Overview of Mobile Communication Systems - PowerPoint PPT Presentation

1 / 26
About This Presentation
Title:

Overview of Mobile Communication Systems

Description:

Computer Science Professional Courses. Overview of Mobile Communication Systems ... Rake receivers popular. Rejection of Interference high ... – PowerPoint PPT presentation

Number of Views:723
Avg rating:3.0/5.0
Slides: 27
Provided by: profjohnso
Category:

less

Transcript and Presenter's Notes

Title: Overview of Mobile Communication Systems


1
Overview of Mobile Communication Systems
  • Transferring knowledge to future leaders

Presented by Professor Johnson I Agbinya
jagbinya_at_uwc.ac.za
2
History of Cellular Networks
  • First Ever Mobile Network
  • Deployed by Bell Mobile System
  • In New York (1970)
  • Used one High Powered Transmitter (limited in
    range, power and scope)
  • Good coverage
  • Limited capacity
  • Limited mobility
  • Inefficient use of bandwidth

3
Single Cell Network
4
First (Generation) Cellular Network
  • By Nippon Telephone Telegraph (NTT)
  • In Japan (NTT System)
  • In 1979 (Analog system)
  • Operated in the 800 MHz range
  • Used 25 kHz channel spacing
  • Used 5 kHz guard band

5
First Generation Cellular Networks (1)
  • Operate Mostly in the 800 MHz range
  • First 1G cellular networks Early 1980s
  • Analog systems
  • Nordic Mobile Telephone (NMT)
  • Advanced Mobile Phone System (AMPS)
  • Total Access Communication System (TACS)

6
First Generation Cellular Networks (2)Nordic
Mobile Telephone (NMT)
  • Operated in the 450 MHz range
  • In the Scandinavia (1981)
  • Analog system
  • Architecture
  • Duplex system (10 MHz separation in links)
  • 180 channels (1.2 kbps, very low rate)
  • Frequency modulation ( 5 kHz deviation )
  • Digital control signal (FSK)

7
First Generation Cellular Networks (3)Advanced
Mobile Phone System (AMPS)
  • Operated in the 800 to 900 MHz band
  • USA (1983) - after NMT introduction
  • Analog system
  • 40 MHz spectrum allocation (10 MHz link
    separation)
  • 666 channels (10 kbps rate)
  • 20 MHz per operator (333 channels)
  • Latter increased to 416 channels (25 MHz /
    operator)
  • 30 kHz per channel
  • 21 control channels (FSK, 8 kHz deviation)

8
First Generation Cellular Networks
(3a)Limitations of AMPS
  • Low calling capacity
  • Limited Spectrum
  • No room for spectrum growth
  • Poor data communication
  • Minimal privacy (low security of user
    information)
  • Inadequate fraud protection (subject to cloning)

9
First Generation Cellular Networks (4)Total
Access Communication System (TACS)
  • Operated in the 900 MHz band
  • UK (1985) - after introduction of AMPS
  • Analog system
  • 45 MHz (duplex) uplink and downlink separation
  • 1000 channels (8 kbps rate)
  • 25 kHz per channel
  • Frequency modulation ( 9.5 kHz deviation )
  • digital control channels (FSK, 6.4 kHz deviation)

10
Second Generation Cellular Networks
  • Pushed by demand for
  • more subscribers
  • limited frequency resource
  • saturated networks
  • need for better system security
  • Digital Systems

11
2G Cellular Networks (1)
  • 2G Access technologies
  • GSM (Global System for Mobile communication)
  • Combination of FDMA and TDMA
  • Europe, Africa, Asia/Pacific regions
  • CDMA (Code Division Multiple Access)
  • North America, parts of Asia/Pacific
  • TDMA (Time Division Multiple Access)
  • South America (mostly)

12
2G Cellular Networks (1)
  • CDMA (orthogonal codes given to users)
  • FDMA (Spectrum divided as f W / N)
  • TDMA (Time duration T1 Tf / N)
  • Channels are non-overlapping

13
2G Cellular Networks (2)
  • CDMA (IS-95 series networks)
  • Users are identified by orthogonal codes
  • Uses spread spectrum digital modulation
    techniques (1.25 MHz bandwidth, 1.2288 Mchip)
  • Rake receivers popular
  • Rejection of Interference high
  • Suffers from cell breathing (contraction and
    expansion of cell range as a function of the
    number of users on network)

