Title: Bulk and Interface Properties of Multilayer Systems
1Bulk and Interface Properties of Multilayer
Systems
Edson Passamani Caetano
Universidade Federal do EspÃrito Santo Physics
Departament/EspÃrito Santo/Vitória/Brazil
2Outline
- Introduction
- Thin films/Multilayers
- Relevant discorverings in multilayers
- Studied problems
- Non-collinear magnetic coupling
- Exchange bias effect
- Sample preparations
- Fe/Mn/Fe trilayers (MBE)
- FeNi/FeMn/FeNi trilayers (Sputtering)
- Mössbauer results
- Fe/Mn/Fe trilayers
- FeNi/FeMn/FeNi trilayers
General Remarks
3Thin films/Multilayers
System with one of its dimension in nanometer
scale
If the effusion cells can be independently
controlled
4Relevant Discoverings in Multilayers
From especial issue of J3M (1999)
1400
5Studied Systems
- Influence of interfacial roughness/alloy on the
- (i) Non-collinear coupling of Fe/Mn/Fe trilayers
- (ii) EB effect in FeNi/FeMn/FeNi trilayers
6(No Transcript)
7(No Transcript)
8Sample preparation MBE (KULeuven) Vacuum during
the deposition 6x10-11 mbar
9Experimental Characterization Methods
1057Fe Mössbauer Spectroscopy
11MgO/Fe(5nm)/Mn(0.5nm)/Fe(5nm) prepared at
different Ts
12Magnetometry Field Applied // to the Film Plane
13MgO/Ag(100nm) substrate (TS 50o C)
14MgO/Ag(100nm)/Fe(10nm)/Mn(1nm)/Fe(5nm)
TS50oC
38 of bulk a-Fe
? 47o
MgO/Fe(5nm)/Mn(1nm)/Fe(5nm) TS150oC
17 of bulk a-Fe
? 72o
15EB effect
2nd problem to be shown
16(No Transcript)
17Interfacial effect/EB system
Heb values increase with roughness Uyama et
al., J. Magn. Soc. Jpn. 21 (1997) 911
Heb values reduce with roughness Nogués et
al., PRB 59 (1999) 6984
18Samples A2, A5 and A10 PW 2, 5 and 10 mTorr
19Si/WTi/Py(30)/FeMn(15)/Py(10)/WTi PW 2, 5 and 10
mTorr (A2, A5 and A10)
X-ray Reflectivity results
Py
20Samples A2 and A10 PW 2 and 10 mTorr
21Si/WTi/Py(30)/FeMn(15)/Py(10)/WTi PW 2, 5 and 10
mTorr (A2, A5 and A10)
Magnetometry
Heb values decrease while Hc values increase
with roughness
22Si/WTi(10)/Py(30)/FeMn(15)/Py(10)/WTi(10) PW 2,
5 and 10 mTorr (A2, A5 and A10)
23Hyperfine parameters
chemical roughness (alloy) exceeds the
interfacial roughness
24Proposal model Transversal view
25General Remarks
- Bulk magnetic properties of multilayer systems
are intrinsically associated with their interface
properties.
- In trilayer systems, the upper interface is
usually rougher than the lower one. In addition,
the chemical roughness (alloy) is in general
larger than the interfacial/surface roughness.
- The magnetic coupling angles in Fe/Mn/Fe
trilayers are related to their interfacial
roughnesses and therefore it is not due to the
quasi-helicoidal AFM state of Mn layer in the
trilayer.
- The Py/FeMn/Py trilayers Heb ? 1/roughness and
HC ? roughness. Theirs values are intrinsically
related to the fraction of each Mössbauer
component.
26- Prof. Dr. André Vantomme (KULeuven-Belgium)
- Prof. Dr. Elisa Baggio-Saitovitch (CBPF/Brazil)
- Prof. Dr. Fernando Pelegrini (IFG/Brazil)
- Dr. Bart de Groot (KULeuven-Belgium)
- Dr. Bart Croonenborghs (KULeuven-Belgium)
- Dr. Valberto Pedruzi Nascimento (CBPF/Brazil)
- MSc. Breno Segatto (UFES/Brazil)
- MSc. Francisco Almeida (KULeuven-Belgium)
Thank you!
Sponsors
27Magnetic structure model