University
- Talk given by G. Chiodini Fermilab
- Genova - Pixel 2000 - June 5-9, 2000
2Overview
- Test beam setup
- 5 pixel plane tested
- SSD telescope and DAQ
- Test beam results
- Pixel Calibration
- Charge collection
- Charge-sharing
- Spatial resolution
- Four plane pixel telescope
- Conclusions
3Setup 5 pixel planes tested
Samples of FPIX0 and FPIX1 readout chips
bump-bonded to ATLAS sensor prototypes
50x400 mm2 cells
30 mm pitch indium bumps
FPIX0 64x12cells 8 bit external ADC
FPIX1 160x18cells 2 bit internal FADC
- ST1-CiS p-stop
- ST2-CiS p-spray
- Bonded active area 3.2x4.4mm2
- Two ST1-Seiko p-stop
- ST2-Seiko p-spray
- Bonded active area 8x6.8mm2
4Setup 5 pixel planes tested
FPIX0 Inner Board
Analog Buffer
8 bit ADC
Pixel detector Light protected
Close-up middle station
5Setup SSD telescope and DAQ
Magnet
DAQ
E T H E R N E T
- I/O Board
- - Controls and Initializes 4 Pixel
readout chips - - GPIB controller HV, thresholds, and
pulser - Automatic pixel calibration
VME COMPUTER
I/O BOARD
STAR
TFIB
6Resultspixel calibration - pulse generator
Qth2500400e- Qnoise10613e-
Qnoise,ADC40096e- Dynamics 1.5MIP
7Results Pixel calibration - X ray sources
Vth0 Threshold knob
8Results Charge collection
1MIP30100e-
Single chip Tile 1 CiS p-stop
1MIP21500e-
Single chip Tile 2 CiS p-spray
9Results charge-sharing
Track inclination
Diffusion
Qth2500e- Vbias-140V
Delta rays emission
10Results charge-sharingBias voltage
ST1 CiS FPIX0 detector
11Results charge-sharingThreshold
ST1 CiS FPIX0 detector
12Results spatial resolutionGaussian width
ST1 CiS FPIX0 detector
13Results spatial resolutionComparison between
detectors
Qth2500e- Qth2200e- Qth3780e-
14Results spatial resolutionBias voltage
ST1 CiS FPIX0 detector
15Results spatial resolutionThreshold
ST1 CiS FPIX0 detector
16Results spatial resolution2D spatial resolution
x
ST1 CiS FPIX0 detector
y
Sigma 4.650.10
Sigma 12.90.26
17Results spatial resolutionNon-Gaussian
resolution function
CS1 and track angle lt 10 degs Square convoluted
with a Gaussian
CSgt1 track angle lt 10 degs and all CS track angle
gt 10 degs Gaussian power law
- Non-Gaussian part
- 15 of events half in the constant
- term and half in the tails
- power law with an exponent ³2
18Four plane pixel telescope
2.2mm thick diamond target
Interaction vertex in the target
Thousands triggered multiple interactions events
Interaction vertex in pixel plane
19Conclusions
- The FPIX-type FE performs well as expected and
needed - GREAT data sample to gain operational experience
with PSDs (3M useful events) - Primary features of results are clear
- Very good resolution at all angles
- 3 ADC bits will be enough for BTeV
- Parameterization of the non-Gaussian tails used
in L1 trigger MC simulations - The BTeV multiplicity is easily handled by 50mm x
400mm pixels