14
2G Cellular Networks (3)
  • TDMA (GSM and TDMA networks)
  • Users share frequencies but transmit at different
    time slots
  • Most popular air interface
  • Used mostly in Europe and Africa
  • Limited in data rates
  • cell range dependent on transmitted power and
    environmental effects

15
2G Cellular Networks (4)
  • Examples of TDMA networks
  • IS-54 (dual mode TDMA/AMPS)
  • IS-54B
  • electronic serial number
  • better authentication
  • better caller ID
  • IS-54C
  • Evolution path is through EDGE to 3G

16
2G Cellular Networks (5)
  • Characteristics of IS-54 and EIA-553

17
2G Cellular Networks (6)
  • TDMA Characteristics
  • IS54 standard specifies traffic on digital voice
    channels
  • initial implementation triples the calling
    capacity of AMPS systems
  • capacity improvements of 6 to 15 times that of
    AMPS are possible
  • many blocks of spectrum in 800 MHz and 1900 MHz
    are used
  • all transmissions are digital
  • TDMA/FDMA supported 7. 3 callers per channel (6
    callers on half rate later), providing 3 times
    the AMPS capacity

18
2G Cellular Networks (7)
  • Characteristics of IS-54 networks
  • 30 kHz channel spacing
  • DQPSK encoding at 24.3 kbaud rate
  • 6 time slots
  • 48.6 kbps channel capacity (48.6/6 kbps per TS)
  • vector sum excited linear prediction (VSELP)
    vocoder at 7.95 kbps
  • dual mode handsets to accommodate AMPS
  • 3 times capacity of AMPS

19
2G Cellular Networks (8)
  • Characteristics of PDC networks
  • Operated in Japan (1991)
  • 25 kHz channel spacing
  • 80 MHz link spacing (810-826, 956-980 MHz
    1429-1453, 1477-1501 MHz)
  • Used space diversity to reduce carrier
    interference
  • Reuse factor of 4
  • DQPSK modulation at 42 kbps signaling rate
  • mobile assisted handoff and VSELP at 6.7 kbps

20
2G Cellular Networks (9)
  • Characteristics of PCS 1900 networks
  • North American implementation of DCS 1800 (GSM)
  • 80 MHz link separation
  • Uplink and downlink are paired mirror images of
    each other

21
Evolution of 2G Networks to 3G
  • Politics of GSM and CDMA competition means
    different designation of cdma2000 1x EV (is it a
    2.5G or 3G network?)

22
Evolution of CDMA Networks to 3G
  • IS-95 to cdma2000 1xRTT (144 kbps)
  • cdma2000 1x EV-DO (DO for data only)
  • Voice carried on IS-95 network
  • 1.25 MHz channels
  • Reuses IS-95 channels (saves costs)
  • Peak rate to be 2.4 Mbps in future

23
Evolution of GSM Networks to 3G
  • GSM to GPRS (171.2 kbps)
  • Voice on GSM and data on GPRS (2.5G)
  • GPRS uses packet switching
  • GPRS to EDGE
  • EDGE is considered a 3G network
  • packet switching capacity of 384 kbps
  • will support both voice and data
  • uses more time slots to increase capacity

24
3G Networks
  • All employ wideband CDMA (W-CDMA)
  • UMTS (European ETSI/3GPP standard)
  • CDMA2000 (American standard)
  • Uses packet switching (UTRA FDD and TDD)
  • Peak rate to be 2.4 Mbps
  • First networks deployed in 2001
  • BT (UMTS in Isles of Man)
  • NTT DoCoMo (Japan) - FOMA

25
3G Networks - UTRA FDD and TDD
  • Frequency Division Duplex
  • distinct frequency bands for each user
  • forward band - traffic from base station to
    mobile
  • reverse band - traffic from mobile to base
    station
  • Time Division Duplex
  • communication on a single frequency
  • distinct time slots for forward and reverse links
  • small time differences between the slots for one
    person to make transmission look simultaneous

26
Questions and Answers
  • Feedback survey
  • Tell me what you think about this
    lecture
  • jagbinya_at_uwc.ac.za
  • Next lecture February .
Write a Comment
User Comments (0)
About PowerShow.com