Bloemfontein Electricity Training Centre - PowerPoint PPT Presentation

1 / 8
About This Presentation
Title:

Bloemfontein Electricity Training Centre

Description:

Learner Technician, Apprentice Training and Low Voltage Officials ... Stove, kettle, geyser, etc. Duration 5 Days. Courses in General ... – PowerPoint PPT presentation

Number of Views:198
Avg rating:3.0/5.0
Slides: 9
Provided by: Grobb
Category:

less

Transcript and Presenter's Notes

Title: Bloemfontein Electricity Training Centre


1
Bloemfontein ElectricityTraining Centre
30 Rhodes Avenue Bloemfontein 9301
Tel (051) 4092346/7 Fax (051)
4092400 pvz_at_be.bfncouncil.co.za
Course Information
2
TECHNICAL TRAINING PROVIDER TO
  • ESKOM
  • Learner Technician, Apprentice Training and Low
    Voltage Officials
  • LOCAL GOVERNMENT EDUCATIONAL TRAINING BOARD
  • Learner technician, Apprentice and Trade Worker
    Training
  • ELECTRICAL CONTRACTORS ASSOCIATION (ECA)
  • Apprentice Training, Elconops, Distribution
    Operator, Electrical Supply Installer,
    Single-phase Tester, Appliance repairer

DEPARTMENT OF EDUCATION
3
kWh Energy Meters Courses
4
METER INSPECTOR COURSE
  • Investigate meter installation
  • Know principles of electricity
  • Knowledge of test instruments
  • Know layout from point of supply to point of
    consumption
  • Know faults on Pre-paid meters
  • Know principles of Pre-paid, Rotor Bulk meters
  • Know CT, VT, load balancing Zellweger relays
  • Know how to read the different types of meters
  • Know the layout of a sub-station
  • Be able to replace Ripple relays
  • Be able to install a meter box

Duration 25 days
5
REPLACE kWh ENERGY METER AND OR CIRCUIT
BREAKERUNDER LIVE CONDITIONS
  • Safety precautions (actions conditions)
  • Protective clothing
  • Removal procedure
  • Replacing procedure
  • Knowledge test
  • Performance test

Duration 1 day
6
TAKE NOTE kWh-ENERGY METER READINGS COURSE
  • Introduction
  • Principles of meter operation
  • Reading a Watt-hour meter
  • Read a kWh dial meter
  • Knowledge self check
  • Knowledge test
  • Performance test

Duration 2 days
7
Courses in General
  • TECHNICAL COLLEGE N1, N2, N3
  • Corresponding to the applicable syllabus
  • Duration 10 Days
  • WORKSHOP PRACTICE
  • Use of Basic Hand Tools
  • Duration 5 Days
  • INSTALLATION TEST
  • To comply with SABS 0142 Standard
  • Duration 5 Days
  • SIMPLE CIRCUIT DESIGN
  • Designing of schematic diagrams wiring of
    circuits
  • Duration 5 Days

WELDING Arc and Gas Duration 10 Days UNDERGROUND
CABLE WORK (11KV) Terminations joining
cables Duration 5 Days HOME APPLIANCES Stove,
kettle, geyser, etc. Duration 5 Days
8
Evaluations
  • Pre-appointed evaluations (Technical Vienna
    Dover)
  • Article 28 (Trade Test Candidates)
  • Determining existing Skills Levels against above
    mentioned course criteria
  • Unit standard Crediting
Write a Comment
User Comments (0)
About PowerShow.com